Resources
Consider the ionization threshold limit of a ground-state hydrogen atom (). (a) Calculate the minimum threshold frequency and maximum photon wavelength (convergence limit) required to fully ionize the hydrogen atom (), using . (b) If an incoming photon with wavelength strikes a ground-state hydrogen atom, verify whether ionization occurs, and if so, calculate the resulting kinetic energy of the ejected free photoelectron in Joules.
Answer and steps
Final answer
(a) , (ultraviolet); (b) Ionization occurs because ; .
Steps
Part (a): Ionization Energy and Threshold Values
Step 1: Calculate the energy required to ionize a ground-state hydrogen atom
Ionization corresponds to exciting an electron from the ground state () completely away from the nucleus to the continuum limit ():
The minimum energy required for ionization () is:
Step 2: Determine the threshold frequency ()
Using Planck's equation, , where Planck's constant is :
Step 3: Determine the maximum wavelength ()
Using the wave relationship , with the speed of light :
A photon with a wavelength longer than will not possess sufficient energy to ionize ground-state hydrogen. This limit lies in the far ultraviolet region and represents the convergence limit of the Lyman series.
Part (b): Photoelectric Ionization and Kinetic Energy
Step 1: Verify whether ionization occurs
For an incident photon of wavelength :
- Because photon energy is inversely proportional to wavelength (), a shorter wavelength corresponds to higher energy.
- Since , the energy of the incident photon exceeds the ionization energy threshold, so ionization does occur.
Step 2: Calculate the photon energy
Step 3: Calculate the kinetic energy () of the ejected photoelectron
By conservation of energy, the excess energy of the photon beyond the threshold ionization energy is converted into kinetic energy of the ejected electron:
Common Pitfall: Remember that ionization occurs when , not . Because energy increases as wavelength decreases, a shorter wavelength delivers more energy than the minimum threshold.
Typical errors
01 The student misremembers the relationship between energy and wavelength, incorrectly believing that ionization requires a wavelength greater than the threshold wavelength rather than less than it.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
"Since the wavelength is below the threshold wavelength, the photon does not have enough energy, so ionization does not occur."
CorrectBecause , energy is inversely proportional to wavelength. Since , , so ionization occurs with .
Photon energy is inversely proportional to wavelength (). A shorter wavelength corresponds to a higher photon energy, which means an incoming wavelength below provides more than enough energy to ionize the atom.
WHAT YOU DID WELL
Compliments from Your TeacherYou calculated the exact energy difference required to ionize ground-state hydrogen.
You used Planck's equation and the speed-of-light relationship correctly to find and .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou noticed that , but you treated shorter wavelength as meaning less energy instead of more energy.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the threshold criteria for frequency versus wavelength. While frequency is directly proportional to energy (, requiring ), wavelength is inversely proportional to energy (, requiring ).
REASONING PATH
Your ACEpath teacher’s suggested approach- Energy vs. Wavelength Threshold Rule
, so smaller delivers greater energy.
Always write down the condition for photoelectric ejection or ionization, rather than .
- Photoelectron Kinetic Energy Balance
By conservation of energy, .
Whenever ionization is verified, compute and subtract the threshold binding energy to get .
CORRECTED PATH
ACEpath Teacher's DemonstrationCompare the incident wavelength to the maximum threshold: since , the photon energy exceeds the ionization threshold, meaning ionization occurs.
Calculate the incident photon energy: .
Determine the kinetic energy of the ejected electron: .
Ionization occurs; .
02 The student forgets to convert the incoming wavelength from nanometers to meters when calculating photon energy, leading to an incorrect photon energy by a factor of 10⁹.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You substituted directly into without converting nanometers to meters (). Because is in , the wavelength must be expressed in meters to obtain Joules.
- Step 4
- Step 5Correct
Your formula for kinetic energy is conceptually correct, but substituting your unscaled value of yielded an incorrect and physically impossible negative kinetic energy.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly computed the threshold ionization energy, threshold frequency, and convergence wavelength for ground-state hydrogen.
You applied the correct inverse relationship between wavelength and photon energy to determine that ionization does occur.
You set up the correct energy conservation formula for the ejected photoelectron.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou entered instead of in the denominator of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou neglected SI unit matching when combining constants ( in ) with problem data given in prefix units (), and you did not flag the resulting negative kinetic energy as a red flag for a unit error.
REASONING PATH
Your ACEpath teacher’s suggested approach- Unit Consistency in $E = \frac{hc}{\lambda}$
Speed of light is expressed in meters per second (), so wavelength must always be converted to meters () before dividing: .
Whenever a wavelength is given in , immediately write it as before entering it into your calculator.
- Sanity Check on Kinetic Energy
Kinetic energy of a real ejected particle must always be non-negative ().
If you ever compute a negative kinetic energy when you have already confirmed that ionization occurs (), pause and check whether you dropped a factor in the photon energy.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert the incident wavelength to meters: .
Calculate the correct photon energy: .
Apply conservation of energy to find the photoelectron's kinetic energy: .
(a) , ; (b) Ionization occurs; .
03 The student confuses the energy difference ΔE with the ground-state energy sign and keeps it negative, adding the ionization energy instead of subtracting it when calculating kinetic energy.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You added the ionization energy rather than subtracting it. By conservation of energy, the incoming photon's energy is split into overcoming the binding energy (the work function/ionization energy) and the remaining kinetic energy of the ejected electron: , so .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the threshold frequency and maximum threshold wavelength for hydrogen ionization.
You correctly determined the incident photon's energy from its wavelength.
You accurately concluded that ionization occurs because the incident wavelength is shorter than the threshold wavelength.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeNo, this is a conceptual confusion in formulating the energy balance for the photoelectric effect.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou set up the kinetic energy equation as rather than . Remember that an incoming photon delivers total energy ; part of that energy is consumed to overcome the electron binding energy , and only the leftover excess becomes the electron's kinetic energy . Kinetic energy can never exceed the total energy supplied by the incident photon.
REASONING PATH
Your ACEpath teacher’s suggested approach- Conservation of Energy in Photoionization
Always check whether your resulting kinetic energy is less than the incident photon energy; an ejected electron cannot carry more energy than the photon that liberated it.
CORRECTED PATH
ACEpath Teacher's DemonstrationState the energy conservation equation: .
Rearrange for kinetic energy: .
Substitute the values: (or using standard unrounded constants).
(a) , ; (b) Ionization occurs; .
Lock it in
How are photon energy () and wavelength () related mathematically, and what does this mean for threshold conditions?
(inverse relationship). Higher energy corresponds to shorter wavelengths, so ionization or photoelectric emission requires .
Similar question
A hydrogen atom has an electron excited to (). Determine the maximum wavelength of light that can ionize this excited atom from to .
Answer
. Key steps: ; .
Potassium metal has a work function of (). Light with shines on potassium. Does photoelectron emission occur? If yes, calculate the maximum kinetic energy in Joules.
Answer
Yes, emission occurs; . Key steps: . Since , emission occurs; .
An incoming photon ejects an electron from ground-state hydrogen () with a kinetic energy of . Find the wavelength of the incident photon in nanometers.
Answer
. Key steps: ; .