Resources
A standard laboratory protocol considers a synthetic crystallization of adipic acid (, molar mass ) via the oxidation of cyclohexene (, molar mass ) commercially viable only if the process meets a critical threshold percent yield of at least . An organic chemist treats of cyclohexene with excess potassium permanganate in a stoichiometric ratio yielding adipic acid. (a) Determine the exact minimum mass (in grams) of purified adipic acid that must be recovered to meet this minimum viability threshold. (b) If the chemist collects of product, determine the percent yield and evaluate whether the threshold was achieved.
Answer and steps
Final answer
(a) Critical threshold mass = ; (b) Percent yield = , which falls below the threshold (threshold not achieved)
Steps
Calculate the theoretical yield of adipic acid
- Find the moles of the limiting reactant (cyclohexene): Given that potassium permanganate is present in excess, cyclohexene () is the limiting reactant.
- Determine the moles of product produced: The stoichiometric ratio between cyclohexene and adipic acid () is :
- Calculate the theoretical mass (yield) of adipic acid:
(a) Determine the minimum mass required to meet the viability threshold
The process is commercially viable if the yield is at least of the theoretical yield:
Thus, at least of adipic acid must be recovered.
(b) Calculate the percent yield and evaluate against the threshold
- Calculate the percent yield: Given an actual yield of :
- Evaluate viability: Compare the obtained percent yield to the threshold: The collected amount corresponds to a percent yield of , which falls below the required target; therefore, the commercial viability threshold was not achieved.
Typical errors
01 The student calculates the threshold requirement directly from the starting reactant mass rather than from the theoretical yield of product.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You multiplied the mass of the starting reactant (cyclohexene, ) by . The viability threshold specifies a percent yield of the product (adipic acid), so the percentage must be applied to the theoretical yield of adipic acid (), not the reactant mass.
- Step 2
- Step 3
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the theoretical yield of adipic acid using the reactant mass, molar masses, and stoichiometric ratio.
You correctly computed the percent yield from the collected mass of product.
You correctly evaluated that the experimental yield fell below the critical threshold.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeWHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the starting mass of cyclohexene as the base quantity for the threshold. Percent yield is strictly a measure of product recovery relative to the maximum theoretical product that could form. Because cyclohexene and adipic acid have different molar masses ( vs. ), mass is not conserved by grams, so threshold product mass must always be calculated from the theoretical yield of the product.
REASONING PATH
Your ACEpath teacher’s suggested approach- Yield Relates to Product Quantities
. A target threshold mass is always a fraction of the theoretical product yield.
Find the theoretical yield of the product first, then multiply that theoretical mass by the required threshold percentage.
- Molar Mass Changes Across Reactions
Even with a stoichiometric mole ratio, of reactant does not produce of product when their molar masses differ.
Never apply product yield percentages directly to reactant masses.
CORRECTED PATH
ACEpath Teacher's DemonstrationFirst determine the theoretical yield of adipic acid from the limiting reactant: .
Then apply the viability threshold () to this theoretical product mass: .
(a) Critical threshold mass = ; (b) Percent yield = , threshold not achieved
02 The student inverts the percent yield formula by dividing the theoretical yield by the actual yield.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You inverted the percent yield ratio by dividing theoretical yield by actual yield. Percent yield represents what you actually obtained out of the maximum possible, so actual yield must be in the numerator.
- Step 4
, so the threshold was achieved.
Correct, so the commercial viability threshold was not achieved.
Because your calculated percent yield was inverted, your comparison and conclusion were reversed.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the molar quantity of cyclohexene from its mass and molar mass.
You correctly applied the stoichiometric ratio to find the theoretical yield of adipic acid.
You correctly solved part (a) by calculating of the theoretical yield.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set up the ratio as theoretical yield over actual yield rather than actual yield over theoretical yield.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the numerator and denominator in the percent yield formula. The theoretical yield represents the total possible amount ( baseline), so it must always serve as the denominator (whole), while the actual experimental yield is the numerator (part). In an ordinary reaction without impurities, the percent yield cannot exceed .
REASONING PATH
Your ACEpath teacher’s suggested approach- Part-over-Whole Sanity Check
Before finalizing, check whether your result exceeds . If a pure product yields more than , you likely inverted the fraction.
CORRECTED PATH
ACEpath Teacher's DemonstrationCompare with threshold:
(a) Critical threshold mass = ; (b) Percent yield = , which falls below the threshold (threshold not achieved)
03 The student ignores molar masses and stoichiometry, assuming a 1:1 mass conservation between cyclohexene and adipic acid.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
A stoichiometric ratio applies to moles, not grams. Because cyclohexene and adipic acid have different molar masses ( vs. ), you must convert the starting mass of cyclohexene to moles () before multiplying by the molar mass of adipic acid to find the theoretical yield ().
- Step 2Correct
You applied the correct threshold percentage (), but because your theoretical yield was incorrect from Step 1, this value was affected.
- Step 3Correct
You correctly used the definition of percent yield (actual yield divided by theoretical yield), but dividing by instead of produced an impossible yield exceeding .
- Step 4
, so the threshold was achieved.
Correct, so the threshold was not achieved.
Your comparison logic was correct, but comparing your affected percent yield () led to the opposite final conclusion.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified and applied the formula for percent yield as actual yield divided by theoretical yield times .
You correctly used the factor to define the minimum threshold mass.
You clearly showed every step of your calculation.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou assumed that a 1:1 reaction stoichiometry implies that the mass of reactant directly equals the mass of product, skipping the conversion from mass to moles and back to mass using respective molar masses.
REASONING PATH
Your ACEpath teacher’s suggested approach- Mole Bridge Rule
Stoichiometric coefficients relate amounts in moles, never amounts in grams.
Always convert reactant mass to moles () before using stoichiometric mole ratios to calculate product moles and mass.
- Sanity Check for Percent Yield
In standard stoichiometry problems without impurities or excess mass, percent yield cannot exceed .
If your calculated percent yield exceeds , immediately re-check your theoretical yield calculation.
CORRECTED PATH
ACEpath Teacher's DemonstrationFind moles of cyclohexene: .
Convert to theoretical mass of adipic acid using its molar mass: (or ).
Calculate minimum viability mass: .
Calculate actual percent yield: .
Compare with threshold: , meaning the threshold was not achieved.
(a) Critical threshold mass = ; (b) Percent yield = , which falls below the threshold (threshold not achieved)
Lock it in
What is the defining formula for the percent yield of a chemical reaction?
. Both quantities must represent the same product.
Similar question
A synthesis of aspirin () has a theoretical yield of . A quality standard requires at least an yield. What minimum mass of purified aspirin must be recovered to meet this requirement?
Answer
. Key step: .
A student decomposes of calcium carbonate (, molar mass ) according to to produce calcium oxide (, molar mass ). If a process requires an yield to be viable, determine the minimum mass of that must be collected.
Answer
. Key steps: Moles of . In a ratio, theoretical yield of . Minimum threshold mass .
In a reaction, of (molar mass ) reacts with excess hydrogen to form ammonia according to (molar mass of ). (a) Calculate the theoretical yield of in grams. (b) If the reaction achieves a yield, determine the actual mass of ammonia produced and evaluate whether it meets a target benchmark of .
Answer
(a) ; (b) , benchmark achieved. Key steps: produces , so theoretical yield . Actual yield . Since , the benchmark was achieved.