Resources
Consider the decomposition equilibrium of gaseous water at an extreme elevated temperature of : , where the equilibrium constant is extremely small, . If of pure is placed into a rigid container and heated to , determine the asymptotic limiting equilibrium concentration of diatomic oxygen, .
Answer and steps
Final answer
Steps
Determine initial concentrations and set up the ICE table
The reaction takes place in a rigid vessel, so the initial molar concentration of water vapor is:
Initially, no products are present ( and ).
Let represent the increase in the concentration of at equilibrium. According to the stoichiometric coefficients of the balanced equation:
- Initial concentration ():
- Change ():
- :
- :
- :
- Equilibrium concentration ():
Write the equilibrium expression and apply the small- approximation
The equilibrium constant expression is:
Substitute the equilibrium terms into the expression:
Because is extremely small (), the degree of decomposition is negligible. We can make the approximation:
Solve for
Substitute the approximation into the equation:
Isolate :
Take the cube root of both sides:
Verify the approximation and conclude
Check the validity of neglecting relative to :
Since , the approximation is completely valid.
Therefore, the equilibrium concentration of diatomic oxygen is:
Typical errors
01 The student forgets to square the 2 in the numerator when expressing [H2]² as 2x² instead of (2x)² = 4x³.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
When substituting into , the entire quantity must be squared: . Writing omitted squaring the coefficient .
- Step 4Correct
Your algebraic solving technique was correct, but the numerical result was affected by the missing factor of in the numerator.
- Step 5Correct
Because was calculated from instead of , the resulting equilibrium concentration of oxygen is incorrect.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly computed the initial molarity of water vapor from moles and volume.
You correctly expressed the equilibrium concentrations in terms of using the stoichiometric ratios.
You appropriately recognized that is small and applied the small- approximation.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou substituted as rather than .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisForgetting to enclose multi-factor algebraic quantities in parentheses before raising them to an exponent causes the exponent to apply only to the variable rather than both the coefficient and the variable.
REASONING PATH
Your ACEpath teacher’s suggested approach- Parentheses rule for substitution
Whenever an equilibrium term has a stoichiometric coefficient (such as ), substitute it as , where both and are raised to the power .
Always write explicit parentheses around the substituted quantity before evaluating the power.
CORRECTED PATH
ACEpath Teacher's DemonstrationSubstitute with parentheses: .
Equate to : .
Divide by : .
Take the cube root: .
02 The student ignores the stoichiometric coefficient of 2 for H2, setting [H2] = x instead of 2x in the equilibrium expression.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You correctly accounted for the stoichiometry when writing for , but you set . In the balanced equation , the stoichiometric coefficient of is , so its equilibrium concentration must be when .
- Step 2Correct
You stated the correct equilibrium law and applied the small- approximation appropriately, but substituting instead of omitted the factor of in the numerator.
- Step 3Correct
You solved the cubic equation and extracted the cube root accurately based on your algebraic setup, but the missing coefficient propagated to an incorrect final concentration.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly computed the initial concentration of water vapor as .
You wrote the correct equilibrium constant expression with the proper exponents.
You recognized that is tiny and correctly simplified .
You carried out the algebraic cube root calculation with correct arithmetic.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou assigned instead of in the equilibrium line, even though you correctly recognized the factor of when writing .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConflating the stoichiometric coefficient's role in the ICE table with its role as an exponent in the equilibrium expression. A coefficient of requires both multiplying the change by (so ) and raising that term to the -th power in (yielding ).
REASONING PATH
Your ACEpath teacher’s suggested approach- Double-Check the Change Line
Every species in the 'Change' row of an ICE table must have a factor equal to its balanced stoichiometric coefficient: , .
Before substituting into , verify that the ratio of changes matches the balanced ratio .
- The 'Multiply Inside, Exponent Outside' Rule
When substituting an equilibrium concentration term into , write , which expands to .
Write explicitly in your scratch work so the numerical prefactor is not lost.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the correct equilibrium concentrations from the ICE table: , , and .
Substitute these terms into the expression: .
Isolate : .
Take the cube root: .
03 The student omits the exponent when writing the equilibrium constant expression, treating [H2O]² as [H2O] in the denominator.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
In the balanced equation , the coefficient of is . Therefore, must be raised to the power of in the denominator of the expression.
- Step 3Correct
Your algebra was carried out accurately based on your equation, but the result is affected by the missing squared exponent from the previous step.
- Step 4Correct
Because was calculated from an incomplete equilibrium expression, the final oxygen concentration is incorrect.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the initial concentration of from the given moles and container volume.
You accurately defined the changes in concentration using the stoichiometric ratios of the balanced reaction.
You recognized that is extremely small and reasonably applied the negligible dissociation approximation .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote instead of in the denominator of the equilibrium expression.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou forgot to raise the reactant concentration to its stoichiometric power when setting up the law of mass action expression.
REASONING PATH
Your ACEpath teacher’s suggested approach- Stoichiometric Coefficients as Exponents
For a general reversible reaction , the equilibrium constant expression is .
Always double-check that every reactant and product concentration in the formula is raised to the power equal to its stoichiometric coefficient in the balanced equation.
CORRECTED PATH
ACEpath Teacher's DemonstrationInclude the stoichiometric power of in the denominator: .
Simplify the algebraic fraction: .
Set equal to : .
Take the cube root: .
Lock it in
When substituting an equilibrium concentration into an equilibrium expression containing , what is the correct expanded algebraic expression?
. Both the coefficient and the variable must be squared.
Similar question
For the gaseous equilibrium , a container initially holds of . If is the equilibrium concentration of , write the numerator of in terms of and simplify it completely.
Answer
. Since and , the numerator is .
For the reaction with , pure is placed in a vessel at an initial concentration of . Using the small- approximation where , calculate the equilibrium concentration .
Answer
. Setting up . Then , giving .
Consider the decomposition with . If initially and no products are present, let . Set up the equilibrium expression under the small- approximation and solve for at equilibrium.
Answer
. At equilibrium, , , and . Thus . Hence , yielding . Therefore, .