Resources
In an analytical chemistry laboratory, a aliquot of an unknown monoprotic weak acid, , is titrated with a standardized solution of sodium hydroxide (, a strong base). The equivalence point is reached after the addition of exactly of the titrant, and the measured at the exact half-equivalence point ( of added) is . Classify as a weak acid, determine the initial molar concentration of in the original sample, and determine the acid dissociation constant () of the unknown weak acid.
Answer and steps
Final answer
is a weak acid; initial concentration ;
Steps
Classification of the Acid
An acid is classified as weak if it only partially dissociates into its ions in aqueous solution:
Unlike a strong acid (which dissociates completely and does not establish a dynamic equilibrium), establishes a buffer region during titration where both the unreacted weak acid () and its conjugate base () coexist. Furthermore, its dissociation constant confirms that is a weak acid.
Determine the Initial Concentration of
At the equivalence point, the moles of added hydroxide ions () are stoichiometrically equal to the initial moles of the monoprotic acid ():
Calculate the moles of titrant () consumed at the equivalence point:
Because the stoichiometric ratio is :
Now, divide by the initial sample volume () to find the original molar concentration:
Determine the Acid Dissociation Constant ()
At the exact half-equivalence point ( of added), exactly half of the initial molecules have been neutralized to form the conjugate base :
Using the Henderson-Hasselbalch equation for the buffer region:
Since , the logarithmic term becomes :
Calculate from :
Common Pitfall: Do not confuse the half-equivalence point with the equivalence point. At the half-equivalence point, because the acid and its conjugate base are in equal concentrations. At the equivalence point, all has been converted to , resulting in a basic due to the hydrolysis of .
Typical errors
01 The student uses the half-equivalence volume instead of the equivalence point volume to calculate the initial concentration of HA.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
is a weak acid because it dissociates only partially in water.
- Step 2Correct
You used the titrant volume at the half-equivalence point () rather than at the equivalence point (). Complete stoichiometric neutralization of all original requires the full equivalence volume.
- Step 3
At half-equivalence,
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly classified based on partial dissociation.
You correctly applied the relationship at the half-equivalence point to find .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused the physical meaning of the half-equivalence point with the equivalence point. Complete stoichiometric neutralization occurs only at the equivalence point, where moles of added base equal the initial moles of acid. The half-equivalence point neutralizes only half of the original acid molecules.
REASONING PATH
Your ACEpath teacher’s suggested approach- Identifying Total Moles of Analyte
The total initial moles of weak acid satisfy .
Always use the full equivalence volume () when calculating initial concentration or total moles of analyte.
- Role of the Half-Equivalence Point
At , exactly half of has converted to , meaning and .
Use the half-equivalence point strictly to find and buffer properties, not for total stoichiometric titration stoichiometry.
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate the moles of required to completely neutralize at the equivalence point: .
Equate moles of monoprotic acid to moles of strong base at equivalence: .
Divide by the original sample volume: .
is a weak acid; initial concentration ;
02 The student misinterprets the pH at the half-equivalence point as directly giving the hydronium ion concentration [H+] from which they attempt to calculate Ka using the initial acid concentration, ignoring the Henderson-Hasselbalch relationship.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
is a weak acid because it incompletely ionizes in water.
- Step 2
- Step 3Correct
The formula applies only to a pure, un-titrated weak acid solution before any base is added. At the half-equivalence point, exactly half of the weak acid has been converted to its conjugate base, making , which means and .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that is a weak acid based on its incomplete ionization.
You properly applied the equivalence-point stoichiometry to compute the initial concentration of the acid.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeNone.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou applied the initial equilibrium approximation for an isolated weak acid () to a buffer system at the half-equivalence point, overlooking that leads directly to .
REASONING PATH
Your ACEpath teacher’s suggested approach- Half-Equivalence Condition
At the half-equivalence point of a weak acid–strong base titration, .
Substitute equal concentrations into the Henderson-Hasselbalch equation to obtain .
- Finding $K_a$ from Half-Equivalence $\text{pH}$
.
Directly convert the measured half-equivalence into using without squaring or dividing by the initial concentration.
CORRECTED PATH
ACEpath Teacher's DemonstrationAt the half-equivalence point, exactly half of has reacted, so .
From the Henderson-Hasselbalch equation, .
Therefore, , which gives .
is a weak acid; ;
03 The student miscalculates Ka from pKa by using the natural exponential function e^(-pKa) instead of 10^(-pKa).
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
is a weak acid because it does not completely dissociate in aqueous solution.
- Step 2
- Step 3
- Step 4Correct
The chemical 'p-scale' is defined using common base- logarithms (), so reversing it requires the base- power , not the natural exponential .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly defined and classified as a weak acid.
You applied titration stoichiometry at the equivalence point accurately to find the initial concentration of .
You correctly identified that at the exact half-equivalence point.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused the base- logarithmic scale used for and () with the natural logarithm (). Because , the inverse operation is , whereas is the inverse of the natural logarithm .
REASONING PATH
Your ACEpath teacher’s suggested approach- Definition of the 'p' Operator
In chemistry, . Therefore, .
Always use base when converting between , , , and their corresponding concentrations or constants.
- Natural Log vs. Common Log
uses base (inverse is ), while or uses base (inverse is ).
Reserve base for thermodynamic and kinetic relationships like the Arrhenius equation or , and use base for acid-base equilibrium scales.
CORRECTED PATH
ACEpath Teacher's DemonstrationRecall that the p-operator denotes the negative base-10 logarithm: .
Invert the logarithm using base 10: .
Evaluate the power: .
is a weak acid; ;
Lock it in
In an acid–base titration, at which point are the initial moles of weak acid stoichiometrically equal to the moles of added strong base?
At the equivalence point (). Complete neutralization requires a stoichiometric amount of titrant.
Similar question
A aliquot of an unknown weak monoprotic acid is titrated with . The equivalence point is observed at of titrant, and the at added is . Calculate the initial molar concentration of the weak acid and its .
Answer
. Initial concentration: . At half-equivalence (), , so .
A chemist titrates of a weak monoprotic acid with . The half-equivalence point occurs after adding of base, at which point the is . Determine the equivalence point volume of titrant, the initial acid concentration, and the .
Answer
. Moles of acid: . Initial concentration: . Acid constant: .
During the titration of of a weak monoprotic acid with , a student measures after adding of titrant. Calculate the of the acid, and determine the after adding of titrant (at the equivalence point).
Answer
Equivalence volume is , so is the half-equivalence point where . At equivalence, total volume is and . . . .