Resources
A solution contains an extremely low concentration of silver nitrate: . Solid sodium chloride is added until at ( for ). (a) Calculate and evaluate whether precipitation of can occur under these extreme dilution conditions. (b) Calculate the asymptotic limiting concentration of required to force precipitation from this solution, and discuss why precipitation of is physically impossible if the initial is diluted below the theoretical threshold limit where the required exceeds the saturation solubility of ().
Answer and steps
Final answer
(a) ; since (), no precipitation occurs; (b) Asymptotic required ; if , precipitation of is physically unattainable because the required would exceed the solubility limit of ().
Steps
Part (a): Calculating and Determining Precipitation
- Write the dissolution equilibrium and solubility product expression: Silver chloride dissolves according to the equation: The solubility product constant expression is:
- Calculate the ion product (): Using the given initial concentrations, and :
-
Compare to :
- If , the solution is unsaturated, and no precipitate forms.
- If , the solution is saturated at dynamic equilibrium.
- If , the solution is supersaturated, and precipitation occurs until .
Here, . Therefore, the solution is far below saturation, and no precipitation occurs.
Part (b): Minimum Required and the Physical Solubility Limit
- Find the required to initiate precipitation: Precipitation begins the instant the ion product reaches ():
- Determine the physical limit for precipitation: To force precipitation in any solution by adding solid , the required chloride ion concentration cannot exceed the maximum amount of chloride that can dissolve in water. The saturation solubility of is given as , which sets the maximum attainable chloride ion concentration:
- Calculate the theoretical dilution threshold for : The absolute lowest concentration of that can ever be precipitated using occurs when is at its maximum limit ():
- Physical conclusion: If the initial is diluted below , the required to reach would exceed . Adding more solid beyond will not increase in solution (the excess simply remains undissolved). Consequently, can never reach , making the precipitation of physically impossible.
Typical errors
01 The student misinterprets the precipitation criterion by claiming precipitation occurs when Q is less than K_sp.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
Precipitation only occurs when the solution becomes supersaturated (). Because is less than , the ions remain fully dissolved in solution.
- Step 3
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the ion product from the given silver and chloride concentrations.
You accurately determined the chloride concentration needed to begin precipitation ().
You clearly explained the physical constraint imposed by the saturation solubility of .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou knew to compare and , but you accidentally inverted the inequality rule for precipitation.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the condition for an unsaturated solution () with supersaturation (). In solubility equilibrium, represents the maximum capacity of dissolved ions; precipitate only forms when ion concentrations exceed this equilibrium threshold ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Solubility Quotient Rules
unsaturated (no precipitate); saturated (dynamic equilibrium); supersaturated (precipitate forms).
Always remember that solid forms only when the solution has 'too many' ions dissolved ().
CORRECTED PATH
ACEpath Teacher's DemonstrationCompare the calculated reaction quotient to the solubility product: and .
Recognize that , so .
Apply the saturation rule: when , the solution is unsaturated, so all ions remain dissolved and no solid precipitates.
(a) ; since , no precipitation occurs. (b) Required ; precipitation is physically impossible when the required (corresponding to ) because cannot dissolve beyond its saturation limit.
02 The student mistakenly adds the ion concentrations instead of multiplying them to calculate the ion product Q.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
The reaction quotient for a dissolution reaction is an ion product, meaning you must multiply the ion concentrations rather than add them.
- Step 2
Since (), precipitation of occurs.
CorrectSince (), the solution is unsaturated and no precipitation occurs.
Because the calculated value of was incorrect from step 1, your comparison to led to the opposite conclusion. With the correct value of , , so no precipitate forms.
- Step 3
- Step 4
If the required exceeds the solubility limit of , saturates and cannot supply enough ions.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the equilibrium constant expression to find the required chloride concentration in Part (b).
You provided a sound physical explanation of why exceeding the saturation limit of sodium chloride prevents further precipitation.
You showed neat, well-organized steps and maintained correct units throughout your work.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set up as a sum of ion concentrations instead of their product.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the mathematical form of the reaction quotient with a sum rather than a product of molar concentrations derived from the law of mass action.
REASONING PATH
Your ACEpath teacher’s suggested approach- Ion Product Definition
For a salt dissolving as , the reaction quotient is .
Always multiply the active ion concentrations raised to their stoichiometric coefficients; never add them.
- Precipitation Criteria
Compare to : if , precipitation occurs; if , no precipitate forms; if , the solution is saturated.
Evaluate using multiplication first, then compare magnitudes with using scientific notation.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the dissolution expression: .
Express the ion product: .
Substitute the given concentrations: .
Compare with : Since (), the solution is unsaturated and no precipitation occurs.
(a) ; since , no precipitation occurs. (b) ; precipitation is physically impossible if the required exceeds the solubility limit of ().
03 The student multiplies K_sp by [Ag⁺] instead of dividing to determine the required chloride ion concentration.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
To isolate from the solubility product relationship , you must divide by , rather than multiplying them together.
- Step 3Correct
; precipitation is possible at because , but becomes physically impossible if .
Because of the inversion error in the previous step, your required chloride concentration was incorrect. At , the required is , which is well below the solubility limit of , so precipitation can indeed be induced by adding .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly formulated the ion product expression .
You accurately calculated and compared it to to conclude the solution is unsaturated.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou multiplied the equilibrium constant by the ion concentration instead of dividing.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou inverted the algebraic relationship when solving for an unknown ion concentration from , treating the product relationship as a direct proportionality rather than an inverse proportionality.
REASONING PATH
Your ACEpath teacher’s suggested approach- Isolating an Ion from $K_{sp}$
For a 1:1 salt , , so .
Always divide by the known ion concentration when determining the minimum partner concentration needed to reach saturation.
- Checking Physical Plausibility
If one ion concentration is extremely low (), the counter-ion concentration needed to reach must be larger (), not even smaller ().
Perform a quick order-of-magnitude check: the product of the two concentrations must equal .
CORRECTED PATH
ACEpath Teacher's DemonstrationSubstitute the known values: .
Compare with the maximum soluble chloride: Since , precipitation can be induced at this concentration.
Calculate the minimum threshold for silver: . If falls below this value, the required exceeds , making precipitation physically impossible.
(a) , so no precipitation occurs. (b) Required ; precipitation becomes physically impossible only when because cannot exceed the solubility limit of .
Lock it in
What does mean for a sparingly soluble salt in aqueous solution?
The solution is unsaturated; all ions remain dissolved and NO precipitate can form.
Similar question
A solution contains and . For , . Calculate and state whether will precipitate.
Answer
. Since (), the solution is unsaturated and no precipitate forms.
Solid is added to a solution containing . Given , calculate the minimum needed to initiate precipitation.
Answer
Precipitation begins when . Thus, .
The solubility product of is . A chemist prepares a solution with . If the solubility limit of the iodide source () is , determine whether it is physically possible to precipitate from this solution.
Answer
To precipitate , we need . Since (the saturation limit of ), this concentration is readily attainable, so precipitation is physically possible.