Resources
A physiological buffer is formulated by dissolving of disodium hydrogen phosphate (, molar mass ) and of sodium dihydrogen phosphate monohydrate (, molar mass ) into distilled water to produce exactly of aqueous solution. Given that for dihydrogen phosphate dissociation, , the equilibrium constant is () at : (a) convert the solute quantities to molar concentrations in , and (b) calculate the resulting of the physiological buffer.
Answer and steps
Final answer
(a) , ; (b)
Steps
Part (a): Determining Molar Concentrations
-
Calculate the moles of disodium hydrogen phosphate ():
- Mass of
- Molar mass =
Because dissociates completely in water to yield one mole of hydrogen phosphate ion () per mole of salt:
-
Calculate the moles of sodium dihydrogen phosphate monohydrate ():
- Mass of
- Molar mass =
Similarly, complete dissociation produces an equimolar amount of dihydrogen phosphate ion ():
-
Convert moles to molar concentrations: The total volume of the solution is .
Part (b): Calculating the Buffer
-
Identify the acid-base conjugate pair: In this phosphate buffer system:
- Weak acid:
- Conjugate base:
- Equilibrium: with
-
Apply the Henderson–Hasselbalch equation:
Substitute the calculated concentrations:
Since :
Common Pitfall: Always verify which species acts as the proton donor (acid) and which acts as the proton acceptor (base). An inverted ratio inside the logarithm will produce an erroneous . Here, equal concentrations ensure the logarithmic term vanishes, setting .
Typical errors
01 The student inverts the ratio of conjugate base to conjugate acid in the Henderson-Hasselbalch equation by placing acid over base in the log term.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You inverted the quotient in the logarithmic term. In the Henderson–Hasselbalch equation, the numerator must be the conjugate base () and the denominator must be the weak acid ().
- Step 4Correct
Your final numerical value happened to be correct solely because and , but the step follows an incorrect formula.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted both mass values into moles using the provided molar masses.
You correctly determined the molar concentrations of both phosphate species by dividing by the solution volume in liters.
You correctly identified to finish the arithmetic evaluation.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused which species acts as the Brønsted–Lowry acid and which acts as the conjugate base, placing the acid in the numerator of the Henderson–Hasselbalch equation.
REASONING PATH
Your ACEpath teacher’s suggested approach- Identify Acid vs. Conjugate Base
The acid has more ionizable protons (); the conjugate base has one fewer proton.
Compare and . Since has two protons and has one, is the weak acid () and is the conjugate base ().
- Henderson–Hasselbalch Ratio Form
Always write the conjugate base on top. A helpful mnemonic is 'Base on top, Acid at the bottom' or 'B over A'.
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify the weak acid and conjugate base from the equilibrium: , where is the acid and is the base.
Write the standard Henderson–Hasselbalch equation: .
Substitute the known values: .
(a) , ; (b)
02 The student forgets to convert milligrams to grams when calculating molar amounts, yielding concentrations that are off by a factor of 1000.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You substituted the solute masses directly in milligrams ( and ) against molar masses expressed in grams per mole (). You need to convert milligrams to grams first by dividing by (or multiplying by ).
- Step 2Correct
You correctly converted to and used , but your resulting concentrations were times too large because they carried over the mole error from the previous step.
- Step 3Correct
You correctly selected the Henderson–Hasselbalch equation and placed the base and acid in their proper positions, but substituted the inflated concentration values of .
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the conjugate base () and conjugate acid () for the second dissociation of phosphoric acid.
You converted the volume from to accurately.
You applied the Henderson–Hasselbalch equation with the correct ratio of base to acid.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou forgot to convert milligrams to grams before dividing by molar mass, which shifted your molarity by three orders of magnitude.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking unit consistency between solute mass given in milligrams () and molar mass defined in grams per mole ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Unit Alignment Check
Molar mass has units of , so solute mass must be expressed in grams () before dividing: .
Whenever mass is given in , immediately multiply by or write before entering it into your formula.
- Physical Reasonableness of Concentration
A solute concentration of is extraordinarily concentrated (higher than concentrated aqueous acids) and physically impossible for dilute buffer salts.
Always pause to verify whether your calculated molarity is typical for laboratory buffers, which are generally between and .
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert each mass from milligrams to grams: , and .
Calculate moles: , and .
Compute concentrations: , and .
Evaluate : .
(a) , ; (b)
03 The student subtracts the log ratio instead of adding it in the Henderson-Hasselbalch equation.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You used subtraction instead of addition for the ratio of conjugate base to weak acid. In the standard Henderson–Hasselbalch equation, .
- Step 4Correct
Because , the logarithm evaluated to zero, which allowed your final calculation to yield despite the incorrect sign.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the molar amounts of both phosphate salts from their masses and molar masses.
You converted solution volume to liters and found the correct molar concentrations for both species.
You correctly identified the conjugate base and weak acid in the phosphate equilibrium.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou accidentally placed a minus sign in front of the base-to-acid logarithmic term instead of a plus sign.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the two equivalent forms of the logarithmic buffer equation: versus .
REASONING PATH
Your ACEpath teacher’s suggested approach- Henderson–Hasselbalch Sign Convention
More base increases , so must result in .
Always write when the conjugate base is in the numerator.
CORRECTED PATH
ACEpath Teacher's DemonstrationState the Henderson–Hasselbalch equation:
Substitute concentrations:
(a) , ; (b)
Lock it in
What is the general form of the Henderson–Hasselbalch equation for a weak acid and its conjugate base?
Memory cue: Conjugate base on top, weak acid on bottom (B over A).
Similar question
A buffer solution is prepared with and . Given , calculate the of the buffer.
Answer
- Identify as the base and as the acid.
- Apply Henderson–Hasselbalch: .
A chemist dissolves of acetic acid () and of sodium acetate () in of water. If (), find the .
Answer
- Base is (), acid is ().
- Using mole ratio directly: .
You need to prepare a phosphate buffer at using and (). Determine the required molar ratio .
Answer
- Set up Henderson–Hasselbalch: .
- Subtract : .
- Solve: .