Resources
An environmental remediation cell uses electrolysis to recover trace cadmium ions from an industrial wastewater tank. A batch of wastewater initially contains at a concentration of (). The solution is electrolyzed with a constant current of via the reduction (molar mass of ). Assuming an average current efficiency of across the depletion regime due to mass-transport limitations, calculate the time in minutes required to reduce the residual concentration down to the regulatory discharge limit of . Use .
Answer and steps
Final answer
Steps
Calculate the mass of cadmium to be removed
The volume of the industrial wastewater is . The initial concentration is and the target residual concentration is .
Calculate the change in concentration:
The total mass of that must be reduced is:
Applying standard round-to-even convention for three significant figures:
Determine the theoretical charge required ()
The reduction half-reaction at the cathode is:
This reaction requires per mole of deposited.
Convert the mass of cadmium to moles using its molar mass ():
Using Faraday's constant (), the theoretical charge needed solely for cadmium reduction is:
Account for current efficiency and find total charge ()
Current efficiency () is defined as the fraction of the total charge passing through the cell that performs the desired reduction:
Given an average current efficiency of :
Calculate the required electrolysis time in minutes
Current is the rate of electric charge flow (), so the required time in seconds is:
Convert the time to minutes:
Typical errors
01 The student forgets that each cadmium ion requires two electrons for reduction, using z = 1 instead of z = 2, which halves the required time.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
Each ion requires electrons to reduce to metallic . You used , omitting the factor of from the half-reaction.
- Step 3Correct
You correctly divided by the current efficiency, but the value carried forward was already halved.
- Step 4Correct
Your time conversion and formula were executed correctly, but propagated the missing factor of from Step 2.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the net mass and moles of cadmium ions that must be removed from the wastewater.
You correctly applied the current efficiency relationship .
You correctly related electric charge, current, and time, and accurately converted seconds into minutes.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou directly multiplied moles of metal by Faraday's constant () without multiplying by the valence number () representing the number of moles of electrons transferred per mole of substance reduced.
REASONING PATH
Your ACEpath teacher’s suggested approach- Balancing the Half-Reaction
Always write out the reduction half-reaction to identify the moles of electrons transferred per mole of metal deposited ().
Before calculating charge, write out and verify that is included in .
- Accounting for Current Efficiency
Current efficiency , so total charge is always greater than theoretical charge ().
Confirm that when .
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the cathodic reduction half-reaction: , which yields .
Compute the theoretical charge: .
Incorporate the current efficiency: .
Calculate total electrolysis time: .
Convert seconds to minutes: .
02 The student multiplies by the current efficiency instead of dividing by it, incorrectly assuming less total charge is needed rather than more.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
Current efficiency is defined as , which means . Since only of the supplied charge goes toward reducing , the total charge supplied by the power source must be larger than the theoretical charge, not smaller.
- Step 4Correct
Your time calculation followed the right formula and unit conversion, but the value was affected by the incorrect total charge from Step 3.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly found the mass of cadmium to be removed from the given wastewater volume and concentration change.
You converted the mass to moles accurately using the molar mass.
You correctly identified that reducing each cadmium ion requires 2 electrons and applied Faraday's constant to determine the theoretical charge.
You correctly related current, total charge, and time, including the conversion from seconds to minutes.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated current efficiency as a multiplying factor on the required theoretical charge instead of recognizing that inefficiency increases the total electrical charge and operational time required.
REASONING PATH
Your ACEpath teacher’s suggested approach- Definition of Current Efficiency
When solving for the total charge supplied by an external source, divide the theoretical charge by : .
- Physical Sanity Check
Whenever efficiency is less than (), side reactions consume part of the current.
Confirm that your calculated total charge and total time are strictly greater than their theoretical zero-loss values.
CORRECTED PATH
ACEpath Teacher's Demonstration(or without intermediate rounding)
03 The student bases the calculation on the total initial cadmium content of 25.0 mg/L rather than the amount removed down to the 0.50 mg/L limit.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You calculated the total mass of cadmium originally present rather than the mass that must be removed. The wastewater is only treated down to the discharge limit of , so .
- Step 2Correct
Your molar mass conversion formula is correct, but the result carries forward the initial mass value.
- Step 3Correct
You correctly applied and Faraday's constant, but this step inherits the previous mass error.
- Step 4Correct
You correctly divided the theoretical charge by the current efficiency (), but the calculation uses the propagated charge.
- Step 5Correct
You correctly converted current and seconds into minutes, but the final answer is higher than expected due to the extra cadmium assumed in Step 1.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the two-electron stoichiometry for cadmium reduction.
You properly used current efficiency by dividing theoretical charge by .
You handled the conversions between charge, current, seconds, and minutes without any arithmetic slips.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou solved for the time needed to remove 100% of the cadmium instead of stopping at the regulatory limit of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisIn environmental remediation problems, the required extent of reaction is determined by , not by alone.
REASONING PATH
Your ACEpath teacher’s suggested approach- Identify Initial vs. Net Change
Whenever an end concentration or regulatory threshold is specified, the reacting quantity is .
Always highlight both initial and final concentrations and write out before computing mass.
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate the concentration change: .
Find mass removed: .
Convert to moles: .
Find theoretical charge: .
Account for current efficiency: .
Calculate time in minutes: .
Lock it in
What is the general formula relating charge (), moles of substance reduced/oxidized (), and Faraday's constant ()?
, where is the number of moles of electrons transferred per mole of substance according to the balanced half-reaction.
Similar question
A solution containing is electrolyzed at a steady current of with current efficiency to plate out of silver (). How many seconds does this process take? ()
Answer
. For , . . Time ().
An acidic solution containing is electrolyzed to plate metallic chromium (). If a current of runs for with a current efficiency of , what mass of is deposited? ()
Answer
Total charge . Useful charge . For , . Moles of . Mass .
Industrial wastewater () containing () at an initial concentration of is treated by electrodeposition down to . The cell operates at with an average current efficiency of . Calculate the required operation time in hours. ()
Answer
Mass removed . Moles . For , . . Total charge . Time .