Resources
Solid ammonium carbamate () decomposes upon heating according to the equilibrium reaction: . An evacuated rigid flask containing excess solid ammonium carbamate is allowed to reach chemical equilibrium at , at which point the total equilibrium pressure is found to be . (a) Calculate the partial pressures of and at equilibrium. (b) Calculate the equilibrium constant for this decomposition at .
Answer and steps
Final answer
(a) , ; (b)
Steps
Part (a): Determining the Partial Pressures
- Relate the moles of gases produced by stoichiometry: The balanced decomposition equation is: Because the flask was initially evacuated, the only gases present arise exclusively from the decomposition of solid ammonium carbamate. According to the stoichiometry, the reaction produces of for every of .
- Express partial pressures in terms of a single variable: By the ideal gas law ( at constant temperature and volume), the partial pressure of each gas is directly proportional to the number of moles produced:
- Apply Dalton's Law of Partial Pressures: The total pressure is the sum of the individual partial pressures: Substitute into the equation:
- Calculate the equilibrium partial pressures: Given :
Part (b): Calculating the Equilibrium Constant ()
-
Write the expression for : In heterogeneous equilibria, pure solids do not appear in the equilibrium expression because their activities are defined as . Therefore:
(Common Pitfall: Do not include the solid reactant in the denominator of , and remember to raise to the power of its stoichiometric coefficient, which is .)
- Substitute the calculated equilibrium partial pressures:
Typical errors
01 The student assumes equal partial pressures for both gases by dividing the total pressure equally instead of using stoichiometric ratios.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You assumed equal partial pressures, but the stoichiometry of produces of for every of . Because partial pressure is directly proportional to moles, .
- Step 3Correct
You correctly wrote the expression without including the solid reactant, but substituting the incorrect partial pressures led to an incorrect value for .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly stated that the total pressure is the sum of the individual partial pressures.
You wrote the correct equilibrium expression , correctly excluding the pure solid and squaring the ammonia term.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou divided the total pressure equally by 2 instead of distributing it according to the stoichiometric mole ratio.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou overlooked that the partial pressures of gases generated entirely from the decomposition of a solid are proportional to their stoichiometric coefficients ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Gas Stoichiometry in Rigid Flasks
When gases are formed exclusively from a decomposition reaction at constant volume and temperature, .
Express each gas pressure as a multiple of a single variable based on its stoichiometric coefficient before solving for total pressure.
CORRECTED PATH
ACEpath Teacher's DemonstrationRelate the partial pressures using reaction stoichiometry: and .
Substitute into Dalton's law: .
Solve for : , so .
Substitute the correct equilibrium values into : .
(a) , ; (b)
02 The student forgets to square the partial pressure of NH3 according to its stoichiometric coefficient in the Kp expression.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
In the balanced equation, of are produced per mole of reaction, so its partial pressure must be raised to the second power: .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the stoichiometry to relate to .
You correctly applied Dalton's law of partial pressures to set the sum equal to .
You calculated accurate equilibrium partial pressures for both product gases.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou treated the partial pressure of as having a power of rather than squaring it.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the linear stoichiometric coefficient used in partial pressure sums with the exponential power required by the law of mass action in equilibrium expressions.
REASONING PATH
Your ACEpath teacher’s suggested approach- Check coefficients against exponents
For a reaction , the equilibrium constant expression is .
Always write out the general symbolic expression directly from the balanced chemical equation and circle each stoichiometric coefficient before plugging in numbers.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the expression using the stoichiometric coefficients as exponents: .
Substitute the equilibrium partial pressures found in Part (a): .
Evaluate the arithmetic: , and .
(a) , ; (b)
03 The student misinterprets the 2:1 stoichiometric ratio and sets P(CO2) = 2P(NH3), inverting the partial pressures of the two gases.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
According to the balanced reaction , 2 moles of are produced for every 1 mole of . At constant volume and temperature, partial pressure is proportional to moles, so the partial pressure of must be twice that of , not the other way around.
- Step 2Correct
Your algebraic method for combining the partial pressures was sound, but your values were inverted because of the ratio error in Step 1.
- Step 3Correct
You wrote the correct equilibrium expression excluding the solid reactant and correctly squared the partial pressure of ammonia. However, substituting the inverted pressure values resulted in an incorrect value.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly excluded the solid ammonium carbamate from the expression.
You correctly raised to the second power according to its stoichiometric coefficient.
You correctly applied Dalton's law of partial pressures to sum the gas pressures.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou accidentally placed the factor of 2 on the wrong gas when relating the partial pressures.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the stoichiometric mole ratio: when a reaction produces 2 units of gas A for every 1 unit of gas B, gas A must have the larger mole amount and larger pressure ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Sanity check coefficients and relative pressures
For gases generated solely from the decomposition of a solid, the gas with the larger stoichiometric coefficient must have the larger partial pressure.
Always verify that the gas with a coefficient of 2 has twice the partial pressure of the gas with a coefficient of 1.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet based on the mole ratio.
Substitute into Dalton's law: .
Solve for the partial pressures: and .
Substitute these values into .
(a) , ; (b)
Lock it in
When a solid decomposes into multiple gases in an evacuated container, how do their partial pressures relate to each other?
Their partial pressures are directly proportional to their stoichiometric coefficients () because and are constant.
Similar question
Solid ammonium hydrogen sulfide decomposes according to: . In an evacuated flask at , the total equilibrium pressure is . Calculate .
Answer
Key steps: The mole ratio of to is , so . .
Solid carbon decomposes steam via the reaction: . If starting only with pure steam and solid carbon, at equilibrium the total pressure is and the remaining steam has a partial pressure of . Find the partial pressures of and at equilibrium.
Answer
Key steps: Pressure due to produced gases is . The stoichiometry produces for every , so and . Thus, . Therefore, and .
Solid phosphonium iodide decomposes according to: , while hydrogen iodide further partially decomposes according to . If no secondary decomposition occurs, reaches equilibrium with . Then, an additional of inert argon is pumped in at constant volume and temperature. State the partial pressure of and calculate for the primary decomposition.
Answer
Key steps: Adding an inert gas at constant volume does not change the partial pressures of the reacting gases or the position of equilibrium. Because and are formed in a ratio, . .