Resources
In an experiment studying enzyme kinetics and surface-mediated catalysis, a student monitors the decomposition of of aqueous using an immobilized catalase bead suspension at . The evolved oxygen gas is collected over water in an inverted gas-measuring buret at an atmospheric pressure of (the vapor pressure of water at is ). Over the first of catalyzed reaction, exactly of wet is collected. Assuming ideal gas behavior ( and ), calculate: (a) the number of moles of dry produced during this interval, and (b) the average rate of decomposition in the solution, , in units of .
Answer and steps
Final answer
(a) ; (b)
Steps
Part (a): Moles of Dry Produced
- Find the partial pressure of dry oxygen gas using Dalton's Law of Partial Pressures: Because oxygen gas is collected over water, the total pressure is the sum of the partial pressure of dry and the vapor pressure of water ():
- Convert the pressure to atmospheres:
-
Calculate the moles of dry using the ideal gas law ():
- Volume of gas collected:
- Temperature:
- Gas constant:
Part (b): Average Rate of Decomposition
-
Relate moles of produced to moles of consumed: The balanced chemical equation for the catalyzed decomposition of hydrogen peroxide is:
From the stoichiometric ratio ():
-
Calculate the change in molarity () in the aqueous solution:
- Volume of the reaction solution:
- Determine the average rate of decomposition: Over the time interval :
Common Pitfall: A frequent mistake is using the gas volume () instead of the liquid solution volume () when computing the molar concentration of , or forgetting to subtract the vapor pressure of water before applying the ideal gas law.
Typical errors
01 The student ignores Dalton's law of partial pressures and fails to subtract the vapor pressure of water when calculating moles of dry oxygen collected over water.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Because oxygen gas was collected over water, the total measured pressure includes both dry oxygen gas and water vapor. You need to apply Dalton's law of partial pressures () before converting to atmospheres.
- Step 2Correct
Your setup of the ideal gas law and unit conversions for volume and temperature were completely correct, but the result was shifted by the unadjusted pressure from Step 1.
- Step 3Correct
You correctly applied the stoichiometry between and and correctly divided by the liquid reaction volume (), though the numerical value carried over the earlier pressure error.
- Step 4Correct
Your definition and calculation of the reaction rate using the elapsed time were correct, propagating the earlier pressure slip into the final value.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted the gas volume from milliliters to liters.
You properly used the stoichiometric molar ratio from the decomposition equation .
You astutely divided by the liquid solution volume () rather than confounding it with the collected gas volume.
You correctly defined and calculated the reaction rate as the change in molarity over time.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou converted the total atmospheric pressure directly to atmospheres instead of subtracting the vapor pressure of water first.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking that gas collected over water is a mixture containing saturated water vapor, requiring Dalton's law () to isolate the dry gas pressure before applying the ideal gas law.
REASONING PATH
Your ACEpath teacher’s suggested approach- Gas Collected Over Water Check
Whenever an experiment specifies that a gas is 'collected over water' or provides the vapor pressure of water (), the gas inside the buret is 'wet'.
Always subtract from immediately: .
- Consistent Pressure Units Before Conversion
Both total barometric pressure and vapor pressure must be in the same units (e.g., ) prior to subtraction.
Perform the subtraction in , then divide the net dry pressure by .
CORRECTED PATH
ACEpath Teacher's DemonstrationSubtract the vapor pressure of water: .
Convert dry oxygen pressure to atmospheres: .
Solve for dry moles of : .
Find moles of decomposed: .
Determine concentration change: .
Compute decomposition rate: .
(a) ; (b)
02 The student forgets the 2:1 stoichiometric ratio between H₂O₂ and O₂, assuming that one mole of H₂O₂ decomposes to form one mole of O₂.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
From the balanced reaction , two moles of decompose for every one mole of produced.
- Step 3Correct
Your formula for molarity and your choice of solution volume () were correct, but the value is affected by the missing stoichiometric factor of .
- Step 4Correct
- = - = 1.00 10^{-3}\text{ M}$$\cdot$$\text{s}^{-1}
Your rate calculation method is correct, but the final numerical value is halved due to the earlier stoichiometry error.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly subtracted the vapor pressure of water to obtain the partial pressure of dry oxygen gas.
You correctly applied the ideal gas equation to find the moles of oxygen collected.
You correctly identified and used the aqueous solution volume rather than the gas volume to calculate the concentration change of hydrogen peroxide.
You correctly divided the molarity change by elapsed time to determine the average rate.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou assumed that hydrogen peroxide and oxygen react in an equimolar ratio, overlooking the stoichiometric coefficient of for in the balanced decomposition equation .
REASONING PATH
Your ACEpath teacher’s suggested approach- Write and Balance the Equation First
Always write out the balanced chemical equation before relating the consumption of reactant to the formation of product: .
Before converting moles between species, explicitly write down the mole ratio from the balanced equation.
- Distinguish Phase Volumes
In gas-collection kinetics, use gas volume for the gas law () and solution volume for aqueous concentration ().
Label and separately to prevent confusing the two quantities.
CORRECTED PATH
ACEpath Teacher's DemonstrationUse the balanced decomposition equation: .
Multiply moles of by : .
Divide by the reaction solution volume: .
Divide by the time interval: .
(a) ; (b)
03 The student divides the moles of decomposed H₂O₂ by the gas buret volume rather than the aqueous solution volume when computing concentration.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
- Step 4Correct
You used the gas collection volume () in the denominator. Because hydrogen peroxide is dissolved in the liquid phase, its molarity must be calculated using the aqueous reaction volume ().
- Step 5Correct
Your rate setup dividing concentration change by elapsed time was mathematically correct, but the numerical result was affected by the volume error from the previous step.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly applied Dalton's law to subtract the water vapor pressure.
You correctly converted units and applied the ideal gas equation .
You correctly applied the stoichiometric ratio between and .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the volume of the gas collection apparatus () with the volume of the aqueous solution () when calculating molar concentration .
REASONING PATH
Your ACEpath teacher’s suggested approach- Gas Phase vs. Aqueous Phase Volume
The concentration of an aqueous reactant is always computed over the volume of the liquid solution, never the volume of gas collected above it.
Separate your system into two phases: use only in for the gas buret, and use for all solution molarity calculations.
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify the liquid volume containing the reactant: .
Calculate the molarity change: .
Calculate the average reaction rate: .
(a) ; (b)
Lock it in
When a gas is collected over water, why can't you directly substitute the barometric pressure into to find the moles of generated gas?
The collected gas is saturated with water vapor. By Dalton's Law, , so using overestimates the moles of the gas produced.
Similar question
A sample of is thermally decomposed, yielding of wet oxygen collected over water at and an atmospheric pressure of . The vapor pressure of water at is . Calculate the moles of dry produced.
Answer
. Key steps: ; ; .
A solution of decomposes via a platinum catalyst at . Over , of is collected over water at ( at ). Find the average rate of disappearance of , , in .
Answer
. Key steps: ; ; ; ; .
An experiment generates hydrogen gas by reacting zinc with excess . The wet gas is collected in a buret over water at and (). If of pure () reacts completely according to , what volume of wet gas (in ) will be collected in the buret?
Answer
. Key steps: ; ; .