Resources
In a spectrophotometric standardization experiment, iron(III) ions react with thiocyanate ions to form the deep-red complex according to the equation: . Write the formation constant () expression. A student mixes of with of . At equilibrium, spectrophotometric analysis determines that . Calculate the initial concentrations of both reactants immediately upon mixing, construct the equilibrium concentration values, and determine the experimental .
Answer and steps
Final answer
Expression: ; Initial concentrations: , ; Equilibrium concentrations: , ; Experimental constant:
Steps
Equilibrium Expression
For the homogeneous complex-ion formation reaction:
The formation constant () expression is written as the ratio of the equilibrium molar concentration of the product complex to the product of the equilibrium molar concentrations of the uncomplexed reactant ions, each raised to the power of its stoichiometric coefficient ():
K_f = \frac{[[\ce{Fe(SCN)}]^{2+}]}{[\ce{Fe^{3+}][\ce{SCN^-}]}
Initial Concentrations After Mixing
When two solutions are combined, each solute is diluted by the total volume of the mixture.
- Total volume:
-
Dilution formula:
- For :
- For :
Common Pitfall: Forgetting to account for the dilution step upon mixing the two solutions is a frequent mistake. You must use the concentrations immediately after mixing, not the stock bottle concentrations.
Equilibrium Concentrations (ICE Table Method)
From the stoichiometry of the reaction, 1 mole of reacts with 1 mole of to yield 1 mole of .
The spectrophotometric measurement gives the equilibrium concentration of the complex:
Substitute to find the remaining concentrations of reactants at equilibrium:
Determination of Experimental
Substitute the equilibrium concentrations into the expression:
Typical errors
01 The student forgets to account for dilution upon mixing equal volumes, using the stock solution concentrations as initial concentrations.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You used the stock concentrations directly instead of accounting for the doubling of total volume upon mixing of each solution.
- Step 3Correct
Your subtraction correctly reflects the reaction stoichiometry, but the values are shifted due to the incorrect initial concentrations.
- Step 4Correct
You substituted your equilibrium values into the expression correctly, but the resulting numerical value inherits the earlier dilution error.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly wrote the equilibrium constant expression for the complex formation.
You applied the stoichiometric relationship to calculate equilibrium concentrations from your initial concentrations.
You correctly substituted your calculated values into the expression.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou copied the stock solution concentration directly as the initial concentration at the moment of mixing.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisMixing two solutions increases the total volume (), which lowers the concentration of all solutes before any chemical equilibrium is established.
REASONING PATH
Your ACEpath teacher’s suggested approach- Check Total Solution Volume
, where
Before setting up an ICE table, always determine whether combining solutions changed the volume, and compute fresh initial molarities.
CORRECTED PATH
ACEpath Teacher's DemonstrationFind total volume: .
Compute diluted initial concentrations: .
Calculate equilibrium concentrations: .
Evaluate : .
02 The student mistakes the initial concentrations upon mixing for the equilibrium concentrations, neglecting the consumption of reactants to form the complex.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
Because of each reactant is consumed for every of complex formed, you must subtract from the initial concentrations.
- Step 4Correct
Your calculation followed correctly from your substituted values, but it used the unreacted initial concentrations rather than the true equilibrium concentrations.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly derived the mass-action expression.
You properly applied the dilution formula to determine reactant concentrations immediately after mixing.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the initial concentrations upon mixing as if no reactants were consumed during the reaction, omitting the stoichiometric depletion step .
REASONING PATH
Your ACEpath teacher’s suggested approach- Conservation of Mass in Equilibrium Mixtures
For a reaction , when .
Always subtract the amount of product formed from each reactant's initial concentration before substituting into the equilibrium constant expression.
CORRECTED PATH
ACEpath Teacher's DemonstrationDetermine the change in concentration using stoichiometry: .
Calculate equilibrium concentration: .
Apply the same deduction for : .
Substitute the equilibrium values into : .
03 The student inverts the equilibrium constant expression by writing reactants over products, resulting in the reciprocal of the formation constant.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
The equilibrium constant expression is always written as the concentration of products over the concentration of reactants, raised to their stoichiometric coefficients.
- Step 2
- Step 3
- Step 4Correct
Your arithmetic substitution followed your inverted formula from Step 1, producing instead of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the dilution factor to determine initial concentrations immediately after mixing.
You successfully used the stoichiometric mole ratio to compute the uncomplexed reactant concentrations at equilibrium.
You recognized that concentrations are multiplied rather than added in an equilibrium expression.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou placed reactants over products instead of products over reactants when writing .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConflating the orientation of the law of mass action ratio, likely from associating the forward starting materials with the top of the fraction.
REASONING PATH
Your ACEpath teacher’s suggested approach- Law of Mass Action Orientation
For any general reversible reaction , the equilibrium constant is defined as .
Always remember the mnemonic 'Products over Reactants' (P over R) before substituting numerical values.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the standard formation constant expression with the complex in the numerator: .
Substitute the equilibrium concentrations: .
Evaluate the numerical value: .
Lock it in
When two aqueous solutions are mixed together to start a reaction, how do you find the initial concentration of a reactant?
Use the dilution equation: , where is the sum of both solution volumes.
Similar question
A student mixes of with of . What are the initial concentrations and immediately after mixing?
Answer
. The total volume doubles to , so each concentration is halved: .
A reaction mixture is prepared by combining of and of . Calculate the initial concentrations and upon mixing.
Answer
, . The total volume is . Thus, and .
In the reaction , of is mixed with of . At equilibrium, . Calculate the equilibrium constant .
Answer
. Total volume . Initial values: , . At equilibrium: . Then .