Resources
An unknown pure alkali metal carbonate with the general formula has a measured molar mass of . Using the standard atomic masses and , determine the atomic mass of the unknown alkali metal and identify the element from the periodic table.
Answer and steps
Final answer
Atomic mass of ; Element is Potassium ()
Steps
Express the molar mass of the compound in terms of its constituent elements
The formula of the alkali metal carbonate is . One mole of this compound contains:
- of the alkali metal
- of carbon atoms ()
- of oxygen atoms ()
Therefore, the equation for the total molar mass is:
Calculate the mass contribution of the carbonate group ()
Substitute the given standard atomic masses for carbon and oxygen:
Solve for the atomic mass of metal
Subtract the mass of the carbonate group from the total molar mass of the compound to find the mass contributed by the two metal atoms:
Now, divide by to find the atomic mass of a single mole of :
Common Pitfall: Forgetting the subscript on is a frequent error. The mass difference () represents two moles of alkali metal cations, so it must be divided by to find the atomic mass of the individual element.
Identify the element
Compare the calculated atomic mass of to the alkali metals (Group 1 elements) on the periodic table:
- Lithium ():
- Sodium ():
- Potassium ():
- Rubidium ():
The atomic mass matches potassium ().
Typical errors
01 The student forgets to divide the remaining mass by 2 for the two metal atoms in M2CO3, yielding an atomic mass of 78.202 g/mol and misidentifying the metal as selenium.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
The formula is , which contains two moles of per mole of compound. The remaining corresponds to , so you need to divide this value by to find the atomic mass of .
- Step 3Correct
Because the atomic mass from the previous step was not divided by , you matched the mass to selenium. Additionally, selenium is a Group 16 nonmetal/metalloid, whereas the question specified that is an alkali metal (Group 1).
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the molar mass contribution of the carbonate ion.
You set up a sound subtraction strategy to isolate the metal contribution from the total molar mass.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou treated the formula as rather than , omitting the factor of when solving for the molar mass of element .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking chemical formula subscripts during mass balance calculations leads to equating the total mass of an element in a compound with its molar mass.
REASONING PATH
Your ACEpath teacher’s suggested approach- Subscript Multiplier Check
In a formula , the total mass contributed by element equals .
Always write out the expanded formula before substituting numbers.
- Periodic Family Verification
The identified element must match the chemical family specified in the problem statement.
Check that your identified element is an alkali metal (Group 1: , , , , ). Selenium is in Group 16.
CORRECTED PATH
ACEpath Teacher's DemonstrationConsulting Group 1 (alkali metals) on the periodic table, the element with molar mass is potassium ().
Atomic mass of ; Element is Potassium ()
02 The student miscounts the number of oxygen atoms in carbonate as one instead of three, calculating an incorrect molar mass for the anion and identifying rubidium.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You calculated the molar mass of carbon monoxide () instead of the carbonate group (). A carbonate ion contains three oxygen atoms, so you must multiply the atomic mass of oxygen by .
- Step 2Correct
Your algebraic procedure—subtracting the anion mass and dividing by for the two atoms—was sound, but the result was shifted by the incorrect anion mass from Step 1.
- Step 3Correct
You matched to manganese, but the correct atomic mass of corresponds to potassium (). Note also that manganese is a transition metal, while the question specified an alkali metal (Group 1).
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly accounted for the two metal atoms in by setting up and dividing by .
You correctly subtracted the non-metal mass from the total molar mass to isolate the contribution of the metal.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote instead of , leaving out two oxygen atoms.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisFailing to account for chemical formula subscripts when decomposing a polyatomic ion into its constituent elements.
REASONING PATH
Your ACEpath teacher’s suggested approach- Subscript Accounting
In a chemical formula, every subscript multiplies the molar mass of the element immediately preceding it: .
Always list each element and its corresponding subscript explicitly before adding atomic masses.
- Family Verification
Alkali metals are exclusively the Group 1 elements (, , , , , ).
Check that your final identified element matches the chemical family specified in the problem statement.
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate the molar mass of the carbonate group with all three oxygens: .
Subtract the carbonate group mass from the total molar mass: .
Divide by to find the atomic mass of metal : .
Compare to Group 1 alkali metals: potassium () has an atomic mass of .
Atomic mass of ; Element is Potassium ()
03 The student assumes a 1:1 metal-to-carbonate ratio with formula MCO3 instead of M2CO3 and incorrectly divides by 1.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
The problem specifies the formula , which contains two alkali metal atoms per formula unit. The difference accounts for of , so you must divide by to find the atomic mass of .
- Step 3Correct
Carrying forward the incorrect atomic mass of led you to select bromine (, atomic mass ), which is a halogen rather than an alkali metal. Using the correct mass of identifies potassium ().
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the combined molar mass of the carbonate group ().
You correctly subtracted the anion mass from the total molar mass of the compound.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote the formula as instead of , omitting the subscript on the metal cation.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou overlooked the stoichiometric coefficient of the alkali metal cation indicated by the subscript in , treating the metal-to-carbonate ratio as instead of . Additionally, alkali metals (Group 1) form cations, requiring two cations to balance the charge of carbonate.
REASONING PATH
Your ACEpath teacher’s suggested approach- Subscript Accounting
Every subscript in a chemical formula represents the mole ratio of that atom per mole of compound.
Always write down the full algebraic breakdown first: before substituting values.
- Chemical Family Sanity Check
Alkali metals belong exclusively to Group 1 of the periodic table (, , , , , ).
Verify that your final candidate element belongs to the chemical group specified in the prompt.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the molar mass equation: .
Substitute the carbonate mass: .
Divide by to find the atomic mass of one mole of : .
Locate Group 1 (alkali metals) on the periodic table to find the element with an atomic mass near , which is potassium ().
Atomic mass of ; Element is Potassium ()
Lock it in
When solving for the molar mass of an element in a compound , what relation connects the remaining mass to the atomic mass of ?
. You must divide the remaining mass by the element's subscript .
Similar question
An unknown alkali metal oxide has the formula and a measured molar mass of . Using , calculate the atomic mass of and identify the metal.
Answer
. Dividing by gives . The alkali metal is Sodium ().
An unknown alkali metal sulfate has the formula and a molar mass of . Given standard atomic masses and , determine the atomic mass of and identify the element.
Answer
Molar mass of . Total mass of metal . Dividing by yields . The alkali metal is Potassium ().
A hydrated alkali metal carbonate with the formula has a molar mass of . Using , , and , find the atomic mass of and identify the alkali metal.
Answer
Mass of . Mass of . Mass of . Dividing by gives . The alkali metal is Sodium ().