Resources
In an analytical chemistry laboratory, a student standardizes primary standard potassium hydrogen phthalate (KHP, , molar mass ) by reacting of dried KHP with an estimated sodium hydroxide solution: . (a) Calculate the theoretical volume in milliliters of exactly required to reach the stoichiometric equivalence point. (b) The student titrates using a class A burette (initial reading ) and reaches the phenolphthalein light pink endpoint at a final burette reading of . Calculate the actual titrant volume dispensed. (c) Determine the percent recovery (percent of theoretical titrant volume consumed) and state whether the titrant was slightly under- or over-titrated.
Answer and steps
Final answer
(a) Theoretical volume = ; (b) Actual volume dispensed = ; (c) Percent recovery = , indicating slight over-titration past the equivalence point
Steps
Part (a): Theoretical Volume of Required
- Calculate the moles of primary standard potassium hydrogen phthalate ():
- Determine the stoichiometric moles of needed: According to the balanced equation: The molar ratio of to is . Therefore:
- Calculate the theoretical volume () in milliliters: Using the definition of molarity (): Converting to milliliters:
Part (b): Actual Titrant Volume Dispensed
The volume of titrant dispensed from a burette is the difference between the final and initial readings:
Part (c): Percent Recovery and Titration State
- Calculate the percent recovery of the theoretical titrant volume:
-
Evaluate under- or over-titration:
- Because the actual volume delivered () is greater than the theoretical volume required at the stoichiometric equivalence point (), the value exceeds .
- This indicates that the sample was slightly over-titrated past the stoichiometric equivalence point.
Typical errors
01 The student uses the estimated 0.1000 M concentration instead of the exact 0.1042 M concentration to find the theoretical volume, resulting in 41.82 mL.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You used the estimated nominal concentration of instead of the exact concentration of specified in part (a).
- Step 3
- Step 4Correct
Your percent recovery formula and logical deduction were mechanically sound, but the numerical result and conclusion were shifted because they relied on the erroneous theoretical volume from Step 2.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the moles of potassium hydrogen phthalate from its measured mass and molar mass.
You correctly found the net volume dispensed from the initial and final burette readings.
You set up the correct ratio for calculating percent recovery.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou substituted the approximate benchmark concentration of instead of the exact titrant concentration of provided in prompt (a).
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking the exact concentration given for part (a) in favor of the introductory nominal estimate led to an inflated theoretical equivalence volume ( vs. ), which in turn made an actual volume of appear under-titrated instead of over-titrated.
REASONING PATH
Your ACEpath teacher’s suggested approach- Nominal vs. Exact Concentration
When a problem specifies an exact titrant concentration for theoretical calculations (e.g., 'exactly '), do not use an approximate or target preparation value (e.g., 'estimated ').
Always verify which concentration value is designated for the quantitative stoichiometric calculation.
- Interpreting Over- vs. Under-Titration
If , the percent recovery is , meaning titrant was added past the stoichiometric equivalence point (over-titrated).
Compare the actual delivered volume directly with the true stoichiometric volume before concluding the titration state.
CORRECTED PATH
ACEpath Teacher's DemonstrationRecalculate the theoretical volume using the exact concentration: .
Compute the corrected percent recovery: .
Because (), titrant was dispensed past the equivalence point.
(a) ; (b) ; (c) , slightly over-titrated
02 The student adds the initial and final burette readings rather than subtracting them, finding an incorrect dispensed volume of 43.60 mL.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You added the initial reading to the final reading instead of subtracting it. The volume dispensed from a burette is the difference between the final reading and the initial reading ().
- Step 3Correct
You applied the correct percent recovery formula, but your result was affected by the erroneous actual volume carried forward from part (b).
- Step 4Correct
Your qualitative conclusion is chemically sound because any recovery greater than indicates over-titration, but the value you cited was propagated from the earlier error.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the stoichiometric moles of and the corresponding theoretical volume of .
You used the correct ratio formula for percent recovery.
You correctly interpreted that a titrant recovery greater than corresponds to over-titrating past the equivalence point.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou accidentally added the starting burette reading instead of taking the difference between the final and initial marks.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the operation needed for interval measurement on a downward-graduated scale: a burette measures delivered fluid by difference (), never by addition.
REASONING PATH
Your ACEpath teacher’s suggested approach- Burette Dispensation Formula
Burette volume delivered is always final reading minus initial reading: .
Always subtract the smaller initial reading from the larger final reading when recording delivered titrant.
- Physical Reality Check
The volume delivered must be strictly less than the final reading on the burette barrel.
Notice that dispensing titrant drains fluid down the barrel; adding readings yields a total volume larger than the burette reading itself, which is physically impossible.
CORRECTED PATH
ACEpath Teacher's DemonstrationSubtract the initial burette reading from the final reading: .
Recalculate percent recovery using the corrected actual volume: .
Compare with : since , the titrant was slightly over-titrated.
(a) ; (b) ; (c) , slightly over-titrated
03 The student inverts the ratio for percent recovery, dividing theoretical volume by actual volume to get 97.17% and incorrectly concluding it was under-titrated.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You inverted the fraction by dividing theoretical volume by actual volume. Percent yield or percent recovery is always defined as .
- Step 4Correct
Because your calculated recovery was less than , you concluded the sample was under-titrated. With the correct recovery of , the delivered volume exceeds the stoichiometric requirement, meaning the sample was slightly over-titrated.
WHAT YOU DID WELL
Compliments from Your TeacherYou calculated the moles of potassium hydrogen phthalate accurately using its molar mass.
You determined the stoichiometric volume of sodium hydroxide required at the equivalence point.
You found the net volume delivered from the burette by taking the difference between the final and initial readings.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set up the ratio as theoretical divided by actual instead of actual divided by theoretical.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the numerator and denominator in percent yield and percent recovery definitions, often caused by reflexively placing the smaller number on top to ensure a value under 100%.
REASONING PATH
Your ACEpath teacher’s suggested approach- Ratio Definition Check
Always place the experimental observation in the numerator and the calculated theoretical benchmark in the denominator.
- Physical Reality Check
If you added more titrant than theoretically needed (), the percent recovery must be , representing over-titration.
Compare the two raw volumes directly before interpreting: physically means extra titrant was added past the equivalence point.
CORRECTED PATH
ACEpath Teacher's DemonstrationSubstitute into the numerator and into the denominator: .
Compare the recovery to : since (and ), more titrant was delivered than required to reach the equivalence point.
Conclude that the titration was slightly over-titrated past the equivalence point.
(a) ; (b) ; (c) , indicating slight over-titration
Lock it in
How do you calculate the theoretical equivalence volume () of a titrant from the moles of analyte () and titrant molarity ()?
. Always use the exact known molarity rather than an approximate nominal concentration.
Similar question
A sample of of KHP (molar mass ) is titrated with an exact solution. Calculate the theoretical equivalence volume in milliliters.
Answer
- Moles of KHP .\n2. reaction ratio means .\n3. .
In a standardization titration, the stoichiometric volume required is . A student reads an initial burette volume of and a final burette volume of . Calculate the actual volume dispensed, the percent recovery, and determine whether the sample was under- or over-titrated.
Answer
- .\n2. .\n3. Because (), the sample was under-titrated.
A chemist dissolves of oxalic acid dihydrate (, molar mass , diprotic acid) to standardize a sodium hydroxide solution. If of is dispensed at the endpoint, yielding a recovery of the theoretical volume, what is the exact molarity of the solution?
Answer
- Moles of acid .\n2. Since oxalic acid is diprotic: .\n3. , and percent recovery , so .\n4. Molarity .