Resources
An aqueous solution of of is mixed with of . (a) Using standard solubility rules, predict whether a precipitate forms and identify its chemical formula. (b) Write the balanced net ionic equation for the precipitation reaction, including state symbols. (c) Calculate the theoretical yield of the precipitate in grams. (Molar mass of )
Answer and steps
Final answer
(a) A precipitate forms: ; (b) ; (c)
Steps
Part (a): Predicting the Precipitate Using Solubility Rules
When solutions of lead(II) nitrate, , and potassium iodide, , are combined, the ions present in the mixture before any reaction are:
A double-displacement exchange yields two potential new combinations:
- (Potassium nitrate): According to standard solubility rules, all salts of alkali metal cations (Group 1, such as ) and all nitrate salts () are soluble in water. Therefore, remains dissociated as spectator ions.
- (Lead(II) iodide): Most halide salts (chlorides, bromides, and iodides) are water-soluble, with notable exceptions including salts of , , and . Because lead(II) is an exception, lead(II) iodide has very low solubility.
Therefore, a precipitate forms, and its chemical formula is .
Part (b): Writing the Balanced Net Ionic Equation
- Overall balanced molecular equation:
- Complete ionic equation: Write all strong, soluble electrolytes in dissociated ionic form:
- Net ionic equation: Cancel the spectator ions ( and ) present unchanged on both sides:
Part (c): Calculating the Theoretical Yield
Step 1: Calculate the initial moles of each reacting ion.
- Moles of :
- Moles of :
Step 2: Determine the limiting reactant. From the balanced net ionic equation, the required molar ratio is:
Check the ratio of available moles:
The reactants are present in exact stoichiometric proportions. Therefore, both reactants are completely consumed in the precipitation reaction.
Step 3: Calculate the theoretical yield of . The stoichiometric ratio gives:
Convert moles of precipitate to mass in grams using its molar mass ():
Typical errors
01 The student ignores the 1:2 stoichiometric ratio between Pb²⁺ and I⁻ and assumes a 1:1 reaction, incorrectly identifying iodide as the limiting reactant and halving the theoretical yield.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You correctly calculated the moles of as , but you crossed out the correct initial calculation of for and altered it to .
- Step 4Correct
Because you adjusted the available amount of and divided by the stoichiometric factor of again, you obtained of instead of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that lead(II) iodide precipitates based on solubility exceptions.
You wrote the accurate, balanced net ionic equation with appropriate charges and state symbols.
You correctly calculated the moles of lead(II) ions from molarity and volume.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou initially wrote the correct quantity for , but crossed it out.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou conflated the initial moles delivered by the solution () with the stoichiometric mole ratio needed for the reaction. Because and react in a ratio, the available of and of are in exact stoichiometric balance, yielding of .
REASONING PATH
Your ACEpath teacher’s suggested approach- Separate Initial Moles from Stoichiometric Ratio
Calculate available moles of each reactant strictly from before comparing them using the chemical equation.
Keep as the actual amount of iodide present.
- Determine Limiting Reactant by Mole-to-Coefficient Ratio
Compare for each reactant: the smaller value is limiting.
Compute for and for ; since they are equal, neither reactant is in excess.
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate available moles: and .
Compare with the balanced equation : requires .
Since exactly is provided, both reactants are fully consumed, forming .
Multiply moles by molar mass: .
4.61
02 The student forgets to convert milliliters to liters when calculating moles, resulting in quantities that are three orders of magnitude too large.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You calculated moles using volume in milliliters rather than liters. Because molarity is defined as , multiplying by yields millimoles (), not moles.
- Step 4Correct
Your stoichiometric reasoning and conversion from moles to mass were methodologically sound, but the final answer of is off by a factor of due to the earlier unit error.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that lead(II) iodide is insoluble and wrote the correct chemical formula .
You wrote a fully balanced net ionic equation with accurate aqueous and solid state symbols.
You recognized the stoichiometric ratio between and and correctly used the molar mass to find the mass.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated volume in milliliters as liters when applying the molarity formula , overlooking that molarity () has units of . Multiplying milliliters directly gives millimoles (), which must be converted to moles () before multiplying by molar mass in .
REASONING PATH
Your ACEpath teacher’s suggested approach- Molarity Definition and Volume Units
. When volume is given in , convert to liters first: .
Always write out the units explicitly in your calculation setup: .
- Sense Check on Chemical Quantities
A beaker of dilute aqueous solution cannot produce kilograms of precipitate.
Check your final numerical magnitude against the scale of the experiment: () is physically impossible for a total reaction mixture.
CORRECTED PATH
ACEpath Teacher's DemonstrationSince the stoichiometric ratio is , both ions react completely:
03 The student writes a molecular or full non-ionic equation instead of the requested net ionic equation.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
Yes, a precipitate forms. Formula:
- Step 2Correct
You wrote the complete balanced molecular equation instead of the net ionic equation. A net ionic equation must show only the ions actively participating in forming the solid precipitate, omitting spectator ions ( and ).
- Step 3
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used solubility rules to determine that lead(II) iodide is insoluble.
You calculated initial moles and mole ratios accurately.
You found the exact theoretical yield with appropriate units.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou solved for the complete molecular equation instead of removing the spectator ions to provide the net ionic equation.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the definitions of molecular, complete ionic, and net ionic equations. A molecular equation keeps compounds neutral, whereas a net ionic equation cancels out spectator ions and shows only the species directly forming the precipitate.
REASONING PATH
Your ACEpath teacher’s suggested approach- Equation Types Distinction
Molecular equations display full formulas; complete ionic equations dissociate all soluble strong electrolytes into ions; net ionic equations cancel spectator ions.
Always check whether the prompt asks for 'molecular', 'total/complete ionic', or 'net ionic'. When asked for 'net ionic', cross out ions that remain aqueous and unchanged on both sides.
CORRECTED PATH
ACEpath Teacher's DemonstrationDissociate all soluble strong electrolytes into aqueous ions:
Cancel out the spectator ions ( and ) appearing unchanged on both sides:
(a) Precipitate forms: ; (b) ; (c)
Lock it in
When finding the limiting reactant from solution volumes and molarities, what must you calculate first before looking at the reaction coefficients?
Calculate the actual moles of each dissolved ion present using . Do not alter these initial mole amounts by the stoichiometric coefficients.
Similar question
A solution of is mixed with of . Write the balanced net ionic equation and calculate the theoretical yield of in grams. (Molar mass of )
Answer
Net ionic equation: . Initial moles: ; . The molar ratio is exact (), so both are consumed. Yield: , .
An aqueous mixture is prepared by combining of with of . Determine the limiting reactant and calculate the mass of barium phosphate, , formed. (Molar mass of )
Answer
Net ionic equation: . Initial moles: ; . Test ratio: , so is limiting. Yield: ; .
A sample of is mixed with of . (a) Identify the limiting reactant for precipitation of . (b) Calculate the theoretical yield of precipitate in grams and the concentration of excess chloride ions remaining in solution after precipitation. (Molar mass of )
Answer
(a) ; . Since has a ratio, is limiting. (b) Yield of . Excess . Total volume . .