Resources
The reversible gas-phase dissociation of dinitrogen tetroxide to nitrogen dioxide is given by with an equilibrium constant at . In an initial equilibrium state inside a variable-volume cylinder, the total pressure is and the degree of dissociation is . If the piston is pushed inward to compress the gas mixture until the new equilibrium total pressure reaches at constant temperature (), determine the new equilibrium degree of dissociation of , and state whether this shift is consistent with Le Châtelier's principle.
Answer and steps
Final answer
(or ), which demonstrates a shift left toward the side with fewer gas moles (from to ), fully consistent with Le Châtelier's principle.
Steps
Express Equilibrium Partial Pressures in Terms of Degree of Dissociation ()
Consider the dissociation reaction:
Let the initial amount of be . At equilibrium, if a fraction dissociates:
- Moles of
- Moles of
- Total moles of gas
Using Dalton's Law, the partial pressure of each gas under a total pressure is:
Formulate the Equilibrium Constant Expression ()
Substitute the partial pressures into the expression for :
Calculate the New Degree of Dissociation () at
Because temperature remains constant at , the equilibrium constant does not change ().
Substitute and into the expression:
Multiply both sides by and collect like terms:
Evaluate with Le Châtelier's Principle
- Observation: As the total pressure increases from to , the degree of dissociation drops from () to ().
- Principle: Increasing pressure by compressing the system causes the equilibrium to shift in the direction that decreases the total number of moles of gas to counteract the imposed stress.
- The forward reaction produces of gas from of gas (). Therefore, increasing the pressure drives the system to the left (favoring the reactant ), which reduces .
Thus, the decrease in is entirely consistent with Le Châtelier's principle.
Typical errors
01 The student forgets to square the stoichiometric coefficient of NO2 in the numerator of Kp, writing 2α² or 2α instead of (2α)² = 4α².
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
When you square the partial pressure of , you must square the entire numerator term: , not .
- Step 2Correct
Your algebraic rearrangement was carried out correctly, but the numerical answer is incorrect because it used the erroneous factor from the previous step.
- Step 3
Since decreases from to , the equilibrium shifted toward reactants. This is consistent with Le Châtelier's principle because higher pressure favors fewer moles of gas.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly wrote the initial equilibrium expression in terms of partial pressures: .
You accurately solved the resulting equation for using sound algebraic steps.
You correctly applied Le Châtelier's principle to explain why an increase in total pressure shifts the equilibrium toward the side with fewer moles of gas.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote instead of squaring both the coefficient and the variable, which should yield .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisFailing to place parentheses around grouped terms when substituting an expression with a stoichiometric coefficient into a power leads to squaring only the variable rather than the entire term .
REASONING PATH
Your ACEpath teacher’s suggested approach- Square the Entire Grouped Term
When a partial pressure contains a coefficient , such as , squaring that pressure gives .
Always place parentheses around the mole fraction term before applying the power: .
CORRECTED PATH
ACEpath Teacher's Demonstration(or ) and the shift toward the reactant is consistent with Le Châtelier's principle.
02 The student omits the total pressure factor P from the expression for Kp, confusing mole fractions with partial pressures.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You omitted the total pressure from the equilibrium constant expression. Because partial pressure is mole fraction times total pressure (), squaring the partial pressure of introduces a factor of in the numerator that does not cancel.
- Step 2Correct
Your algebra was executed correctly for your equation, but the calculation was affected by the missing total pressure term .
- Step 3
The degree of dissociation increased from to , which means more formed. This is inconsistent with Le Châtelier's principle, which predicts that an increase in pressure should shift the reaction toward fewer moles of gas.
CorrectThe degree of dissociation decreases from to , which shows a net shift toward reactants (fewer gas moles). This decrease is consistent with Le Châtelier's principle.
You stated the rule of Le Châtelier's principle correctly, but because your calculated was falsely higher than , you incorrectly concluded that the system contradicted the principle.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly stated that an increase in total pressure shifts equilibrium toward the side with fewer gas moles.
You solved your algebraic equation for with accurate arithmetic.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou used the mole-fraction ratio in place of the partial-pressure equilibrium constant , leaving out the total pressure factor.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing partial pressures with mole fractions when setting up . When , , so total pressure must remain explicitly in the equilibrium equation.
REASONING PATH
Your ACEpath teacher’s suggested approach- Include Total Pressure in Dalton's Law
For any gas , .
Always write out each partial pressure with before squaring or multiplying terms into .
- Check the Net Change in Gas Moles
The dimensional relationship is , where .
Since , verify that a net factor of is present in the final expression.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the partial pressures: and .
Substitute into : .
Substitute and : .
Rearrange: .
Solve for : .
(), and the decrease from to is fully consistent with Le Châtelier's principle.
03 The student forgets that the total number of moles at equilibrium is (1 + α) and assumes the total moles remain 1, writing P(NO2) = 2α·P and P(N2O4) = (1 - α)·P.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You treated the individual mole quantities as mole fractions, assuming the total moles remained . Because dissociation produces additional gas molecules, the total equilibrium amount is , which must appear in the denominator of each partial pressure expression.
- Step 2Correct
You carried out the algebra and quadratic formula correctly based on your equation, but the missing factor changed the denominator from to , leading to an incorrect value for .
- Step 3
Because decreases from to , fewer moles of gas are produced. This is consistent with Le Châtelier's principle because increasing pressure drives the reaction toward the side with fewer gas molecules.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly set up the equilibrium constant expression in terms of partial pressures.
You solved your resulting quadratic equation accurately.
You correctly explained the qualitative direction of the equilibrium shift using Le Châtelier's principle.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou equated mole fraction directly to individual moles without dividing by the total moles at equilibrium.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking the variable total number of moles in a dissociation reaction when converting stoichiometric amounts into partial pressures via Dalton's law ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Always calculate total equilibrium moles first
. For , .
Sum all equilibrium mole quantities explicitly before writing Dalton's law expressions.
- Verify Dalton's law structure
, never unless .
Ensure the denominator of each partial pressure term contains before substituting into .
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up using proper partial pressures: .
Substitute and : .
Clear the denominator: .
Solve for : .
(or ), consistent with Le Châtelier's principle.
Lock it in
When substituting an equilibrium mole term into a squared partial pressure expression , what is the correct numerator?
. Remember to square both the coefficient and the variable.
Similar question
For the gas-phase reaction at total pressure starting with pure , express in terms of the degree of dissociation and total pressure .
Answer
. Each product has mole fraction , while has mole fraction , giving .
For the reaction , at . Calculate the degree of dissociation when the total pressure is .
Answer
. Using : .
Consider the dissociation starting from pure with degree of dissociation . Express in terms of and total pressure .
Answer
. Equilibrium moles are for , for , and for (total moles ). Then .