Resources
In marine corrosion, an iron hull plate is exposed to ocean water (, , dissolved partial pressure ). The reduction of dissolved oxygen follows: , with standard reduction potential . Iron corrodes according to (). If the local concentration of ferrous ions at the hull boundary layer is , calculate the non-standard overall cell potential driving the spontaneous corrosion of iron under these exact environmental conditions.
Answer and steps
Final answer
Steps
Formulate the Overall Electrochemical Reaction
Corrosion operates as a galvanic cell with distinct anodic (oxidation) and cathodic (reduction) half-reactions:
- Cathode (reduction of dissolved oxygen):
- Anode (oxidation of iron):
Multiplying the oxidation half-reaction by balances the number of transferred electrons ():
Determine the Standard Cell Potential ()
Using standard reduction potentials:
Calculate the Reaction Quotient ()
From the water autoionization relation at ():
Pure solids () and liquids () have unit activity (). The reaction quotient expression is:
Substitute the given values (, , and ):
Apply the Nernst Equation
At , the cell potential is given by:
Substitute , , and :
The extremely low concentrations of dissolved ions in ocean water drive , significantly increasing the potential above standard conditions to and strongly favoring spontaneous hull corrosion.
Typical errors
01 The student uses n = 2 in the Nernst equation based on the oxidation half-reaction of iron rather than the 4 electrons transferred in the balanced overall reaction.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
2 + 2 + 22 2^{2+} + 4^- E^{} = 0.401 - (-0.440) = 0.841
- Step 2
= 14.00 - 8.10 = 5.90 [^-] = 10^{-5.90} = 1.26 10^{-6}
- Step 3
Q = = = 7.88 10^{-31}
- Step 4
n = 2
Correctn = 4
The value of in the Nernst equation must match the total number of moles of electrons transferred in the balanced overall reaction. Because moles of each lose , a total of electrons are transferred (), which also matches the consumed by .
- Step 5
E_{} = 0.841 - \log(7.88 10^{-31}) E_{} = 0.841 + 0.890 = +1.731
CorrectE_{} = 0.841 - \log(7.88 10^{-31}) 0.841 + 0.459 = +1.300_
Using doubled the correction term from to , leading to an overestimated cell potential.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly balanced the full redox equation by combining the iron oxidation and oxygen reduction half-reactions.
You calculated the standard cell potential accurately.
You correctly converted to and determined the reaction quotient .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou selected from the individual single-atom oxidation half-reaction () rather than from the total moles of electrons transferred in the balanced overall reaction that defines .
REASONING PATH
Your ACEpath teacher’s suggested approach- Matching n to the Overall Balanced Equation
In the Nernst equation , and the exponents in must correspond to the exact same balanced chemical equation.
Always verify that equals the total electrons exchanged after multiplying the half-reactions to make electrons cancel.
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify total electrons transferred: , so .
Substitute into the Nernst equation: .
Evaluate the correction term: (or using unrounded ).
Add to : .
02 The student miscalculates the reaction quotient by using [H+] = 10^(-8.10) M instead of finding [OH-] from pOH for the alkaline oxygen reduction reaction.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You calculated instead of . Because , gives the hydronium ion concentration. To find at , first find .
- Step 3Correct
Your reaction quotient expression correctly includes the species raised to their stoichiometric coefficients, but your numerical value is off due to the earlier error.
- Step 4Correct
You executed the Nernst calculation steps cleanly, but the propagated value of resulted in an overestimate of the final cell potential.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly combined the oxidation and reduction half-reactions to obtain the balanced overall reaction and identified .
You correctly computed the standard cell potential as .
You properly formulated the reaction quotient expression with correct stoichiometric powers.
You correctly applied the Nernst equation formula.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou substituted the solution's directly as the exponent for hydroxide concentration () rather than converting to first.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing and when converting from given pH values in basic or alkaline half-reactions.
REASONING PATH
Your ACEpath teacher’s suggested approach- Check the Identity of the Basic Ion
and ; at , .
Whenever a reaction quotient contains and you are given , calculate before calculating .
CORRECTED PATH
ACEpath Teacher's DemonstrationFind at : .
Compute hydroxide ion concentration: .
Calculate the reaction quotient: , giving .
Apply the Nernst equation: .
03 The student forgets to square the [Fe2+] concentration in the reaction quotient expression when balancing the overall reaction.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
2 + + 2 2 + 4 E^{} = 0.401 - (-0.440) = 0.841 n = 4
- Step 2
= 14.00 - 8.10 = 5.90 [] = 10^{-5.90} = 1.26 10^{-6}
- Step 3
Q = = = 3.15 10^{-27}
CorrectQ = = 7.87 10^{-31}
Because the balanced equation has a coefficient of in front of , its concentration must be squared in the reaction quotient: rather than .
- Step 4
E_{} = 0.841 - \log(3.15 10^{-27}) = 0.841 - 0.01479 (-26.50) = +1.233_
CorrectE_{} = 0.841 - \log(7.87 10^{-31}) +1.300_
Your execution of the Nernst equation formula was mathematically sound, but the final numerical value was shifted due to the missing square on in Step 3.
WHAT YOU DID WELL
Compliments from Your TeacherYou balanced the four-electron redox reaction between iron and dissolved oxygen correctly.
You calculated the standard potential using cathodic and anodic values accurately.
You correctly derived from the given environmental .
You correctly set up and applied the Nernst equation formula at .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou correctly balanced in the overall reaction, but wrote with an implicit power of instead of squaring it in .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking that every stoichiometric coefficient in the balanced chemical equation becomes the power of that species' activity in the mass-action expression for .
REASONING PATH
Your ACEpath teacher’s suggested approach- Match Exponents to Balanced Coefficients
For a general reaction , the reaction quotient is .
Always circle or highlight each product and reactant coefficient in the overall reaction before writing the algebraic expression for .
CORRECTED PATH
ACEpath Teacher's DemonstrationSquare the ferrous ion concentration to match its coefficient of : .
Substitute values: .
Compute the logarithm: (or directly, ).
Calculate .
Lock it in
In the Nernst equation , what does the quantity represent?
is the total moles of electrons transferred in the balanced overall reaction used to write (not just one half-reaction).
Similar question
A galvanic cell consists of at . Given and , state the value of and calculate .
Answer
, . Key steps: Overall reaction is (). . . Thus , giving .
An aluminum-air battery operates via with . What is the value of for this overall balanced equation, and what is the Nernst prefactor ?
Answer
, prefactor . Key steps: Each loses , so lose total (). .
Under acidic conditions, iron corrodes via (). If , , and at , calculate using the correct value of .
Answer
. Key steps: because . . . .