Resources
In a collegiate physical chemistry laboratory, a student standardizes a freezing-point osmometer using pure benzene (, ). A non-volatile organic acid is synthesized and purified. The student dissolves of the solid acid into of benzene in a double-walled cryoscopic cell. The freezing point of the mixture is measured with a calibrated Beckmann differential thermometer and recorded as . In a subsequent non-aqueous neutralization titration, of the pure acid requires of for complete neutralization. Using the cryoscopy data, calculate the experimental molar mass of the solute in benzene, determine the equivalent mass per ionizable proton from the titration, and explain whether the acid exists as a monomer or a dimer in non-polar benzene.
Answer and steps
Final answer
Cryoscopic Molar Mass ; Neutralization Equivalent Mass ; Solute exists primarily as a monomer in benzene (accounting for experimental uncertainty, ratio vs dimer expected )
Steps
Calculate the Cryoscopic Molar Mass of the Acid
The freezing point depression of a solution, , is directly proportional to its molal concentration :
Substitute the measured temperatures:
Solve for the molality of the solute particles:
Using the mass of the solvent (benzene), , calculate the number of moles of dissolved solute particles:
The apparent experimental molar mass () of the solute in benzene is:
Determine the Neutralization Equivalent Mass
At the equivalence point in the non-aqueous neutralization titration:
Calculate the chemical amount of base consumed:
The equivalent mass (), defined as the mass of acid providing one mole of ionizable protons, is:
Determine the Association State (Monomer vs. Dimer)
-
Theoretical Expectation for Association:
- If the acid is monoprotic, its true monomer formula mass is equal to its equivalent mass:
- Carboxylic acids often dimerize in non-polar solvents like benzene via dual hydrogen bonds (). If complete dimerization occurred, the cryoscopically determined apparent molar mass would be:
-
Comparison with Experimental Data:
- The measured cryoscopic molar mass is .
- Comparing this value to the expected monomer mass gives a ratio:
- This value is close to (monomer) within typical collegiate laboratory error, and is nowhere near the expected value for a dimer ().
Therefore, the solute exists predominantly as a monomer in benzene under these conditions.
Typical errors
01 The student forgets to convert the mass of benzene from grams to kilograms when calculating molality, obtaining an apparent molar mass that is three orders of magnitude too small.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
Because molality is defined per kilogram of solvent, you must convert of benzene to before multiplying by molality.
- Step 3Correct
Your formula is correct, but the result was three orders of magnitude too low due to using instead of .
- Step 4
- Step 5
The experimental molar mass of is much smaller than , which does not match a monomer or dimer.
Correct, which is consistent with a monomer (close to ) rather than a dimer ().
With the corrected molar mass of , the ratio to the monomer equivalent mass of is , which indicates that the solute exists primarily as a monomer rather than a dimer.
WHAT YOU DID WELL
Compliments from Your TeacherYou found the freezing point depression accurately from the measured temperatures.
You correctly used the cryoscopy formula relating depression to molality.
You performed the titration stoichiometry and calculated the equivalent mass correctly.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou used the solvent mass directly in grams () instead of converting to kilograms () when finding solute moles from molality.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the unit basis of molality () with per-gram concentration, leading to an overestimation of solute moles by a factor of 1000.
REASONING PATH
Your ACEpath teacher’s suggested approach- Check Molality Base Units
, with units .
Always convert solvent mass from grams to kilograms () before applying .
- Evaluate Reasonable Molar Mass
Stable organic compounds typically have molar masses between and several hundred .
If your molar mass comes out below , immediately inspect your unit conversions for a factor of 1000.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert benzene mass to kilograms: .
Calculate moles of solute: .
Find apparent molar mass: .
Compare with equivalent mass: is close to (ratio ) and far below a dimer ().
The experimental cryoscopic molar mass is , the equivalent mass is , and the acid exists primarily as a monomer in benzene.
02 The student expects carboxylic acids to always dimerize via intermolecular hydrogen bonding in non-polar solvents and claims the acid exists as a dimer regardless of the numerical evidence.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
Because benzene is non-polar, carboxylic acids form hydrogen-bonded pairs, so the acid exists as a dimer.
CorrectYou applied a theoretical generalization about carboxylic acids in non-polar solvents without checking your experimental numbers. A dimer would have an apparent molar mass of approximately , whereas your experimental cryoscopic mass () is close to the monomer mass ().
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the freezing point depression and the solution molality.
You correctly determined the cryoscopic molar mass of the solute as approximately .
You accurately computed the neutralization equivalent mass of from the titration data.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou relied on a qualitative heuristic (that carboxylic acids dimerize in non-polar solvents) instead of evaluating the ratio between your experimentally measured colligative molar mass and the monomer equivalent mass.
REASONING PATH
Your ACEpath teacher’s suggested approach- Comparing Apparent Molar Mass to Monomer Mass
Colligative properties measure the total number of independent solute particles in solution. For an association equilibrium , the apparent molar mass is . If the solute is predominantly a monomer, ; if fully dimerized, .
Always compute the ratio to see whether it is near (monomer), near (dimer), or an intermediate value before drawing a qualitative conclusion.
CORRECTED PATH
ACEpath Teacher's DemonstrationCompare the measured cryoscopic molar mass () to the equivalent mass ().
Assuming the acid is monoprotic, its monomer molar mass is . If it dimerized, the expected apparent molar mass would be .
Calculate the experimental association factor: . Because this value is close to within experimental error and far from , the solute exists primarily as a monomer.
Cryoscopic Molar Mass (or ); Neutralization Equivalent Mass ; The acid exists predominantly as a monomer in benzene.
03 The student calculates the ratio of molar mass to equivalent mass in reverse or misinterprets dimerization as halving the apparent molar mass instead of doubling it.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
120 60 98.9 120
Correct(2 120 = 240) 98.9 120 240,
When molecules dimerize (), two monomer molecules bind together to form a single larger particle. Because apparent molar mass is total mass divided by the number of solute particles, dimerization doubles the apparent molar mass to rather than halving it. Because is close to the monomer value () and far from , the acid is predominantly a monomer.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used colligative freezing point depression to calculate the apparent cryoscopic molar mass.
You correctly used the neutralization titration stoichiometry to calculate the equivalent mass of the acid.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused the halving of particle count with the halving of molar mass. In colligative property measurements, apparent molar mass is defined as mass divided by particle moles (). When solute molecules associate into dimers, the number of particles is cut in half for a fixed mass, which doubles the apparent molar mass.
REASONING PATH
Your ACEpath teacher’s suggested approach- Association vs. Apparent Molar Mass
For an association , the apparent particle mass is .
Always multiply the monomer mass by the degree of association to find the expected dimer or oligomer molar mass.
- Colligative Counting Principle
Colligative properties depend directly on particle concentration (), while molar mass is inversely proportional to molality ().
Check that lower freezing point depression means fewer particles, which indicates a larger apparent molar mass.
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify the monomer mass from the titration: for a monoprotic acid, .
Determine the expected dimer mass: two monomer units combine into one particle, so .
Compare the experimental value: .
Evaluate proximity: , which is consistent with experimental laboratory error around a monomer value of , and nowhere near .
The experimental cryoscopic molar mass is , the equivalent mass is , and the acid exists primarily as a monomer in benzene.
Lock it in
What are the standard SI-derived units of molality (), and what mass unit must the solvent have?
Molality has units of . The solvent mass must always be expressed in kilograms (), never grams.
Similar question
A solution contains of an unknown solute dissolved in of camphor (). The freezing point depression is . Calculate the molar mass of the solute.
Answer
- Molality .\n2. Solvent mass in kg: .\n3. Solute moles: .\n4. Molar mass: .
Benzoic acid () is dissolved in benzene. A solution prepared by dissolving of benzoic acid in of benzene () gives a freezing point depression of . Calculate the apparent experimental molar mass and determine the degree of dimerization .
Answer
- .\n2. Moles of particles: .\n3. Apparent molar mass: .\n4. Van 't Hoff factor: .\n5. Dimerization equilibrium (): (or dimerized).
An unknown diprotic organic acid is analyzed. Titrating of the acid requires of to reach the second equivalence point. Cryoscopic analysis of of the acid in of solvent () produces . Determine the theoretical monomer molar mass and state whether the acid undergoes association or dissociation in this solvent.
Answer
- Titration: Moles . Since has 2 protons, . True monomer molar mass .\n2. Cryoscopy: . Solvent mass . Solute moles . Apparent molar mass .\n3. Since , the acid neither associates nor dissociates; it exists as an intact monomer in the solvent.