Resources
Consider the unbalanced chemical equation for the reduction of solid iron(III) oxide by carbon monoxide gas to produce solid iron and carbon dioxide gas: After balancing the equation with the lowest whole-number integer coefficients, determine the molar ratio of reducing agent consumed to metallic iron produced, expressed as the simplified fraction .
Answer and steps
Final answer
Steps
Identify the reducing agent and product of interest
In a redox reaction:
- The species that loses electrons (whose oxidation state increases) acts as the reducing agent.
- In , carbon has an oxidation state of . In , carbon has an oxidation state of . Because carbon is oxidized, is the reducing agent, so its stoichiometric coefficient is .
- The metallic iron produced is , with stoichiometric coefficient .
Balance the chemical equation
Write out the unbalanced equation:
- Balance iron ():
There are iron atoms in each formula unit of . Setting requires: - Balance carbon () and oxygen ():
Each carbon monoxide () molecule removes one oxygen atom from to form one carbon dioxide () molecule. Since each contains oxygen atoms, molecules of are required to remove them: -
Verify atom counts:
- : on the left; on the right.
- : on the left; on the right.
- : on the left; on the right.
The balanced chemical equation with lowest whole-number integer coefficients is:
Thus, , , , and .
Calculate the molar ratio
The molar ratio of the reducing agent consumed () to metallic iron produced () is:
Typical errors
01 The student confuses the reducing agent with the oxidizing agent, calculating the ratio of Fe₂O₃ consumed to Fe produced as 1/2 instead of 3/2.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
The reducing agent is the reactant that is oxidized (loses electrons or gains oxygen). In this reaction, carbon in has its oxidation state increase from to in , making the reducing agent. Iron in is reduced from to , making the oxidizing agent.
- Step 3Correct
Because you selected instead of , you evaluated rather than .
WHAT YOU DID WELL
Compliments from Your TeacherYou balanced the redox reaction with the correct integer coefficients.
You correctly assigned each variable , , , and to its respective chemical species.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou swapped the definitions of oxidizing agent and reducing agent.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the substance that undergoes reduction with the reducing agent. The substance being reduced (gaining electrons, decreasing in oxidation state) is the oxidizing agent, whereas the substance being oxidized (losing electrons, increasing in oxidation state) causes reduction and is the reducing agent.
REASONING PATH
Your ACEpath teacher’s suggested approach- Agent vs. Process Rule
The reducing agent undergoes oxidation (its oxidation number increases); the oxidizing agent undergoes reduction (its oxidation number decreases).
Track oxidation numbers across the reaction: goes from to , so is oxidized and serves as the reducing agent.
CORRECTED PATH
ACEpath Teacher's DemonstrationDetermine oxidation states: in , is ; in , is . Since is oxidized, is the reducing agent with coefficient .
The metallic iron product is , with coefficient .
Compute the ratio: .
02 The student inverts the requested ratio to product over reactant, calculating c/b = 2/3 instead of b/c = 3/2.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You inverted the required ratio. The question asked for the ratio of reducing agent consumed to metallic iron produced (), which is , but you calculated .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly balanced the chemical equation with the lowest whole-number integer coefficients.
You correctly identified carbon monoxide as the reducing agent.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou swapped the numerator and denominator when setting up the requested ratio , calculating product over reactant instead of following the specified fraction order.
REASONING PATH
Your ACEpath teacher’s suggested approach- Target Ratio Setup
The ratio of to means .
Always write the named chemical species with units into the fraction before substituting numbers: .
CORRECTED PATH
ACEpath Teacher's DemonstrationState the required fraction definition from the prompt: .
Substitute the identified stoichiometric coefficients: and .
Write the simplified fraction: .
03 The student balances the equation incorrectly by equating the oxygen coefficients directly as 1:1 without accounting for the three oxygen atoms in Fe₂O₃, yielding a ratio of 1/2.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You balanced iron by setting the coefficient of to , but you did not balance oxygen. With and , there are oxygen atoms on the reactant side and only on the product side. Since each accepts one oxygen atom to become , reducing all oxygen atoms from requires , giving and .
- Step 2
- Step 3Correct
Your ratio calculation directly followed the formula , but because was incorrectly determined as instead of , your final ratio became instead of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly balanced the iron atoms by placing a coefficient of in front of .
You correctly identified carbon monoxide () as the reducing agent in this redox reaction.
You correctly set up the required ratio expression as .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou balanced iron and matched with in a ratio without counting the oxygen atoms originating from .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking that oxygen appears in more than one reactant compound, which requires tallying total oxygen atoms on both sides rather than matching directly to .
REASONING PATH
Your ACEpath teacher’s suggested approach- Check Total Oxygen Atom Inventory
Every element must have the exact same total atom count on both sides of the reaction arrow: .
Count all sources of an element on each side before concluding that an equation is balanced. For oxygen here, ensure .
- Use Oxygen Transfer Logic in Oxide Reduction
In the reduction of a metal oxide by carbon monoxide, each removes exactly one oxygen atom: .
Equate the moles of directly to the number of oxygen atoms in the metal oxide formula unit ( oxygen atoms in require ).
CORRECTED PATH
ACEpath Teacher's DemonstrationSet for , which gives to balance iron.
Count the oxygen atoms in : there are oxygen atoms to remove.
Because each absorbs oxygen atom to form , set and .
Verify the full atom balance: ; ; on both sides.
Compute the ratio: .
Lock it in
What is the relationship between the substance being oxidized and the reducing agent?
They are the same substance. The reactant that gets oxidized causes another species to be reduced, so it is the reducing agent.
Similar question
For the reaction , identify the reducing agent and determine the molar ratio of reducing agent consumed to water produced.
Answer
is the reducing agent because carbon is oxidized from to . The molar ratio of consumed to produced is .
Balance the reaction using the smallest whole-number coefficients. Identify the reducing agent and calculate the molar ratio of reducing agent to metallic iron produced.
Answer
The balanced equation is (). is oxidized from to , making the reducing agent. The ratio of reducing agent () to metallic iron () is .
In the blast-furnace reaction , determine the oxidation state change for carbon and for iron, identify the oxidizing and reducing agents, and find the ratio of moles of reducing agent consumed per mole of iron produced.
Answer
Carbon changes from in to in (oxidized, so is the reducing agent). Iron changes from an average of to (reduced, so is the oxidizing agent). The molar ratio of reducing agent () to metallic iron () produced is .