Resources
Ammonia reacts with oxygen gas in the Ostwald process according to the reaction: . In an industrial reactor, of reacts with excess . If the actual yield of nitric oxide () collected is , calculate the percent yield of for this reaction. (Molar masses: , ).
Answer and steps
Final answer
Steps
Find the moles of ammonia () reacted
To find the percent yield of nitric oxide (), we first determine the theoretical yield based on stoichiometry and then compare the actual yield to that theoretical maximum.
Using the given mass and molar mass of ammonia:
Determine the theoretical moles of produced
From the balanced chemical equation:
The stoichiometric mole ratio between and is:
Since oxygen is in excess, ammonia is the limiting reactant:
Calculate the theoretical mass of
Using the molar mass of ():
Calculate the percent yield
The percent yield is the ratio of actual yield to theoretical yield expressed as a percentage:
Substitute the given actual yield () and the calculated theoretical yield:
(Common Pitfall: Do not divide the actual mass by the mass of reactant . Percent yield always compares the actual amount of a product to the theoretical maximum amount of the same product.)
Typical errors
01 The student directly compares the given masses without converting to moles, treating mass as conserved directly between reactants and products to find theoretical yield.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Mass is not directly conserved on a 1:1 basis between different substances. You must convert grams of reactant to moles, use the mole ratio from the balanced equation to find moles of product , and then convert moles of to grams using its molar mass ().
- Step 2Correct
Your percent yield equation set up the ratio of actual yield to theoretical yield correctly, but substituting the incorrect theoretical yield produced an impossible yield greater than .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the actual yield of as .
You used the general percent yield formula comparing actual yield to theoretical yield.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeAssuming that of directly forms of without accounting for molar masses or the mole bridge.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou bypassed the fundamental rule of stoichiometry: chemical reactions relate quantities of substances through moles, not directly through grams. Because and have different molar masses ( vs. ), one gram of reactant does not equal one gram of product.
REASONING PATH
Your ACEpath teacher’s suggested approach- The Mole Bridge Rule
You cannot jump directly from mass of reactant to mass of product without passing through moles.
Always convert: .
- Sanity Check for Percent Yield
In standard chemical reactions without continuous input or impurities, percent yield cannot exceed .
If your calculated yield is , recheck your theoretical yield calculation to ensure you found the theoretical maximum of the correct product substance.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert given mass of to moles: .
Use the balanced equation to find theoretical moles of : .
Convert moles of to theoretical mass: .
Calculate percent yield: .
02 The student multiplies the molar mass by the stoichiometric coefficient 4 when calculating moles from grams, incorrectly inflating the effective molar mass.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Molar mass is an intensive physical property of a substance ( for ). Do not multiply the molar mass by the stoichiometric coefficient from the balanced equation when converting mass to moles. Coefficients are used only in mole-to-mole ratios between different substances.
- Step 2Correct
You correctly recognized the (or ) mole ratio between and , but your value is affected by the incorrect mole quantity from Step 1.
- Step 3Correct
Your method of multiplying moles by the molar mass of is correct, but your calculation carries forward the incorrect mole amount.
- Step 4Correct
You correctly set up the formula , but the result was distorted by the understated theoretical yield.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the stoichiometric mole ratio between and .
You correctly multiplied moles by the molar mass of to find theoretical mass.
You correctly set up the percent yield ratio as actual yield divided by theoretical yield.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou included the reaction coefficient inside the molar mass conversion factor.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou conflated the intensive property of molar mass (mass per single mole of a substance) with the stoichiometric coefficients of the balanced equation. Coefficients dictate the ratio of moles reacting, never the mass of a single mole.
REASONING PATH
Your ACEpath teacher’s suggested approach- Molar Mass vs. Stoichiometric Coefficients
Molar mass () depends solely on the chemical formula of the compound: . Never multiply by the balancing coefficient.
Calculate moles using strictly . Reserve coefficients exclusively for the mole-to-mole bridge step.
- Sanity Check for Percent Yield
In standard stoichiometry problems without impure products, percent yield cannot exceed .
If your calculated percent yield is over , pause immediately to check whether your theoretical yield was underestimated.
CORRECTED PATH
ACEpath Teacher's Demonstration03 The student inverts the percent yield formula by dividing theoretical yield by actual yield instead of actual by theoretical.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You placed the theoretical yield in the numerator and the actual yield in the denominator. Percent yield measures what you actually obtained relative to the theoretical maximum, so actual yield must be in the numerator.
WHAT YOU DID WELL
Compliments from Your TeacherYou converted the starting mass of ammonia to moles with correct significant figures.
You used the stoichiometric mole ratio from the balanced equation to find the theoretical yield of nitric oxide.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou accidentally placed the larger theoretical yield on top instead of evaluating .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the part (actual yield obtained in the lab) with the whole (theoretical maximum predicted by stoichiometry) in the percentage formula.
REASONING PATH
Your ACEpath teacher’s suggested approach- Define Percent Yield
Always place what was obtained in the experiment (actual yield) on top and the stoichiometric limit (theoretical yield) on the bottom.
- Reasonableness Check
Unless a product contains unremoved impurities or moisture, actual yield cannot exceed theoretical yield.
If your calculated percent yield exceeds , verify whether you flipped the numerator and denominator.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the percent yield formula with actual yield in the numerator: .
Substitute for actual yield and for theoretical yield: .
Compute the ratio: .
Lock it in
Why can you never directly set the theoretical yield of a product equal to the initial mass of a reactant?
Molecules react in mole ratios, not gram ratios. Different substances have different molar masses, so mass must be converted through moles.
Similar question
For the reaction , if of reacts with excess to produce of , what is the percent yield? (Molar masses: , ).
Answer
. Moles of . From the mole ratio (), theoretical moles of . Theoretical mass of . Percent yield .
In the reaction , of reacts with excess . If of is collected, calculate the percent yield. (Molar masses: , ).
Answer
. Moles of . Mole ratio of to is , so theoretical moles of . Theoretical yield . Percent yield .
A student decomposes of according to . If of is obtained, what is the percent yield of ? (Molar masses: , ).
Answer
. Moles of . Theoretical moles of ( ratio). Theoretical mass of . Percent yield (or ).