Resources
In an analytical chemistry laboratory, a student standardizes a solution of iron(II) sulfate (, containing solvated ions) via a redox titration against an acidified standard solution of potassium permanganate (). During the titration, electron transfer occurs between the analyte and titrant ions according to the unbalanced half-reactions:
(a) Write the balanced overall net ionic equation for the electron-transfer process in acidic aqueous solution. (b) If exactly of a titrant solution is required to reach the permanent faint pink endpoint of a aliquot of the solution, calculate the molar concentration of ions in the original sample. (c) Identify the stoichiometric mole ratio of electron donor (reducing agent) to electron acceptor (oxidizing agent) in this titration.
Answer and steps
Final answer
(a) Multiplying the oxidation half-reaction by and adding gives: . (b) Moles of consumed: . From the stoichiometry, moles of oxidized: . The molarity of is . (c) The stoichiometric ratio of electron donor () to electron acceptor () is .
Steps
Part (a): Balancing the Redox Equation via Electron Transfer
A balanced redox equation requires both mass balance (equal numbers of each type of atom) and charge balance (equal numbers of electrons lost and gained).
-
Identify the half-reactions:
- Oxidation half-reaction (electron loss): Each ion loses electron to form an ion.
- Reduction half-reaction (electron gain): Each permanganate ion, , gains electrons.
- Equalize the number of electrons transferred: Because the reduction half-reaction consumes electrons, the oxidation half-reaction must be multiplied by so that all electrons released are accounted for:
-
Combine and cancel spectator electrons: Adding the two half-reactions together:
Canceling the from both sides yields the balanced net ionic equation:
Part (b): Calculating the Concentration of
-
Calculate the amount (moles) of titrant used: Convert the volume of titrant from milliliters to liters:
Using the definition of molarity ():
- Use the stoichiometric mole ratio to find moles of : From the balanced equation, of reacts with of :
- Calculate the molar concentration of in the aliquot: The aliquot volume is :
Common Pitfall: A frequent mistake is using directly without adjusting for stoichiometry. Always multiply by the stoichiometric mole ratio () when relating titrant and analyte.
Part (c): Stoichiometric Ratio of Donor to Acceptor
- The electron donor is oxidized: each ion donates electron, acting as the reducing agent.
- The electron acceptor is reduced: each ion accepts electrons, acting as the oxidizing agent.
To balance total electrons transferred (), donor ions () are required for every acceptor ion (). Therefore, the stoichiometric mole ratio of electron donor to electron acceptor is:
Typical errors
01 The student assumes a 1:1 stoichiometric reaction ratio between titrant and analyte instead of multiplying by the 5:1 stoichiometric factor, leading to a concentration of 0.02329 M.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You assumed a stoichiometric ratio between and . According to your balanced equation from part (a), of reacts with of , so the moles of must be multiplied by .
- Step 4Correct
You correctly divided your calculated moles by the aliquot volume (), but the resulting concentration is incorrect due to the unmultiplied mole value from the previous step.
- Step 5
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly balanced the net ionic redox equation using the half-reaction method.
You calculated the exact amount of permanganate titrant used in moles.
You accurately identified the reducing agent, oxidizing agent, and their stoichiometric ratio.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou treated the equivalence point as instead of applying the mole ratio that you derived in part (a).
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConflating equimolar equivalence () with stoichiometric equivalence (). When transitioning from finding moles of titrant to analyte concentration, you bypassed the stoichiometric conversion factor from the balanced equation.
REASONING PATH
Your ACEpath teacher’s suggested approach- Titration Equivalence Rule
At the equivalence point of a reaction , the mole relationship is , or .
Always write the mole ratio conversion factor explicitly between calculating titrant moles and solving for analyte moles.
CORRECTED PATH
ACEpath Teacher's Demonstration02 The student inverts the 5:1 stoichiometric mole ratio by dividing by 5 instead of multiplying, calculating [Fe²⁺] as 0.004658 M.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
From the balanced equation, of reacts with of . To convert moles of to moles of , you must multiply by rather than dividing by .
- Step 4Correct
Your formula and volume substitution for concentration were set up correctly, but the numerical result was affected by the earlier mole calculation error.
- Step 5
WHAT YOU DID WELL
Compliments from Your TeacherYou balanced the net ionic redox equation with proper mass and charge balance.
You correctly calculated the moles of permanganate titrant used in the titration.
You correctly identified the reducing and oxidizing agents and stated their stoichiometric ratio of .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou recognized the relationship between iron(II) and permanganate, but you divided by instead of multiplying when converting titrant moles to analyte moles.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisInverting the stoichiometric conversion factor during titration dimensional analysis, confusing which species has the larger stoichiometric coefficient.
REASONING PATH
Your ACEpath teacher’s suggested approach- Set Up Dimensional Analysis with Units
Always write full units including chemical formulas: .
Cancel explicitly: .
- Perform a Reasonableness Check
Because of titrant reacts with of analyte, the moles of analyte present must be times greater than the moles of titrant consumed.
Check whether your calculated moles of analyte are greater than your moles of titrant before dividing by volume.
CORRECTED PATH
ACEpath Teacher's DemonstrationApply the mole ratio from the balanced equation: .
Divide by the sample volume: .
03 The student inverts the requested ratio order in part (c), stating the acceptor-to-donor ratio of 1 : 5 instead of donor to acceptor.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You correctly identified as the electron donor and as the electron acceptor, but you reversed the requested ratio order, giving acceptor to donor () instead of donor to acceptor ().
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly balanced the redox reaction by equalizing the electrons transferred between half-reactions.
You correctly carried out the stoichiometry and molarity calculation in part (b).
You correctly identified which species donates electrons and which species accepts electrons.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote the ratio as because you ordered the numbers as rather than the requested .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisThe question asked for the ratio of 'electron donor to electron acceptor' (), but your sentence listed first, leading you to write the stoichiometric coefficient of first.
REASONING PATH
Your ACEpath teacher’s suggested approach- Match the requested term order
When a question asks for the ratio of to , the numerical ratio must be written as .
Write down the formula of each role above the ratio before writing numbers: .
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify the stoichiometric coefficient of the electron donor (): .
Identify the stoichiometric coefficient of the electron acceptor (): .
Express the ratio strictly in the order requested (donor to acceptor): .
The stoichiometric mole ratio of electron donor to electron acceptor is .
Lock it in
In a titration governed by , what is the exact relationship between and at the equivalence point?
. Never assume unless the balanced coefficients are equal ().
Similar question
A aliquot of an acidified tin(II) solution containing is titrated with . The balanced reaction is . If the titration requires of titrant to reach the endpoint, calculate the molar concentration of .
Answer
. Key steps: . From the ratio, . Then .
An oxalic acid solution () is standardized against potassium permanganate according to: . A chemist titrates a solution with . What volume of solution is needed to completely react with of the oxalic acid solution?
Answer
. Key steps: . Using the stoichiometric ratio , . Finally, .
A sample of impure iron ore weighing is dissolved, and all iron is converted to . The resulting solution requires of to reach the equivalence point via: . Calculate the mass percentage of iron in the ore sample (molar mass of ).
Answer
. Key steps: . Moles of . Mass of . Mass percentage = .