Resources
For the dynamic equilibrium at , dynamic equilibrium requires that both forward and reverse rates are non-zero and balance each other. In an approximation analysis of the quadratic expression for , a chemist tests whether the initial concentration permits the simplification , where is the degree of dissociation of . If the threshold for validity of this approximation is defined strictly as (a maximum of dissociation), calculate the minimum initial concentration required in when .
Answer and steps
Final answer
Steps
Equilibrium Expression in Terms of Degree of Dissociation
For a dissociation reaction governed by equilibrium constant , let the initial concentration of reactant be and its degree of dissociation be ().
The equilibrium expression relating , , and is:
Condition for the Minimum Initial Concentration
According to Le Chatelier's principle (and Ostwald's dilution law), decreasing the initial concentration shifts the dissociation equilibrium toward greater dissociation, meaning increases as decreases.
To satisfy the validity criterion (), the initial concentration must be greater than or equal to a critical minimum value, , which occurs at the upper limit of the degree of dissociation:
Solving for
Rearranging the equilibrium equation to solve for :
Substitute the given values into the equation:
Common Pitfall: A frequent mistake is setting inside the equation used to find the boundary concentration itself, which would yield . To find the strict boundary where , the exact term must be retained.
Typical errors
01 The student prematurely uses the approximation 1 - α ≈ 1 in the denominator when calculating the threshold concentration [A]0, giving 0.0160 mol/L instead of 0.0152 mol/L.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You approximated while solving for the exact boundary concentration where . Because the threshold condition is evaluated exactly at the limit, you must retain rather than approximating it as .
- Step 3Correct
Your algebraic rearrangement and arithmetic were executed correctly, but the numerical result was skewed by omitting the factor of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly expressed the equilibrium concentrations of and using the initial concentration and degree of dissociation .
You correctly included the stoichiometric factor of when squaring the concentration of in the numerator.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the threshold condition as permission to simplify in the governing equation, rather than evaluating the exact boundary relation at .
REASONING PATH
Your ACEpath teacher’s suggested approach- Strict Boundary vs. General Approximation
When calculating the exact boundary value of a parameter defining a validity threshold (such as ), do not apply the approximation within the boundary equation itself.
Keep the exact expression and substitute to obtain .
CORRECTED PATH
ACEpath Teacher's DemonstrationRearrange the exact equilibrium expression for : .
Substitute and the threshold value : .
Evaluate the numerator and denominator: .
02 The student forgets to square the stoichiometric coefficient of 2 for B in the numerator, writing [B]² as [A]0α² or 2[A]0α² instead of 4[A]0²α², leading to an incorrect [A]0 of 0.0608 mol/L.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
When squaring , both the coefficient and the initial concentration must be squared, giving . Dividing by leaves , rather than .
- Step 3Correct
Your numerical substitution followed directly from the incorrect numerator in step 2.
- Step 4Correct
Because of the missing factor of in the denominator of the rearranged formula (or missing instead of in the numerator), your calculated minimum concentration is twice the correct value.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly defined the equilibrium concentrations in terms of and the degree of dissociation .
You correctly applied the threshold value without prematurely approximating .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou squared but did not square the coefficient or when expanding .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisForgetting that when substituting an equilibrium concentration term into the mass-action quotient.
REASONING PATH
Your ACEpath teacher’s suggested approach- Square the Entire Expression
If , then .
Always place parentheses around the entire species concentration before applying exponents in equilibrium expressions.
CORRECTED PATH
ACEpath Teacher's DemonstrationSubstitute with explicit parentheses: .
Substitute the boundary values and : .
Solve for : .
03 The student omits the stoichiometric factor of 2 when defining the equilibrium concentration of B, writing [B] = [A]0α instead of 2[A]0α, resulting in [A]0 = 0.0608 mol/L.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Because of dissociates to produce of , the change in is , making the equilibrium concentration rather than .
- Step 2Correct
Squaring the correct concentration yields . Dividing by leaves a factor of in the numerator.
- Step 3Correct
Your arithmetic and rearrangement were completely sound, but propagating the missing factor of resulted in being four times larger than the correct value.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly expressed the equilibrium concentration of reactant as .
You correctly preserved the exact term to find the boundary concentration rather than making an invalid simplification.
You executed the algebraic rearrangement and numerical division with complete precision.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou treated the production of as with the dissociated instead of multiplying by its stoichiometric coefficient of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking the mole ratio during the 'Change' row of an ICE table when converting from degree of dissociation to equilibrium concentrations. For a reaction , the consumed reactant forms of product, which contributes a factor of to the numerator of when raised to its stoichiometric power.
REASONING PATH
Your ACEpath teacher’s suggested approach- Stoichiometry in ICE Rows
For any species with stoichiometric coefficient , .
Write the balanced chemical equation directly above your concentration expressions and verify that the coefficient of each species multiplies the term.
- Power Rule in Equilibrium Constants
.
Ensure that the stoichiometric coefficient is enclosed inside the parentheses before squaring or raising to any power.
CORRECTED PATH
ACEpath Teacher's DemonstrationApply the mole ratio to find .
Substitute into : .
Substitute the boundary values and : .
Solve for : .
Lock it in
When finding the minimum initial concentration corresponding to a threshold , should you set ?
No. The threshold is an exact numerical boundary; substituting into gives , not .
Similar question
For the dissociation , the equilibrium expression is . If , find the exact minimum initial concentration such that .
Answer
For the weak acid equilibrium with , find the exact analytical concentration at which the degree of ionization is exactly . Compare this with the approximate value obtained if .
Answer
Exact: . Approximate (): .
For the dimerization , consider the reverse dissociation where . Determine the exact minimum initial concentration required so that the degree of dissociation does not exceed ().