Resources
Consider the gas-phase synthesis of phosgene: . At a certain temperature, the equilibrium constant is . If a sealed flask is initially filled with and , determine the equilibrium conversion fraction (or fractional extent of reaction) of , defined as .
Answer and steps
Final answer
(or )
Steps
Set up the Reaction Table (ICE Table)
The balanced chemical equation for the synthesis of phosgene is:
Let represent the concentration (in ) of consumed to reach equilibrium.
Using the initial concentrations in the flask:
By definition, the equilibrium conversion fraction of is:
Formulate the Equilibrium Expression
The equilibrium constant expression for the reaction is:
Substitute the equilibrium concentrations in terms of :
Solve for the Equilibrium Extent of Reaction ()
Equating the expression to the equilibrium constant and rearranging into standard quadratic form:
Factor the quadratic equation:
This yields two mathematical solutions:
Physical constraint check:
The extent of reaction cannot exceed the initial concentration of reactants (), as that would result in physically impossible negative concentrations:
- If , (extraneous root).
- Therefore, the physically valid extent of reaction is .
Calculate the Equilibrium Conversion Fraction ()
Substitute back into the expression for :
Typical errors
01 The student forgets that the reaction forms only one mole of gas product from two moles of reactants and inverts the equilibrium constant expression as reactants over products, leading to an incorrect quadratic equation and conversion fraction.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You defined the equilibrium constant expression as reactants over products rather than products over reactants. For , the correct expression is .
- Step 2Correct
Your algebraic expansion and rearrangement were algebraically consistent with your setup in Step 1, but the quadratic equation is affected by the inverted fraction.
- Step 3Correct
Your application of the quadratic formula and selection of the physically reasonable root were mathematically sound, but they yielded because of the inverted initial equation.
- Step 4Correct
You applied the definition of conversion fraction correctly to your calculated extent of reaction, but the final numerical value is incorrect due to the earlier inversion error.
WHAT YOU DID WELL
Compliments from Your TeacherYou set up the stoichiometric concentration changes for reactants and products correctly using the variable .
You expanded binomials and rearranged terms into standard quadratic form accurately.
You used the correct definition of the conversion fraction .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou accidentally placed reactants in the numerator and the product in the denominator when writing the equilibrium constant expression.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusion regarding the fundamental definition of the equilibrium constant quotient , which must always be structured as .
REASONING PATH
Your ACEpath teacher’s suggested approach- Law of Mass Action Definition
For any generic equilibrium , the equilibrium constant is .
Before substituting expressions for equilibrium concentrations, explicitly write the formula with 'products on top, reactants on the bottom'.
- Physical Reality / Directionality Check
A value of means product formation is favored relative to reactants at equilibrium.
Check whether your resulting equilibrium concentrations yield the expected value of when plugged back into the product-to-reactant ratio.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the correct equilibrium constant expression: .
Take the square root of both sides (since ): , or clear the denominator to form , leading to (or standard form ).
Factor or solve the quadratic equation to get roots and . Reject as physically impossible since .
Compute the conversion fraction: (or ).
(or )
02 The student forgets to square the denominator when setting up the equilibrium expression, treating the two reactants as a single first-order term [CO] instead of [CO][Cl2].
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
For the balanced reaction , the law of mass action requires that every gaseous reactant appear in the denominator raised to its stoichiometric coefficient. You omitted from the denominator.
- Step 2Correct
(or when solved directly as or rearranged to )
Your algebraic steps correctly solved the linear equation you wrote, but this step is affected by omitting in Step 1.
- Step 3Correct
(or )
You correctly applied the definition of conversion fraction , but the final value is incorrect because was derived from an incomplete equilibrium expression.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recognized the general definition of the equilibrium constant as products over reactants.
You correctly identified that the conversion fraction represents the reacted moles over initial moles.
You solved your linear algebraic equation accurately without any arithmetic mistakes.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou left out in the denominator of the equilibrium constant expression.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou did not include all gaseous reactants in the law of mass action quotient, treating the reaction as if were the sole reactant.
REASONING PATH
Your ACEpath teacher’s suggested approach- Law of Mass Action Completeness
Every gaseous or aqueous species in the balanced equation must appear in the equilibrium expression: .
Write out the full symbolic equilibrium expression directly beneath the balanced equation before substituting any numbers or variables.
- Dimensional / Unit Consistency
For a reaction where , has units of , which signals that the denominator must have two concentration terms multiplied together.
Check that the total number of concentration factors in the numerator and denominator matches the net change in stoichiometric coefficients.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the complete equilibrium constant expression: .
Substitute the equilibrium concentrations: .
Rearrange into a quadratic equation: . Using the quadratic formula, (or for , ).
Substitute into the fractional conversion: .
(or )
03 The student takes the square root of both sides of the equilibrium expression improperly by treating the numerator x as x², which leads to a linear equation and an erroneous conversion fraction.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You took the square root of both sides, but the numerator is , not . Taking the square root of produces , which does not eliminate radicals. Because the numerator is linear while the denominator is squared, you must multiply out the denominator and solve a quadratic equation.
- Step 3Correct
(or under the workbook's simplified quadratic)
This step is algebraically consistent with your previous line, but the value of is incorrect due to the square root error in Step 2.
- Step 4Correct
(or per the workbook key)
You correctly applied the definition of conversion fraction , but the final numerical value is affected by the earlier calculation of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly wrote the equilibrium constant expression for the synthesis of phosgene.
You accurately defined the equilibrium concentrations in terms of the extent of reaction .
You correctly used the definition of the conversion fraction .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou took the square root of both sides of the equilibrium expression, treating the numerator as if it were .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisAttempting to take the square root of both sides to avoid solving a quadratic equation without verifying whether the numerator is a perfect square.
REASONING PATH
Your ACEpath teacher’s suggested approach- Check for Perfect Squares
You may only take the square root of both sides to obtain a linear equation if both the entire numerator and the entire denominator are perfect squares, such as .
Examine the power of in every factor. If any factor is raised to the first power (like ), you must expand into quadratic form instead.
- Standard Quadratic Expansion
For expressions of the form , clear the fraction by multiplying both sides by , expand the binomial, and collect all terms onto one side.
Write , collect like terms to form , and apply the quadratic formula or factor.
CORRECTED PATH
ACEpath Teacher's DemonstrationStart from the correct equilibrium expression: .
Multiply both sides by : .
Expand and collect all terms on one side: .
Solve using the quadratic formula: .
Choose the root satisfying the physical boundary condition : (note: the source workbook key gives using ).
Compute the conversion fraction: (or per the workbook key).
(or per workbook key)
Lock it in
How is the equilibrium constant expression formulated for the general reaction ?
. Remember the rule: Products in the numerator, Reactants in the denominator.
Similar question
For the dimerization reaction at a certain temperature, . If a sealed flask initially contains and no , find the equilibrium concentration of .
Answer
. Key steps: Set . Solving yields (rejecting since ).
Consider the decomposition of hydrogen iodide: with . If a container initially contains , calculate the equilibrium conversion fraction of .
Answer
(or ). Key steps: . Taking the square root gives . Then .
In the reaction , initial concentrations are , , and . At equilibrium, the fraction of converted is . Calculate the equilibrium constant .
Answer
. Key steps: Conversion of is , so change in is . Equilibrium concentrations: , , and . Then .