Resources
A municipal environmental compliance report states that a wastewater discharge stream contains calcium hydroxide, (), at a mass concentration of at . Assuming calcium hydroxide behaves as a fully soluble and completely dissociated strong electrolyte at this concentration, calculate: (a) the molar concentration of in , (b) the molar hydroxide-ion concentration , (c) the molar hydronium-ion concentration , and (d) the of the wastewater.
Answer and steps
Final answer
(a) ; (b) ; (c) ; (d)
Steps
Calculate the molar concentration of
The mass concentration of calcium hydroxide is given as , and its molar mass is (equivalent to ).
To find the concentration in millimoles per liter ():
Determine the hydroxide-ion concentration
Calcium hydroxide is a strong base that dissociates completely in dilute aqueous solution according to the stoichiometry:
Common Pitfall: Forgetting the stoichiometric factor of . Each formula unit of produces two hydroxide ions ().
Multiply the molar concentration of by :
Converting to molarity ( or ):
Determine the hydronium-ion concentration
At , the autoionization constant of water is :
Rearranging to solve for :
Calculate the
The is defined as the negative base- logarithm of the hydronium-ion concentration:
Alternative verification via :
Typical errors
01 The student forgets that calcium hydroxide produces two moles of hydroxide ions per mole of Ca(OH)2 and equates [OH-] directly to [Ca(OH)2].
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
Calcium hydroxide dissociates according to . Because each formula unit contains two hydroxide ions, the molar concentration of must be twice the concentration of dissolved .
- Step 3Correct
You applied the ion-product relationship correctly, but the resulting value reflects your underestimated from step 2.
- Step 4Correct
Your evaluation of was mathematically correct for your value, but the final numerical result is shifted due to the missed factor of in step 2.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the analytical molar concentration of from the mass concentration and molar mass.
You correctly set up the water autoionization equation to find hydronium concentration.
You properly applied the logarithmic definition to obtain the final .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeThis was not a simple calculation slip; you overlooked the chemical formula subscript of , treating calcium hydroxide as a monoprotic/monohydroxy strong base.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking the stoichiometric ratio between the parent ionic solid and its constituent ions during dissolution. For soluble metal hydroxides with general formula , complete dissociation produces moles of per mole of compound ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Dissociation Stoichiometry
For a strong base , the hydroxide concentration is .
Always write out the balanced dissolution equation before calculating ion concentrations.
- Self-Consistency in Alkaline Solutions
Doubling shifts down by and increases by .
Double-check whether your calculated reflects a dihydroxy base compared to an equimolar monohydroxy base.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the dissociation equation: .
Calculate .
Calculate .
Calculate (or via , ).
(a) ; (b) ; (c) ; (d)
02 The student forgets to convert milligrams to grams when using molar mass, resulting in a concentration that is 1000 times too large.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You divided by without converting units. Because , dividing milligrams by grams per mole yields millimoles (), not moles (). The true concentration is (), not .
- Step 2Correct
You correctly recognized that each mole of yields two moles of , but this step carries over the inflated molarity from Step 1.
- Step 3Correct
You applied the autoionization relationship correctly, but evaluated it with the incorrect hydroxide-ion concentration.
- Step 4Correct
Your logarithmic evaluation is mathematically sound, but yields an impossible because of the initial unit error in Step 1.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that calcium hydroxide dissociates to release two hydroxide ions per formula unit.
You correctly applied the water autoionization constant at .
You used the correct definition to find the final pH.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou assumed dividing a value in milligrams per liter by molar mass in grams per mole gives moles per liter.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConflating metric mass prefixes ( vs. ) when calculating molarity, which scales all subsequent concentrations by a factor of .
REASONING PATH
Your ACEpath teacher’s suggested approach- Dimensional Matching for Molarity
Always write units explicitly next to numbers in calculations: .
- Dilute Solution pH Reality Check
At , dilute aqueous solutions of strong bases rarely exceed .
If a dilute base calculation yields , immediately recheck your initial concentration and prefix conversions.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert the mass concentration: .
Calculate molar concentration: .
Find : .
Find : .
Calculate : .
(a) ; (b) ; (c) ; (d)
03 The student calculates pOH from [OH-] but reports it as pH without subtracting it from 14.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
- Step 4Correct
(or )
The expression calculates , not . A solution of a strong base must have a basic at .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the molar concentration of calcium hydroxide from its mass concentration.
You remembered to multiply by for the divalent strong base to find .
You used the autoionization product of water correctly to compute .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote instead of , overlooking the fact that gives .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the definitions of and . The prefix 'p' means ; hence and . When finding the of a basic solution, one must either take or compute .
REASONING PATH
Your ACEpath teacher’s suggested approach- Check the chemical sense of your result
At , acidic solutions have and basic solutions have .
Since calcium hydroxide is a base, verify that your calculated is significantly above .
- Match ion concentration to the 'p' function
and .
If you use in the logarithm, always label the result as and subtract it from to obtain .
CORRECTED PATH
ACEpath Teacher's DemonstrationMethod 1: Use directly from Step 3: .
Method 2: Use via : , then .
(a) ; (b) (or ); (c) ; (d)
Lock it in
What is the relationship between and the molar concentration of a completely dissociated alkaline earth hydroxide ?
. Dissociation releases two hydroxide ions per formula unit: .
Similar question
A solution is prepared by dissolving of barium hydroxide, (), in water to make of solution at . Assuming complete dissociation, calculate and the of the solution.
Answer
, . Key steps: ; ; each formula unit produces , so ; ; .
A wastewater sample contains of calcium hydroxide, (). If an environmental regulation requires wastewater to have prior to discharge, determine whether this stream complies with the standard at .
Answer
Non-compliant (). Key steps: ; complete dissociation gives ; ; , exceeding the discharge limit of .
A aqueous solution of strontium hydroxide, (), has a measured of at . Calculate: (a) , (b) the molar concentration of dissolved , and (c) the total mass of dissolved in milligrams.
Answer
(a) ; (b) ; (c) . Key steps: ; ; since each formula unit gives , ; ; mass .