Resources
A chemistry student attempts to calculate the of a solution prepared with () and . The student mistakenly applies the Henderson-Hasselbalch equation using the ratio instead of the standard convention . Calculate: (a) the correct equilibrium of the buffer solution at , and (b) the erroneous value resulting from this convention inversion trap.
Answer and steps
Final answer
(a) ; (b)
Steps
Part (a): Correct Equilibrium
-
Identify the Buffer Components and Equilibrium Constant The buffer consists of a weak acid and its conjugate base:
- Weak conjugate acid: , with
- Weak conjugate base: , with
- Acid dissociation constant:
- Calculate
-
Apply the Standard Henderson-Hasselbalch Equation The correct equation relates to using the ratio of conjugate base to conjugate acid:
Substitute the given concentrations into the formula:
Physical check: Because the acidic component is present in higher concentration than the basic component (), the solution must be lower than the (), confirming the result is chemically reasonable.
Part (b): Erroneous from Ratio Inversion
- Identify the Common Trap A frequent error is inverting the concentration ratio by placing the acid in the numerator:
-
Calculate the Resulting Value
Pitfall Note: Inverting the logarithmic ratio changes the sign of the logarithmic term (). When , the inverted formula incorrectly predicts a , erroneously suggesting a more basic solution.
Typical errors
01 The student subtracts the log term instead of adding it in the Henderson-Hasselbalch equation, incorrectly yielding a pH of 9.56 for part (a) and 8.95 for part (b).
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
The standard Henderson-Hasselbalch formula adds the logarithmic ratio of base to acid: . By subtracting this term, you obtained a higher than , even though the buffer has more acid () than base ().
- Step 3Correct
The question specifies that the error is inverting the concentration ratio inside the standard formula: . Because you also used a minus sign in front of the logarithm, you inadvertently cancelled out the inversion, yielding instead of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified as the conjugate acid and as the conjugate base.
You accurately computed the value from .
You handled the logarithmic arithmetic consistently.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote a minus sign before the term instead of a plus sign.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the two equivalent forms of the Henderson-Hasselbalch equation: the standard form uses a plus sign with base over acid, , while a minus sign only applies if the ratio is inverted, .
REASONING PATH
Your ACEpath teacher’s suggested approach- Standard Henderson-Hasselbalch Sign
Always write a plus sign before when placing the base in the numerator.
- Chemical Reasonableness Check
If , then . If , then .
Check your calculated against : with more acid present, the must fall below .
CORRECTED PATH
ACEpath Teacher's DemonstrationFor part (a), substitute into the standard equation: .
For part (b), apply the question's stated ratio-inversion trap with the standard addition: .
(a) ; (b)
02 The student confuses Ka with Kb and calculates pOH instead of pH, leading to an incorrect pH of 5.05 for part (a) and 4.44 for part (b).
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You substituted the concentrations correctly, but the Henderson-Hasselbalch equation using calculates directly, not . Subtracting your intermediate value from turned a basic buffer into an acidic solution.
- Step 3Correct
You correctly set up the inverted ratio requested by the problem, but your earlier confusion of with carried forward when you subtracted from .
WHAT YOU DID WELL
Compliments from Your TeacherYou calculated the correct from the given .
You evaluated the base-10 logarithmic terms accurately in both parts.
You followed the question instructions by inverting the acid-base ratio in part (b).
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou associated the ammonia/ammonium buffer system with simply because ammonia is a weak base, overlooking that the standard Henderson-Hasselbalch equation directly outputs whenever is used.
REASONING PATH
Your ACEpath teacher’s suggested approach- Match the constant to the variable
When using , the Henderson-Hasselbalch equation directly outputs . It outputs only if you use with .
Check the equilibrium constant on the right-hand side before writing the variable on the left: .
- Perform a physical sense-check
An equimolar buffer has a near . Because exceeds , the solution must be slightly more acidic than , yielding a around .
Always verify whether an ammonium buffer can reasonably have a strongly acidic around .
CORRECTED PATH
ACEpath Teacher's DemonstrationApply the standard Henderson-Hasselbalch equation: .
Substitute the known values: .
Apply the inverted ratio for part (b): .
(a) ; (b)
03 The student swaps natural logarithm (ln) for base-10 logarithm (log) in the Henderson-Hasselbalch equation, obtaining a pH of 8.56 for part (a) and 9.95 for part (b).
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You substituted the correct species into the ratio, but you evaluated the term using the natural logarithm () instead of the common base-10 logarithm ().
- Step 3Correct
You correctly inverted the concentration ratio to model the error required by part (b), but you again applied the natural logarithm () instead of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the of ammonium as using the base-10 definition of the "p" operator.
You correctly identified the conjugate base () and conjugate acid () components.
You set up the inverted ratio correctly as requested for part (b).
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou used the natural logarithm function (, base ) instead of the decadic/common logarithm (, base 10). Because the "p" scale in chemistry is defined as , the Henderson-Hasselbalch equation strictly requires the base-10 logarithm.
REASONING PATH
Your ACEpath teacher’s suggested approach- Logarithm Base in Acid-Base Chemistry
The "p" operator represents . Therefore, the Henderson-Hasselbalch equation is .
Always press (base 10) on your calculator when working with and , reserving for thermodynamic and kinetic formulas such as the Arrhenius equation or .
CORRECTED PATH
ACEpath Teacher's DemonstrationEvaluate part (a) using base-10 logarithm: .
Evaluate part (b) with the inverted ratio using base-10 logarithm: .
(a) ; (b)
Lock it in
What is the standard Henderson-Hasselbalch equation relating , , , and ?
. Remember: addition (+) pairs with base in the numerator.
Similar question
A buffer solution is prepared with and . Given (), calculate the equilibrium .
Answer
. Key steps: Identify and . Apply .
A student incorrectly calculates the of a buffer containing and () using . Determine (a) the correct and (b) the student's incorrect result.
Answer
(a) Correct ; (b) Incorrect . Key steps: (a) . (b) Erroneous calculation: .
You need to prepare a phosphate buffer at using and (, ). Find the required molar ratio .
Answer
Ratio . Key steps: Use . Rearrange: . Take the antilog: .