Resources
A solution contains and . A solution of sodium chloride, , is slowly titrated into the mixture at without significantly altering the total volume. Given and , determine the critical threshold concentration of required to initiate precipitation of versus , and state which salt precipitates first.
Answer and steps
Final answer
precipitates at ; precipitates at . Therefore, precipitates first.
Steps
Principle of Selective Precipitation
A sparingly soluble ionic compound begins to precipitate from solution as soon as the ion product (reaction quotient, ) equals or exceeds its solubility product constant ().
When chloride ions () are gradually added to a mixture containing and , precipitation occurs independently for each compound when reaches its critical threshold value. The compound that requires a lower concentration of will precipitate first.
Threshold Concentration for
The dissolution equilibrium for silver chloride is:
The solubility product expression is:
To initiate precipitation, the concentration of chloride must reach:
Substitute the given values:
Threshold Concentration for
The dissolution equilibrium for lead(II) chloride is:
The solubility product expression includes an exponent of due to the stoichiometric ratio:
K_{sp}(\ce{PbCl2}) = [\ce{Pb^{2+}][\ce{Cl-}]^2
Common Pitfall: Do not forget to raise to the second power when writing for . Because is an added variable rather than produced solely from dissolving solid , do not insert stoichiometric coefficients (like ) inside the bracket; simply solve for the equilibrium ion concentration .
Rearranging for the threshold concentration of :
Comparison and Conclusion
Comparing the two threshold concentrations:
Because requires a much smaller concentration of added chloride ions to satisfy its solubility product, precipitates first.
Typical errors
01 The student forgets to square the chloride concentration in the solubility product expression for PbCl2, calculating [Cl-] linearly and obtaining an incorrect threshold concentration.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
Dissolution of yields two chloride ions: . Therefore, must be squared in the solubility product expression: .
- Step 3Correct
Your comparison logic is sound and your final conclusion that precipitates first is correct, but your inequality used the un-squared chloride value ( instead of ).
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that the salt requiring a lower critical concentration of the precipitating titrant precipitates first.
You set up and evaluated the threshold concentration for the electrolyte without error.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakenone
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated as a salt rather than an type salt, omitting the exponent corresponding to the stoichiometric coefficient of in .
REASONING PATH
Your ACEpath teacher’s suggested approach- Stoichiometric Exponents in Solubility Products
For any dissolution equilibrium , the solubility product expression is .
Always write out the balanced dissociation equation first, and verify that each ion concentration is raised to a power equal to its stoichiometric coefficient.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the balanced dissolution equilibrium: .
Apply the proper power to in the equilibrium expression: .
Solve for the threshold concentration: .
Compare the thresholds: .
precipitates at ; precipitates at . Therefore, precipitates first.
02 The student directly compares the numerical K_sp values without calculating the required ion concentrations, mistakenly concluding that the salt with the smaller K_sp precipitates first merely because of that number.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
and
You directly compared the numerical values instead of solving for the precipitating ion concentration . Because and have different stoichiometric ratios ( vs ) and unequal starting cation concentrations, a smaller does not guarantee earlier precipitation.
- Step 2Correct
You correctly stated the final precipitating salt, but your justification relied on the bypassed calculation, and the prompt specifically asked for the critical threshold concentration of for each salt.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recorded the given values for both sparingly soluble salts.
You correctly identified that is the salt that precipitates first.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakenone
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou assumed that a lower numerical always corresponds to earlier precipitation. In reality, values can only be compared directly when salts share the exact same stoichiometry and equal cation concentrations. For salts with different ion formulas or unequal concentrations, you must calculate the critical threshold concentration of the shared precipitating ion.
REASONING PATH
Your ACEpath teacher’s suggested approach- Stoichiometry and K_sp expressions
For a salt , . For a salt , .
Always write out the specific equilibrium expression for each salt before solving for the common added ion.
- Selective precipitation criterion
The salt that precipitates first is the one requiring the lower concentration of the common added titrant ion, not necessarily the one with the smallest .
Calculate independently for every cation present in solution and compare those threshold values.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the reaction quotient condition for : .
Set up the reaction quotient condition for : .
precipitates at ; precipitates at . Therefore, precipitates first.
03 The student includes an erroneous stoichiometric factor of 2 inside the chloride term in the K_sp expression, writing K_sp = [Pb2+](2[Cl-])^2 instead of [Pb2+][Cl-]^2 when solving for the added [Cl-].
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
The equilibrium expression is defined strictly as . The coefficient from the balanced dissolution reaction only appears as an exponent on the actual ion concentration. You added an extra factor of inside the brackets, confusing common-ion addition with dissolving solid into pure water.
- Step 3Correct
Your algebraic simplification was carried out correctly according to your equation, but the numerical answer is incorrect due to the extra factor of in the denominator.
- Step 4Correct
Your reasoning comparing the two values is logically sound and your conclusion is correct, but the comparison relied on your inaccurate threshold value for .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the equilibrium condition needed to initiate precipitation.
You calculated the threshold for with complete mathematical accuracy.
You correctly understood that the salt requiring the lower precipitant concentration precipitates first.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou conflated molar solubility calculations in pure water (where ) with selective precipitation calculations, where is the total concentration of the added titrant at equilibrium and already represents the entire ion concentration inside .
REASONING PATH
Your ACEpath teacher’s suggested approach- Law of Mass Action Definition
For any salt , the solubility product is strictly .
Always write the formal expression using bracketed ion symbols first without multiplying terms by stoichiometric coefficients.
- Molar Solubility ($s$) vs. Actual Ion Concentration ($[\ce{X}]$)
Only use when an unshared salt dissolves in pure water where no other source of ions exists.
When solving for the concentration of an externally added titrant, keep the variable as simply raised to its stoichiometric power.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the standard solubility product expression: .
Isolate : .
Substitute the given concentrations: .
precipitates at ; precipitates at . Therefore, precipitates first.
Lock it in
How is the expression written for an ionic compound of the form dissolving in aqueous solution?
. Remember: the stoichiometric coefficient becomes the power of the ion's concentration in the equilibrium law.
Similar question
A solution has a magnesium ion concentration of . Given , calculate the minimum needed to initiate the precipitation of .
Answer
. Key steps: .
A mixture contains and . Potassium chromate () is added dropwise. Given and , determine which compound precipitates first and calculate its critical threshold.
Answer
precipitates first at . Key steps: For , . For , . Since , precipitates first.
Chloride ions are gradually added to a solution containing and . What percentage of the initial remains in solution just as begins to precipitate? Use and the threshold concentration .
Answer
(or ). Key steps: At the onset of precipitation, . Remaining . Fraction remaining .