Resources
A student mixes of with of . The resulting reaction generates a gas and water. Assuming complete reaction and that the temperature and pressure are maintained at and , write the balanced net ionic equation and determine the percentage of the initial carbonate ions that are converted into carbon dioxide gas, as well as the total volume in liters of generated. (Ideal gas constant )
Answer and steps
Final answer
Net ionic equation: . Percent conversion: . Volume of : .
Steps
Write the Balanced Net Ionic Equation
In aqueous solution, soluble ionic compounds and strong acids dissociate into their ions:
The molecular reaction between sodium carbonate and hydrochloric acid forms sodium chloride, water, and carbon dioxide gas:
Writing all soluble strong electrolytes as separated ions gives the total ionic equation:
Canceling the spectator ions ( and ) yields the balanced net ionic equation:
Determine the Limiting Reactant and Percent Conversion
Calculate the initial moles of carbonate ions and hydrogen ions using :
- Moles of :
- Moles of :
According to the stoichiometric ratio from the net ionic equation, each mole of requires of :
Since is available, is present in excess and is the limiting reactant. Because the reaction goes to completion:
Calculate the Volume of Produced
From the 1:1 mole ratio between and , the moles of carbon dioxide generated are:
Using the ideal gas equation :
Substitute the given values (, , , and ):
Typical errors
01 The student forgets the 1:2 stoichiometry in the limiting reactant analysis and assumes a 1:1 mole ratio, misidentifying carbonate as excess.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
From your balanced equation, requires ( ratio, not ). Since is required and is available, is fully consumed. Because all of initial carbonate reacts, the percent conversion is , not the ratio between the two reactants.
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly wrote and balanced the net ionic equation.
You accurately calculated the initial moles of both reactants from their concentrations and volumes.
You correctly identified that all available carbonate produces and accurately applied the ideal gas law to calculate its volume.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakenone
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou assumed a stoichiometric ratio rather than using the ratio from your balanced equation, and you conflated the definition of 'percent conversion of a reactant' with the mole ratio of the two mixed reactants. Percent conversion of species A is .
REASONING PATH
Your ACEpath teacher’s suggested approach- Stoichiometric Ratio Check
Always use the stoichiometric coefficients from the balanced net ionic equation when determining the moles needed for complete reaction.
Check that each mole of requires .
- Definition of Percent Conversion
Percent conversion of a reactant is . It is never the ratio of one reactant's moles to another reactant's moles.
Identify which reactant is limiting. If a reactant is completely consumed, its conversion is .
CORRECTED PATH
ACEpath Teacher's DemonstrationUse the balanced equation ratio: .
Calculate needed: .
Compare available () with needed (); since available exceeds needed, is in excess and is limiting.
Calculate percent conversion: .
Net ionic equation: ; Percent conversion: ; Volume of :
02 The student misidentifies H+ as the limiting reactant by comparing mole numbers directly without dividing moles of H+ by 2, believing H+ is deficient.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You correctly established that of requires of . Because you have of available, is in excess and is the limiting reactant. The theoretical yield of product must be based on the limiting reactant (), giving a conversion.
- Step 4Correct
You correctly used the ideal gas law with the appropriate constants, but your final volume was affected by carrying forward the incorrect mole value of .
WHAT YOU DID WELL
Compliments from Your TeacherYou wrote the complete and balanced net ionic equation.
You correctly computed the initial moles of both reactants from their volumes and molarities.
You correctly determined the stoichiometric requirement of two ions per ion.
You applied the ideal gas equation correctly with the right gas constant and units.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou did not explicitly compare available reactant moles to required reactant moles to identify which reactant runs out first; instead, you calculated the product yield from the excess reactant () and accepted a physically impossible conversion percentage over .
REASONING PATH
Your ACEpath teacher’s suggested approach- Identifying Limiting Reactant
Compare moles available to moles required: the reactant that runs out first determines maximum product yield.
Always explicitly label which species is 'limiting' and which is 'in excess' before calculating theoretical yield.
- Sanity Check on Percent Conversion
In a reaction with no additional external source, conversion of an initial reactant cannot exceed .
If a calculated conversion or yield exceeds , recheck your limiting reactant identification.
CORRECTED PATH
ACEpath Teacher's DemonstrationCompare available () with required (). Since available exceeds required, is in excess and is the limiting reactant.
Because is limiting and completely reacts, the moles of formed are equal to the initial moles of : , yielding a percent conversion of .
Calculate the gas volume using : .
Net ionic equation: ; Percent conversion: ; Volume of :
03 The student writes a molecular equation instead of the requested net ionic equation.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You wrote a balanced full molecular equation instead of the requested net ionic equation. Strong electrolytes in aqueous solution dissociate into ions, and spectator ions ( and ) must be eliminated.
- Step 2
- Step 3
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the mole quantities of both starting species.
You used stoichiometric mole ratios accurately to identify the limiting reactant.
You applied the ideal gas law with correct units and constants to obtain .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou stopped at the balanced molecular equation rather than converting it to the complete ionic and net ionic equation.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou may have overlooked the distinction between a complete molecular equation (showing neutral compound formulas) and a net ionic equation (which shows only the reacting ionic and molecular species, canceling out spectator ions).
REASONING PATH
Your ACEpath teacher’s suggested approach- Molecular vs. Net Ionic Equation
A net ionic equation includes only the species directly participating in bond breaking/forming, omitting spectator ions that remain unchanged in aqueous solution.
Separate all soluble strong electrolytes into aqueous ions, then cancel the identical ions appearing on both sides of the arrow.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the total ionic equation by dissociating all aqueous strong electrolytes: .
Identify and cancel the spectator ions, and , which appear on both sides of the equation.
Write the remaining participating species to obtain the net ionic equation: .
Net ionic equation: ; Percent conversion: ; Volume of :
Lock it in
What is the formal formula for the percent conversion of a reactant ?
Memory cue: Part reacted over total initial.
Similar question
A student mixes of with of . Assuming the reaction goes to completion according to , identify the limiting reactant and calculate the percentage of initial carbonate ions converted into .
Answer
Limiting reactant: ; Percent conversion: . Key steps:
- .
- .
- Required for all carbonate is . Since only is available, is limiting.
- Moles of reacted .
- Percent converted .
A solution containing of is mixed with a solution containing of to precipitate barium phosphate: . Assuming complete precipitation, determine the limiting reactant and the percent conversion of the excess reactant.
Answer
Limiting reactant: ; Percent conversion of : . Key steps:
- Ratio of .
- requires .
- Since is present, is limiting and is in excess.
- Percent conversion of .
Solid sodium bicarbonate decomposes upon heating: . A sample of (molar mass ) is heated until is collected at and (). Calculate the percent conversion of .
Answer
Percent conversion: . Key steps:
- Initial .
- Moles of produced: .
- Moles of reacted .
- Percent conversion .