Resources
A student titrates of nitrous acid (, ) with potassium hydroxide (). When exactly of the solution has been added, the system forms a buffer prior to the equivalence point. Calculate the pH of the resulting solution at this intermediate stage.
Answer and steps
Final answer
Steps
Calculate the initial amounts in millimoles ()
To find the of the solution during the titration, we determine the amounts of the weak acid and its conjugate base present after partial neutralization.
- Nitrous acid ():
- Added strong base ():
Determine the composition after the neutralization reaction
The added hydroxide ions react completely with nitrous acid according to the stoichiometry:
Using a stoichiometric table (in millimoles):
- Initial:
- Change:
- After reaction:
Since exactly half of the initial weak acid has been neutralized, this stage represents the half-equivalence point of the titration.
Calculate the using the Henderson–Hasselbalch equation
Because the acid and its conjugate base coexist in the same total volume (), the ratio of their molar concentrations equals the ratio of their molar amounts:
Applying the Henderson–Hasselbalch equation:
First, calculate :
Since :
Key Takeaway: At the half-equivalence point of any weak acid–strong base titration, the molar quantity of the unreacted weak acid equals the molar quantity of the conjugate base formed. Therefore, the logarithmic term vanishes, and .
Typical errors
01 The student ignores the consumption of weak acid during neutralization and assumes initial acid concentration remains unchanged in the buffer ratio, yielding a pH of 3.05.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You treated the weak acid amount as unchanged. Because each mole of added consumes one mole of , you must subtract the reacted acid: .
- Step 4
- Step 5Correct
Your Henderson–Hasselbalch setup and logarithmic calculation were mathematically correct, but substituting the unreduced acid quantity caused the final to be too acidic.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the molar amounts of initial nitrous acid and added hydroxide.
You correctly deduced that of conjugate base is produced.
You correctly computed from and applied the Henderson–Hasselbalch equation format properly.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the addition of strong base as only forming conjugate base while forgetting that neutralization consumes an equivalent amount of the starting weak acid.
REASONING PATH
Your ACEpath teacher’s suggested approach- Account for Acid Consumption
During titration with a strong base, . The remaining weak acid is always .
Always complete an ICF (Initial-Change-Final) stoichiometric table before plugging values into the Henderson–Hasselbalch equation.
CORRECTED PATH
ACEpath Teacher's DemonstrationDetermine the remaining unreacted weak acid: .
Evaluate the buffer ratio: .
Apply the Henderson–Hasselbalch equation: .
02 The student calculates the remaining weak acid but treats it as a simple weak acid solution, neglecting the conjugate base present in the buffer and calculating a pH of 2.31.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
[] = = = 4.95 10^{-3}
CorrectWhen a weak acid is partially neutralized by a strong base, the reaction quantitatively generates conjugate base. Here, of was produced alongside the of remaining . Applying the single-solute weak acid approximation ignores the common-ion effect of , which suppresses acid ionization.
- Step 4Correct
This value was calculated from the incorrect hydrogen ion concentration obtained in Step 3.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the initial millimoles of and .
You correctly subtracted the reacted amount to determine the millimoles of unreacted .
You correctly combined the two solution volumes to obtain the total volume.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou tracked the consumption of the weak acid during neutralization, but you did not track the simultaneous production of the conjugate base . As a result, you treated the post-neutralization mixture as a simple monoprotic weak acid solution instead of recognizing it as a conjugate acid–base buffer system.
REASONING PATH
Your ACEpath teacher’s suggested approach- Buffer Recognition in Titrations
Before the equivalence point in a weak acid–strong base titration, partial neutralization yields both unreacted weak acid and newly formed conjugate base .
Always write out an ICF (Initial-Change-Final) stoichiometric table in millimoles to account for both remaining and formed .
- Half-Equivalence Point Property
When exactly half of the initial weak acid is neutralized, , so and .
Check whether the moles of added strong base equal half the initial moles of weak acid; if so, directly evaluate .
CORRECTED PATH
ACEpath Teacher's DemonstrationAccount for the conjugate base formed: .
Recognize that and , meaning the titration is at the half-equivalence point.
Apply the Henderson–Hasselbalch equation: .
03 The student treats the remaining weak acid as a strong acid that completely dissociates into hydrogen ions, resulting in an erroneous pH of 1.26.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You treated the unreacted nitrous acid as a strong acid that dissociates into . Because is a weak acid () and neutralization generates of conjugate base , the solution forms a buffer system rather than a strong acid solution.
- Step 3Correct
Your pH calculation correctly applied the negative logarithm to your previous , but it inherited the error from assuming complete dissociation.
WHAT YOU DID WELL
Compliments from Your TeacherYou calculated the initial moles of weak acid and added strong base accurately.
You carried out the neutralization stoichiometry correctly to determine the unreacted acid remaining.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou equated the concentration of remaining weak acid directly to , overlooking both the incomplete dissociation and the conjugate base produced.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou overlooked the coexistence of unreacted weak acid and its conjugate base formed during partial neutralization, which establishes a buffer governed by the Henderson–Hasselbalch equation.
REASONING PATH
Your ACEpath teacher’s suggested approach- Identify Species Present After Reaction
Neutralizing a weak acid with a strong base produces the conjugate base: .
Always record the moles of conjugate base formed alongside the unreacted weak acid.
- Buffer Equilibrium vs. Complete Dissociation
When both a weak acid and its conjugate base coexist, use .
Check whether ; at this half-equivalence point, the ratio is and .
CORRECTED PATH
ACEpath Teacher's DemonstrationRecognize that neutralization produced of conjugate base while leaving of unreacted .
Set up the Henderson–Hasselbalch equation: .
Compute .
Evaluate .
Lock it in
In a titration of weak acid with strong base , what is the formula for the moles of remaining before the equivalence point?
. Neutralization consumes mole-for-mole as forms.
Similar question
A student titrates of acetic acid (, ) with of . Calculate the pH of the resulting solution.
Answer
. Key steps: Initial ; added . Remaining ; formed . At this half-equivalence point, , so .
A sample of formic acid (, ) is mixed with of . Calculate the pH of the resulting buffer solution.
Answer
. Key steps: Initial ; added . After neutralization: remaining and formed . . .
A student mixes of hypochlorous acid (, ) with to prepare a buffer with . What volume of the solution was added?
Answer
. Key steps: Initial . . From : . Letting be mmol of added: . Volume of .