Resources
Solid iodine () is sealed in an evacuated flask maintained at , where it establishes dynamic equilibrium between solid and vapor phases via sublimation: . At , the equilibrium sublimation vapor pressure of iodine is . If the volume of the flask is expanded isothermally toward an extreme limit of containing only of initial solid , determine whether dynamic equilibrium can still be maintained, or if all solid completely sublimes. Support your conclusion with the maximum vapor pressure exerted if all solid sublimes ().
Answer and steps
Final answer
All solid completely sublimes; dynamic equilibrium is lost because the maximum possible pressure of is well below the equilibrium vapor pressure threshold of .
Steps
Identify the Condition for Dynamic Sublimation Equilibrium
In a closed container at a constant temperature, dynamic equilibrium between a solid and its gas phase: can only exist if both solid and vapor phases are present simultaneously. The gas phase must reach the characteristic equilibrium vapor pressure ( at ).
If the amount of substance available is insufficient to fill the volume up to this equilibrium pressure, all the solid will sublime into gas, leaving no solid phase and breaking the dynamic equilibrium.
Calculate the Pressure Exerted if All Solid Sublimes
Assume all of completely vaporizes into the expanded volume of at .
Using the ideal gas equation:
Substitute the given values:
Convert this pressure into millimeters of mercury ():
Compare with Equilibrium Vapor Pressure
Now compare the maximum possible pressure with the required equilibrium vapor pressure:
- Conclusion: Even after of the solid sublimes into gas, the resulting pressure () remains far below the equilibrium threshold of .
- Because no solid phase remains to continue vaporizing, the rate of condensation cannot balance a sublimation rate, and dynamic equilibrium is lost.
Typical errors
01 The student forgets to convert Celsius to Kelvin, resulting in a significantly lower calculated vapor pressure.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You used directly in the ideal gas law. Gas law calculations require absolute temperature in Kelvin: .
- Step 2Correct
You applied the correct conversion factor between atmospheres and millimeters of mercury, but the resulting value is off by a factor of roughly due to the temperature error in Step 1.
- Step 3
, so all solid sublimes and equilibrium is not maintained.
Correct, so all solid sublimes and dynamic equilibrium cannot be maintained.
Your conceptual reasoning is completely sound: because the maximum possible pressure is less than the required equilibrium vapor pressure (), all solid must sublime and dynamic equilibrium is broken. However, the supporting value used here carries over the earlier calculation error.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the ideal gas equation to find the hypothetical maximum pressure.
You used the correct unit conversion factor of per .
You correctly compared the calculated pressure against the equilibrium vapor pressure to conclude that dynamic equilibrium is lost.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou omitted the conversion from degrees Celsius to Kelvin when using the ideal gas constant , which is defined in units of .
REASONING PATH
Your ACEpath teacher’s suggested approach- Always Convert to Kelvin in Gas Laws
Before substituting into , always convert Celsius temperatures to Kelvin so the units cancel with .
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert the given temperature to absolute scale: .
Recalculate maximum pressure in atmospheres: .
Convert to millimeters of mercury: .
Compare with equilibrium vapor pressure: .
All solid completely sublimes; dynamic equilibrium is lost because the maximum possible pressure of is well below the equilibrium vapor pressure threshold of .
02 The student directly compares the calculated pressure in atmospheres to the equilibrium pressure given in mmHg without converting units, mistakenly concluding that equilibrium is maintained.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You divided by rather than multiplying. Since , converting from atmospheres to millimeters of mercury requires multiplying by .
- Step 3
, so all solid sublimes.
Correct, so all solid completely sublimes and dynamic equilibrium cannot be maintained.
Your conceptual reasoning is sound—comparing the maximum potential vapor pressure to the equilibrium vapor pressure determines phase equilibrium. However, your comparison used the incorrect numerical value from Step 2.
WHAT YOU DID WELL
Compliments from Your TeacherYou converted the Celsius temperature to Kelvin accurately.
You correctly set up and solved the ideal gas equation to find the maximum possible vapor pressure in atmospheres.
You recognized that if the maximum possible pressure is less than the equilibrium vapor pressure, dynamic equilibrium is broken and all solid sublimes.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou inverted the conversion factor between atmospheres and millimeters of mercury by dividing by instead of multiplying.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisLosing track of dimensional units during conversion led to placing in the denominator instead of setting up dimensional analysis with units cancelling ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Dimensional Analysis Setup
Always write out explicit units so the starting unit cancels: .
Check that atmospheres cancel diagonally and you are multiplying by , which must yield a larger number because millimeters of mercury are smaller units than atmospheres.
CORRECTED PATH
ACEpath Teacher's DemonstrationMultiply the pressure in atmospheres by the conversion factor: .
Compare this value to the equilibrium vapor pressure: .
All solid completely sublimes; dynamic equilibrium is lost because the maximum possible pressure of is below the equilibrium vapor pressure of .
03 The student uses the initial volume of 2.00 L instead of the expanded 500.0 L volume, finding a pressure exceeding the equilibrium vapor pressure and incorrectly concluding that equilibrium is maintained.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You substituted the initial volume rather than the expanded volume specified in the problem statement.
- Step 3Correct
Because your calculated pressure was based on the unexpanded volume, your comparison against the equilibrium vapor pressure led to the opposite conclusion.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted the temperature from Celsius to Kelvin.
You correctly chose the ideal gas law to calculate the theoretical maximum pressure if all solid sublimes.
You applied the correct conversion factor between atmospheres and millimeters of mercury.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou grabbed the initial volume () from the setup description rather than the target expanded volume ().
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking the state change described in the problem text leads to substituting pre-expansion parameters instead of the post-expansion state when testing equilibrium limits.
REASONING PATH
Your ACEpath teacher’s suggested approach- State Identification
Always label quantities by state (e.g., , ) when a system undergoes expansion or compression.
Check which volume represents the condition being tested before substituting it into .
- Equilibrium Existence Criterion
A solid-vapor dynamic equilibrium can only exist if , allowing both solid and vapor phases to coexist.
Compare to : if , of the solid vaporizes and dynamic equilibrium is impossible.
CORRECTED PATH
ACEpath Teacher's DemonstrationCompare with the equilibrium vapor pressure: .
All solid completely sublimes; dynamic equilibrium is lost because the maximum possible pressure of is well below the equilibrium vapor pressure threshold of .
Lock it in
What temperature unit must always be used when calculating pressure with the ideal gas law ()?
Kelvin (). The gas constant has temperature units in Kelvin, so convert using .
Similar question
A sample of of dry ice (solid ) is sealed in a container at . Calculate the maximum gas pressure in atmospheres exerted if all solid sublimes ().
Answer
. First convert temperature: . Then apply .
Camphor has an equilibrium sublimation vapor pressure of at . If of camphor is placed in an evacuated vessel at , will dynamic equilibrium be established, or will all camphor sublime? Support with the maximum pressure in .
Answer
All camphor sublimes; dynamic equilibrium is not reached because . Steps: ; ; .
What is the minimum volume (in liters) required at to completely sublime of solid iodine if the equilibrium sublimation pressure is ?
Answer
(or ). Steps: Convert pressure to atmospheres: . Convert temperature: . Solve for volume: .