Resources
In a evacuated sealed reactor at , solid calcium carbonate decomposes into solid calcium oxide and carbon dioxide gas: . At this temperature, the equilibrium constant is , meaning an equilibrium pressure of is required. Exactly of pure is introduced into the reactor at . (a) Calculate the minimum mass of required to establish chemical equilibrium in this vessel at . (b) Determine whether the system reaches a true dynamic equilibrium, and calculate the final equilibrium partial pressure of in the vessel.
Answer and steps
Final answer
(a) of (corresponding to ); (b) True dynamic equilibrium is reached, and .
Steps
Part (a): Minimum Mass of Required
Step 1: Determine the moles of needed at equilibrium
The heterogeneous decomposition equilibrium is:
Because the activities of pure solids are equal to , the equilibrium expression in terms of partial pressures is:
Using the ideal gas law (), calculate the amount of gaseous required to fill the vessel at :
Substituting the known values (with ):
Step 2: Relate moles of to moles and mass of
According to the reaction stoichiometry, of decomposes to produce of :
Using the molar mass of calcium carbonate ():
Thus, a minimum of (or ) of must decompose to build up the equilibrium pressure of .
Part (b): Evaluating System State and Equilibrium Pressure
Step 1: Compare initial amount with required amount
- Initial moles of added:
- Moles needed to produce equilibrium pressure:
Since , only a fraction of the solid reacts:
Step 2: Assess true dynamic equilibrium
For a heterogeneous reaction to achieve true dynamic equilibrium, all chemical species appearing in the balanced equation—both reactants and products—must coexist in the reaction vessel.
Because solid , solid , and gaseous are all present simultaneously at the temperature-dependent equilibrium pressure:
- True dynamic equilibrium is reached.
- The final equilibrium partial pressure inside the container is governed by :
(Note: If fewer than of had been added, all the solid reactant would have decomposed completely, leaving no remaining; in that scenario, dynamic equilibrium could not be established, and the pressure would remain below .)
Typical errors
01 The student forgets that chemical equilibrium requires the coexistence of the solid reactant and assumes that having sufficient reactant means all of it decomposes to produce gas, leading to an incorrect pressure higher than Kp.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
Once reaches ( of decomposed), the forward and reverse reaction rates balance; the decomposition stops advancing macroscopically, so and of remains.
You treated the reaction as running to 100% completion. Because this reversible reaction reaches dynamic equilibrium once , only the required reacts, and the final equilibrium pressure is fixed at .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the ideal gas law to find the moles of gas corresponding to the equilibrium constant.
You correctly calculated the minimum mass of required to generate that equilibrium pressure.
You correctly determined that having more than the minimum moles of solid reactant allows the system to reach equilibrium.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated an equilibrium reaction as an irreversible reaction that proceeds until the limiting reactant is completely consumed, overlooking that dynamic equilibrium halts net change as soon as the reaction quotient reaches .
REASONING PATH
Your ACEpath teacher’s suggested approach- Equilibrium Halts Net Conversion
In a closed system at constant temperature, a reversible reaction stops net conversion once ; it does not consume excess reactant.
Whenever sufficient reactant is available to reach , set the final gas pressure equal to the equilibrium value dictated by rather than calculating complete consumption.
- Coexistence of Phases in Heterogeneous Equilibria
For a heterogeneous decomposition equilibrium like , as long as both solids are present, the equilibrium pressure is fixed by .
Check remaining moles of solid: . Since , the system rests at .
CORRECTED PATH
ACEpath Teacher's DemonstrationBecause , only of decomposes, leaving of unreacted in the vessel.
Because solid , solid , and gaseous all coexist at dynamic equilibrium, the partial pressure of is governed strictly by the equilibrium constant.
Therefore, the equilibrium partial pressure is .
(a) of ; (b) True dynamic equilibrium is reached, and .
02 The student misinterprets the condition for heterogeneous equilibrium and mistakenly believes that because only 0.0500 mol was added, which is less than 0.1 mol or a perceived threshold, all CaCO3 decomposes without reaching equilibrium.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
Because initial moles are close to the minimum, decomposes completely No solid remains, so true equilibrium is not reached
CorrectCompare to . Since , only decomposes, leaving of . Both and coexist with , so true dynamic equilibrium is established.
The calculated is the minimum threshold needed to reach equilibrium pressure. Because the initial amount () exceeds this minimum, decomposition stops as soon as reaches . Solid remains in excess (), so the system successfully attains dynamic equilibrium.
- Step 3Correct
Because equilibrium is reached, the partial pressure of is pinned by the equilibrium constant , rather than being determined by complete decomposition of the initial solid.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the equilibrium condition to find the gas moles required.
You used the ideal gas law with appropriate units to find .
You correctly multiplied by the molar mass of to calculate the minimum mass of .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeAssuming that being 'close to the minimum' causes the reaction to proceed to completion.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the minimum required moles as an unstable threshold that forces total decomposition, rather than recognizing that any initial quantity allows equilibrium to be reached, with the reaction halting naturally once .
REASONING PATH
Your ACEpath teacher’s suggested approach- Evaluate Excess vs. Deficit for Heterogeneous Equilibria
For , dynamic equilibrium is reached whenever .
Calculate from . If , excess remains, equilibrium is reached, and . If , all decomposes and .
CORRECTED PATH
ACEpath Teacher's DemonstrationCompare initial reactant moles to the required minimum: .
Determine the amount remaining at equilibrium: .
Since solid reactant , solid product , and gaseous product all coexist, true dynamic equilibrium is achieved.
Conclude the equilibrium pressure directly from : .
(a) of ; (b) True dynamic equilibrium is reached, and .
03 The student uses the standard molar volume at STP (22.4 L/mol) instead of applying the ideal gas law at 800 K to calculate the required moles of gas.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You divided the volume by , which is the molar volume of an ideal gas only at standard temperature and pressure ( and ). The reactor operates at and requires an equilibrium partial pressure of , so you must calculate the required moles using .
- Step 2Correct
You correctly multiplied by the molar mass of (), but the resulting mass was thrown off by the incorrect mole value from Step 1.
- Step 3Correct
Your comparison logic was sound, but because the true required amount is only , the introduced is more than enough to establish equilibrium.
- Step 4Correct
Because equilibrium is reached and unreacted solid remains, the partial pressure of is fixed by at rather than the pressure resulting from complete decomposition.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the molar mass of () to convert from moles to mass.
You recognized that whether a heterogeneous system reaches dynamic equilibrium depends on comparing the initial amount of reactant to the amount required to satisfy .
You demonstrated that you know how to apply the ideal gas law with and .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou substituted the STP shortcut instead of using with the given temperature and equilibrium pressure.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou defaulted to standard molar volume () without verifying whether the system was at standard temperature and pressure (, ). Whenever gas conditions deviate from STP, the ideal gas law must be evaluated explicitly.
REASONING PATH
Your ACEpath teacher’s suggested approach- Condition Check for STP
The value is valid only at and .
Always check the given and . If either differs from standard conditions, use .
- Equilibrium Pressure in Heterogeneous Systems
For , .
Set to find the required gas pressure before determining how many moles of solid must react.
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate moles of needed to reach : .
Convert required moles of to minimum mass: .
Compare initial reactant with required amount: since , sufficient solid is present for equilibrium to be established with solid , solid , and coexisting.
Identify the final equilibrium pressure: because dynamic equilibrium is established, .
(a) ; (b) True dynamic equilibrium is reached, and .
Lock it in
For the equilibrium with , what determines whether the final pressure equals ?
Whether sufficient solid reactant was initially added so that some remains unreacted when reaches .
Similar question
Solid ammonium carbamate decomposes according to with at . If of the solid is placed in an evacuated container and excess solid remains at equilibrium, what is the relationship between the equilibrium partial pressures of and , and what is ?
Answer
. Substituting into yields .
For the decomposition in a vessel at (), only of is introduced initially (recall is needed for equilibrium). Does the system reach dynamic equilibrium, and what is the final pressure of ?
Answer
No, dynamic equilibrium is not reached because all of decomposes completely, leaving no reactant solid. The final pressure is , which is strictly less than .
A container at contains the equilibrium with . Initially, of pure is placed into the empty container. Calculate the equilibrium total pressure in the flask and determine the remaining mass of (molar mass = ).
Answer
- At equilibrium, , so .\n2. Total pressure .\n3. Moles of each gas formed: .\n4. Moles of reacted , leaving .\n5. Remaining mass .