Resources
In a nuclear forensics and environmental monitoring laboratory, water samples downstream from a research facility are analyzed by gamma-ray spectrometry to determine whether an undeclared activity involves fission or fusion. (a) The gamma spectrum reveals strong characteristic peaks corresponding to iodine-131 (), cesium-137 (), and technetium-99m (). Does this isotopic signature indicate fission or fusion? Justify based on nuclear reaction mechanisms. (b) A second gaseous sample displays high activities of tritium () without any intermediate-mass fission fragments. If a gas sample contains tritium at an activity of with a radioactive half-life of (), calculate the mass of tritium in grams present in the sample (, molar mass of , using ).
Answer and steps
Final answer
(a) Nuclear fission; asymmetric splitting of heavy actinide nuclei produces bimodal intermediate-mass radioisotopes (), which are not generated by light-element fusion. (b)
Steps
Part (a): Identifying the Nuclear Process
- Analyze the Detected Isotopes: The gamma spectrum identifies , , and . These radionuclides are intermediate-mass elements with mass numbers ranging between and .
-
Evaluate Reaction Mechanisms:
- Nuclear Fission: The induced splitting of a heavy parent nucleus (such as or ) typically proceeds via asymmetric fission, yielding two lighter, neutron-rich intermediate-mass nuclei along with free neutrons. These primary fragments decay via and gamma emissions to produce isotopes characteristic of the classic bimodal fission yield curve (e.g., , , and ).
- Nuclear Fusion: Involves the combination of extremely light nuclei (such as isotopes of hydrogen, and ) to form slightly heavier light nuclei (primarily ) and nucleons. Fusion reactions do not possess enough total mass or nucleons to produce mid-table elements ().
- Conclusion: The presence of these characteristic intermediate-mass radionuclides unambiguously indicates nuclear fission.
Part (b): Calculating the Mass of Tritium
- Determine the Decay Constant (): The decay constant relates to the half-life by: Given :
-
Find the Total Number of Tritium Nuclei (): Activity () is given in becquerels (), defined as :
Common Pitfall: Ensure that the half-life is converted to seconds when working with activity in becquerels (), as . The volume () is extraneous information because the total activity of the sample is already provided.
- Convert Number of Nuclei to Mass in Grams: Using Avogadro's number () and the molar mass of tritium ():
Typical errors
01 The student uses half-life in years instead of seconds when calculating the decay constant, causing a mismatch with the activity unit of Becquerel (disintegrations per second).
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
Fission. I-131, Cs-137, and Tc-99m are intermediate-mass fission fragments from heavy nucleus splitting, whereas fusion only involves light nuclei.
- Step 2
- Step 3Correct
You divided an activity in becquerels () by a decay constant expressed in . Because the time units do not match, you must either convert to using the provided half-life in seconds () or convert to .
- Step 4Correct
Your conversion from number of atoms to mass in grams followed the correct algebraic relations, but the final numerical value was off due to the earlier unit mismatch in .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly classified the isotopic signature as nuclear fission based on intermediate-mass fragment mechanisms.
You selected the correct physical formulas for decay constant, activity, and molar mass conversions.
You correctly identified that the gas volume was extraneous information.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou substituted the half-life in years instead of seconds when applying with activity in becquerels.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking the SI definition of the becquerel (), which strictly requires the decay constant to be expressed in rather than during substitution.
REASONING PATH
Your ACEpath teacher’s suggested approach- Match Activity and Decay Constant Units
Activity in becquerels is defined as . Therefore, requires in .
Always convert half-life into seconds before computing whenever activity is stated in becquerels.
CORRECTED PATH
ACEpath Teacher's DemonstrationExpress in reciprocal seconds: .
Compute the correct number of nuclei: .
Calculate moles of tritium: .
Multiply by the molar mass: .
02 The student misremembers the decay constant relationship as λ = t_1/2 / ln 2 instead of ln 2 / t_1/2, inverting the rate constant calculation.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
Fission. These isotopes have mass numbers between 99 and 137, which are typical intermediate-mass fragments produced by nuclear fission rather than fusion.
- Step 2Correct
You inverted the relationship between decay constant and half-life. The decay constant is , with units of , rather than .
- Step 3Correct
You correctly applied the formula , but your value was thrown off by the inverted decay constant from the previous step. Notice that calculating fewer than one atom ( atoms) for an active radioactive sample is a strong clue to check your units and equation.
- Step 4Correct
You followed the correct conversion procedure from number of atoms to moles and then to mass in grams, but the final numerical result was affected by the earlier calculation error.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly diagnosed the isotopic signature as fission based on intermediate-mass radioisotopes.
You correctly used the activity formula to solve for the number of nuclei.
You properly recognized that the sample volume was extraneous information for this calculation.
You followed standard stoichiometric conversions using Avogadro's number and molar mass.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou inverted the fraction in , dividing half-life by instead of by half-life.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the decay constant (a rate constant with units of reciprocal time, ) with half-life (a time interval with units of ), leading to an upside-down ratio.
REASONING PATH
Your ACEpath teacher’s suggested approach- Dimensional Analysis of Rate Constants
Activity is disintegrations per unit time (). Because is dimensionless, must have dimensions of .
Always verify that yields units of , not seconds.
- Sanity Check on Particle Count
A bulk radioactive sample with measurable activity () must contain a very large integer quantity of nuclei ().
If your computed value of is less than atom, immediately recheck whether you divided by or inverted an equation.
CORRECTED PATH
ACEpath Teacher's Demonstration03 The student mistakenly multiplies the sample activity by the volume of 500.0 mL, confusing total activity with volumetric concentration.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
Fission. Intermediate-mass isotopes like I-131 and Cs-137 result from fission of heavy nuclei, not fusion of light nuclei.
- Step 2Correct
The problem specifies that the gas sample contains tritium at an activity of . This value is the total activity of the entire sample, not an activity density per unit volume. Multiplying by the volume introduces an erroneous factor of .
- Step 3
- Step 4Correct
Your rearrangement of and conversion to moles were mathematically sound, but the numerical result was scaled by your inflated total activity from Step 2.
- Step 5Correct
Your mass calculation correctly applied , but the value carries over the factor of error from Step 2.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that intermediate-mass fragments indicate nuclear fission rather than fusion.
You accurately calculated the decay constant using the half-life expressed in seconds.
You correctly related activity to total nuclei using .
You applied Avogadro's number and molar mass accurately to determine mass from nuclei.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou multiplied the stated sample activity by the volume of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the given activity () as an intensive activity concentration (such as ) rather than an extensive property representing the total decay rate of the isolated sample. The volume was extraneous information for calculating absolute mass.
REASONING PATH
Your ACEpath teacher’s suggested approach- Inspect the Units of Activity
Activity given in represents total disintegrations per second for the entire sample. A concentration is given in or .
Check whether the activity value has volume in its denominator before multiplying by sample volume.
- Extraneous Contextual Data
In quantitative nuclear forensics, sample volume or container dimensions are often reported as part of standard sampling protocol without being part of the decay calculation.
Identify whether the quantity needed () requires total activity or concentration before integrating volume into your equation.
CORRECTED PATH
ACEpath Teacher's DemonstrationUse the given activity directly as the total sample activity: .
Compute the number of tritium nuclei: .
Convert nuclei to mass in grams: .
(a) Nuclear fission; asymmetric splitting of heavy actinide nuclei produces bimodal intermediate-mass radioisotopes (), which are not generated by light-element fusion. (b)
Lock it in
What fundamental SI base unit defines the becquerel (), and what does this require for the decay constant in ?
. Because activity is per second, the decay constant must always be in reciprocal seconds () when solving for .
Similar question
A sample contains sodium-24 (, molar mass ) with an activity of . Calculate the decay constant in and the number of sodium-24 atoms in the sample.
Answer
; . Key steps: Convert . Then . Finally, .
A medical facility prepares a solution of phosphorus-32 (, molar mass ) with an activity concentration of . Calculate the total mass of in grams in the entire solution ().
Answer
. Key steps: Total activity . Decay constant . Number of atoms . Mass .
A sealed source contains carbon-14 (, molar mass ) having a measured activity of . An analyst mistakenly calculates and directly divides activity by this value to determine mass. Find the correct mass in grams and the factor by which the analyst's result is underestimated.
Answer
Correct mass = ; factor of underestimation = (seconds per year). Key steps: Correct . Correct atoms. Correct mass . The analyst used in , which is times larger than in , so the calculated and mass were underestimated by exactly a factor of .