Resources
An analytical chemist evaluates an experimental hypothesis claiming that a newly synthesized monoprotic weak organic acid has an acid dissociation constant of . In the lab, a student dissolves a solid sample of this unknown weak acid to make of aqueous solution and measures a stabilized equilibrium at . Assuming the proposed model is correct, reverse-engineer the initial analytical mass concentration (in ) that must have been prepared if the molar mass is . Verify whether the standard approximation was valid or if the full equilibrium expression must be applied.
Answer and steps
Final answer
At , . Using the exact equilibrium expression , we find . (The rule fails because , so the approximation cannot be used). The required initial mass concentration is .
Steps
Calculate the hydronium ion concentration at equilibrium
From the measured , calculate the equilibrium hydronium ion concentration:
For a monoprotic weak acid dissociating in pure water:
Because from the acid is much greater than , autoionization of water is negligible, meaning .
Set up the equilibrium expression and solve for
At equilibrium, the concentration of undissociated acid is . Substituting this into the acid dissociation constant expression gives:
Rearranging to solve for the initial analytical molarity :
Substitute the values:
Evaluate the validity of the standard approximation
A common simplifying assumption is , which is valid only when the percent ionization is under :
Because , the approximation is invalid, and ignoring the dissociated amount would result in a substantial error. The full equilibrium expression was required.
Convert molarity to mass concentration
Using the molar mass (), calculate the initial analytical mass concentration:
Typical errors
01 A student incorrectly assumes the 5% approximation holds and neglects the equilibrium deduction of hydronium from the initial concentration, underestimating the initial concentration.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You assumed instead of using the full denominator . Because is relatively large, neglecting the dissociated amount underestimates the required initial acid concentration.
- Step 3Correct
Your conversion from molarity to mass concentration was performed correctly, but your result was affected by the initial concentration error in Step 2.
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated from the measured .
You correctly evaluated that the percent dissociation exceeds , rendering the standard approximation invalid.
You accurately applied the molar mass conversion from to .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou noticed that the rule failed () but treated it as a passive observation rather than an instruction to resolve the problem using the exact denominator.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisApplying the simplified equilibrium formula by default without setting up the fundamental mass-balance relation , leading to an underestimated initial concentration when percent ionization is non-negligible.
REASONING PATH
Your ACEpath teacher’s suggested approach- Exact Mass Balance for Weak Acids
At equilibrium for , the concentration of un-ionized acid is strictly .
When reverse-engineering from a known and , rearrange directly to without assuming .
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the exact equilibrium constant expression: .
Rearrange to isolate : .
Substitute and : .
Convert to mass concentration: .
The approximation was invalid (), and the required initial mass concentration is .
02 A student calculates the total mass of solute required for the 250.0 mL volume rather than reporting the analytical mass concentration per liter.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You multiplied by the container volume () to find the total solute mass in grams, but the question specifically requested the analytical mass concentration in .
- Step 3
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the hydronium ion concentration from the equilibrium .
You used the complete, non-approximated equilibrium expression to determine the initial molar concentration.
You checked the percent ionization against the threshold and correctly justified why the approximation was invalid.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou solved for the absolute mass of acid dissolved in () instead of leaving the value expressed per liter of solution ().
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the specified volume () as a necessary multiplier for the final answer, overlooking that concentration is an intensive property () rather than an extensive total mass.
REASONING PATH
Your ACEpath teacher’s suggested approach- Check Requested Units
Mass concentration has units of , whereas absolute mass has units of .
Always verify whether the problem asks for total mass or mass concentration before multiplying by solution volume.
- Molarity to Mass Concentration
, where is in and is in .
Multiply molarity directly by molar mass when finding mass concentration in ; do not factor in the sample volume unless total solute mass is requested.
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify the target quantity: initial mass concentration in .
Multiply molarity directly by the molar mass: .
; the approximation is invalid ().
03 A student inverts the equilibrium quotient as Ka = [HA] / [H3O+]^2 when solving for the initial concentration, yielding an unphysically small concentration.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You inverted the equilibrium relationship between , , and . The equilibrium constant definition is , which means is in the denominator, not the numerator. Furthermore, because is moderately large, you must account for the dissociated amount .
- Step 3Correct
Your dimensional analysis and multiplication by molar mass were executed properly, but the result is incorrect due to the propagated value of .
- Step 4
is much larger than , so the approximation is invalid.
Correct, so the approximation is invalid.
While your conclusion that the approximation fails is formally correct, your reasoning was based on the impossible result , which arose from your algebraic inversion in Step 2.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the equilibrium hydronium concentration from the given .
You applied the correct molar mass conversion factor from molarity to mass concentration.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou inverted the quotient in the acid-dissociation equilibrium expression by treating as rather than , producing an initial acid concentration that is orders of magnitude smaller than the hydronium ion concentration it generated.
REASONING PATH
Your ACEpath teacher’s suggested approach- Law of Mass Action Fraction Orientation
For any reaction, . For acid dissociation, .
Always write the equilibrium products in the numerator and the reactant acid in the denominator before rearranging for an unknown initial concentration.
- Physical Sanity Check for Dissociation
A weak acid in pure water cannot produce more hydronium ions than its total initial concentration: .
If your calculated initial concentration is smaller than , immediately stop and recheck your algebraic rearrangement of the equilibrium expression.
CORRECTED PATH
ACEpath Teacher's DemonstrationRearrange the exact acid dissociation equilibrium expression: .
Substitute the values: .
Verify approximation validity using the rule: , confirming the full expression is required.
Convert to mass concentration: .
The required initial mass concentration is , and the standard approximation is invalid ().
Lock it in
When reverse-solving for initial weak acid concentration from known and , what is the exact algebraic expression for ?
. It never requires solving a quadratic equation because appears only once in the denominator.
Similar question
A solution of a monoprotic weak acid with has a measured . Calculate the exact initial analytical concentration in .
Answer
. Using ().
A chemist dissolves an unknown weak acid (molar mass , ) to yield an equilibrium . Determine the initial analytical mass concentration in using the exact equilibrium expression, and state the percent ionization.
Answer
. . Mass concentration . Percent ionization (invalidating the rule).
A initial solution of a weak acid produces a of at equilibrium. Determine whether the acid dissociation constant calculated via the approximation differs by more than from the exact value.
Answer
. Approximate . Exact . Relative difference . Yes, it differs by , which exceeds .