Resources
In an analytical chemistry laboratory, a student standardizes a solution using pure potassium hydrogen phthalate (KHP, molar mass ) to titrate a freshly prepared solution. The student then uses this standardized solution to titrate an unknown diprotic acid derived from a pure element . A sample of pure requires of to reach the second equivalence point via the reaction . Independent mass spectrometry indicates that element has two stable isotopes: (, ) and (). Using the experimental molar mass obtained from the titration, determine the experimental average atomic mass of element and reverse-calculate the isotopic mass of to four significant figures.
Answer and steps
Final answer
Average atomic mass of ; Isotopic mass of
Steps
Titration Stoichiometry and Average Atomic Mass
From the balanced neutralization reaction at the second equivalence point:
- Calculate moles of used:
- Calculate moles of diprotic acid : Because each mole of diprotic acid requires of :
- Experimental Average Atomic Mass of : From the quantitative titration analysis of the acid containing element , the experimental average atomic mass obtained is:
Reverse-Calculate the Isotopic Mass of
The average atomic mass of an element is the weighted sum of the masses of its naturally occurring isotopes:
Where:
- (experimental average atomic mass)
- (fractional abundance of )
- (mass of )
- (fractional abundance of )
- unknown isotopic mass of
- Substitute the known values into the equation:
- Compute the mass contribution of :
- Subtract this contribution from the total average atomic mass:
- Solve for :
Rounding to four significant figures yields:
Typical errors
01 The student forgets the 1:2 stoichiometry between diprotic acid H₂A and NaOH, treating the titration as a 1:1 reaction.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You treated the reaction as a 1:1 neutralization. Because is a diprotic acid reacting to the second equivalence point, reacts with , so is half of .
- Step 3Correct
Your subtraction of two hydrogen masses was logical, but your molar mass was artificially halved because it used the incorrect mole value from Step 2.
- Step 4Correct
You correctly set up the weighted isotope average equation, but you substituted the affected average atomic mass of instead of .
- Step 5Correct
Your algebra was carried out correctly on your numbers, but the result deviates significantly from the true isotopic mass of approximately due to the earlier stoichiometry error.
WHAT YOU DID WELL
Compliments from Your TeacherYou calculated the moles of titrant accurately from its molarity and volume.
You set up the isotopic weighted average formula correctly using fractional abundances.
You executed the downstream linear equation solving cleanly and maintained consistent unit notation.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou equated the moles of diprotic acid directly to the moles of strong base, assuming a 1:1 mole ratio instead of applying the 1:2 stoichiometric factor.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou overlooked the stoichiometric coefficient of in the neutralization reaction . Titrating a diprotic acid to its second equivalence point requires twice as many moles of as moles of acid present. Setting doubled the apparent moles of acid, which halved the derived molar mass and yielded an unphysical isotopic mass of for an isotope labeled .
REASONING PATH
Your ACEpath teacher’s suggested approach- Stoichiometric Factor Verification
For complete neutralization of a polyprotic acid , the mole relationship is .
Check the chemical formula of the acid and the balanced reaction equation before setting analyte moles equal to titrant moles.
- Isotopic Mass Plausibility Check
The isotopic mass in amu of any stable isotope is always numerically close to its integer mass number (within approximately ).
Compare the final calculated isotopic mass to the mass number in the superscript; getting for immediately signals an upstream calculation error.
CORRECTED PATH
ACEpath Teacher's DemonstrationApply the 1:2 stoichiometric factor from : .
Obtain the experimental average atomic mass of element : .
Set up the weighted average formula: .
Subtract the mass contribution of : .
Divide by the fractional abundance of : .
Average atomic mass of ; Isotopic mass of
02 The student subtracts only one hydrogen atom instead of two when calculating the atomic mass of element A from diprotic acid H₂A.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
(Reference value: )
Because the unknown acid is diprotic with the molecular formula , each mole of acid contains two moles of hydrogen atoms. You subtracted only one hydrogen atom () rather than two ().
- Step 4Correct
Your algebraic setup for the isotopic weighted average was completely sound, but the final value was thrown off by the erroneous atomic mass carried over from the previous step.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the titration stoichiometry to relate moles of hydroxide to moles of diprotic acid.
You accurately found the total molar mass of the acid compound from the given sample mass.
You correctly set up the weighted average equation using isotopic fractional abundances and masses.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeThis is a conceptual-subscript oversight rather than an arithmetic slip: you treated the diprotic acid as a monoprotic acid when isolating the mass of element .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking chemical formula subscripts when decomposing compound molar mass into constituent atomic masses. In a compound , the mass of element requires subtracting , not just .
REASONING PATH
Your ACEpath teacher’s suggested approach- Check Formula Subscripts
For any acid , .
Always circle or write out the subscript on hydrogen in the acid formula before subtracting.
- Physical Reasonableness of Isotopic Masses
An isotope's mass in amu is always extremely close to its mass number (within ).
If your calculated isotopic mass for is instead of approximately , pause immediately to catch upstream molar mass errors.
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify the formula , which contains 2 hydrogen atoms: .
Using the experimental average atomic mass of , substitute into the isotopic average equation: .
Isolate the contribution of : .
Solve for the isotopic mass: .
Average atomic mass of ; Isotopic mass of
03 The student multiplies by percent abundances directly instead of dividing by 100 to convert percentages to decimal fractions in the isotope mass calculation.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You correctly set up the formula and subtracted the mass of two hydrogen atoms, but the standard experimental average atomic mass obtained for element is .
- Step 3Correct
You used the raw percentage values ( and ) directly in the weighted sum without dividing by to convert them into decimal fractions ( and ).
- Step 4Correct
Because the mass contribution of was inflated by a factor of , the subtraction produced a negative number and yielded an unphysical negative isotopic mass.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the moles of standard titrated to the second equivalence point.
You correctly applied the stoichiometric ratio to find the moles of diprotic acid .
You correctly recognized that the average atomic mass is a weighted sum of the masses of its constituent isotopes.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou entered percent abundances as whole numbers ( and ) instead of dividing by to obtain fractional abundances ( and ).
WHY IT HAPPENED
ACEpath Teacher's DiagnosisIn the average atomic mass formula , the weighting factors represent fractional abundances that must sum to . If raw percentages are used without dividing by , the total sum is scaled up by a factor of , causing algebraic rearrangements to yield negative masses. Furthermore, catching an unphysical negative mass provides an immediate signal that a factor of was omitted.
REASONING PATH
Your ACEpath teacher’s suggested approach- Convert Percent to Decimal Fraction
Fractional abundance , such that .
Divide every percentage by before setting up the equation, or divide the entire weighted sum by .
- Physical Sanity Check
An isotopic mass must be strictly positive and numerically close to its mass number (e.g., ).
If a calculated mass is negative or deviates significantly from the mass number, immediately check for an omitted division by .
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert the percentage abundances of both isotopes to fractional abundances: and .
Write the weighted average formula: .
Calculate the mass contribution of : .
Subtract this contribution from the total average atomic mass: .
Divide by to solve for : , which rounds to (four significant figures).
Average atomic mass of ; Isotopic mass of
Lock it in
How are the moles of a diprotic acid related to the moles of required to reach the second equivalence point?
. Each mole of diprotic acid releases , requiring for complete neutralization.
Similar question
A sample of an unknown diprotic acid requires of to reach the second equivalence point. Element has two isotopes: (, ) and (). Calculate the experimental molar mass of and reverse-calculate the isotopic mass of to four significant figures (take atomic mass of ).
Answer
; isotopic mass of . Steps: ; ; ; ; .
A sample of a pure triprotic acid is titrated to its final equivalence point with of . Element consists of two stable isotopes: () and (). Determine the experimental average atomic mass of element and the percent natural abundance of (take atomic mass of ).
Answer
Average atomic mass of ; abundance of (extrapolated). Steps: ; ; ; ; using yields , showing an experimental value near of the lighter isotope.
A chemist analyzes a mineral sample containing an unknown diprotic acid . Titration of of pure requires of for complete neutralization. Element has three stable isotopes: (, ), (, ), and (). Calculate the molar mass of , the average atomic mass of , and the isotopic mass of to four significant figures (take ).
Answer
; average atomic mass of ; isotopic mass of . Steps: ; ; ; ; .