Resources
A chemistry student needs to prepare of a aqueous copper(II) sulfate () solution from a concentrated stock solution with a molarity of . Calculate the volume, in milliliters (), of the stock solution required to prepare this diluted solution.
Answer and steps
Final answer
Steps
Identify the Given Information
Dilution Principle
When a solution is diluted by adding pure solvent (water), the amount of solute dissolved in the solution remains constant. Only the total volume of the solution increases, which lowers its concentration: Since molarity () is defined as moles of solute per liter of solution (), this relationship is expressed by the dilution equation: where:
- is the molarity of the concentrated stock solution.
- is the volume of the stock solution needed.
- is the molarity of the diluted solution.
- is the final volume of the diluted solution.
From the problem statement:
- Stock concentration,
- Required stock volume,
- Dilute concentration,
- Dilute volume,
Rearrange and Solve for
Rearrange the dilution formula to solve for the unknown volume :
Substitute the known values into the equation:
Check Units and Significant Figures
- Units: The molarity units () cancel out, leaving the result directly in milliliters ().
- Significant Figures: The input values and have significant figures, while has . The final result must be reported to significant figures: .
Common Pitfall: When using , both volume terms must share the same unit. While converting to liters is valid, keeping both volumes in milliliters is often faster and avoids unit-conversion errors, as long as units match on both sides.
Typical errors
01 The student inverts the dilution formula by multiplying the stock molarity by the target volume and dividing by the target concentration, resulting in an impossible stock volume larger than the final volume.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
To isolate from the dilution formula , you need to divide both sides by , giving .
- Step 2Correct
You substituted the numerical values accurately into your formula, but the calculation was affected by the inverted concentration ratio from Step 1.
- Step 3Correct
Your arithmetic on the substituted values was correct, but because the formula was rearranged incorrectly, your final volume is incorrect.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that this dilution problem relies on the conservation of moles via .
You correctly matched each given quantity with its corresponding variable (, , and ).
You carried out the arithmetic operations and unit cancellations accurately based on your written setup.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou swapped and in the fraction when isolating , multiplying by rather than dividing by it.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou algebraically isolated the unknown volume incorrectly from and missed the physical sanity check that the concentrated stock volume () must always be smaller than the final diluted volume ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Algebraic Isolation Check
To solve for , divide both sides by : .
Always write the base equation first, then show the division step by dividing both sides by the coefficient of the unknown variable.
- Dilution Reality Check
Diluting a solution always requires adding solvent, so and .
After calculating , compare it immediately to ; if , re-check your formula rearrangement.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite down the conservation equation: .
Divide both sides by the stock concentration : .
Substitute the known values: .
Simplify: .
02 The student mispairs the concentrations and volumes in the dilution equation by associating the stock molarity with the final diluted volume.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You mismatched the solution parameters. The final dilute solution has both a concentration of and a volume of , while the stock solution has a concentration of and an unknown volume .
- Step 3Correct
Your algebra was executed correctly based on your equation, but the answer inherited the initial variable mismatch.
WHAT YOU DID WELL
Compliments from Your TeacherYou selected the correct dilution formula relating molarity and volume.
You performed the algebraic rearrangement and division accurately.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou accidentally swapped the two concentrations relative to the volumes, multiplying the stock concentration by the diluted solution's volume.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisFailing to explicitly assign given values with subscripts (e.g., , vs. , ) before plugging them into . A quick physical sanity check reveals that you cannot dilute a solution by starting with a volume () much larger than the desired final solution ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Subscript Assignment
Each side of must describe the exact same state of the solution (State 1 = concentrated stock, State 2 = final dilute solution).
Write out , , , and before substituting.
- Physical Reality Check
Diluting a stock solution by adding solvent always means and .
Ensure the calculated stock volume is smaller than the target final volume.
CORRECTED PATH
ACEpath Teacher's DemonstrationPair the dilute concentration with the dilute volume: .
Set this equal to the stock solution moles: .
Solve for : .
03 The student multiplies all three given values together instead of applying the dilution ratio, confounding total moles with the required volume.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Dilution conserves the amount of solute (), meaning . Solving for the initial volume requires dividing the final moles by the initial concentration, , rather than multiplying all variables together.
- Step 2Correct
Your arithmetic was carried out correctly according to your written formula, but the calculation followed an incorrect algebraic setup.
- Step 3Correct
Because of the multiplication formula used in the first step, your final volume equals the target volume rather than the smaller volume of concentrated stock required.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the numerical values given in the problem statement for molarity and volume.
You carried out the multiplication arithmetic accurately according to your formula.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the dilution relationship as a direct product of all known values () rather than setting the initial moles equal to the final moles () and isolating the unknown volume algebraically.
REASONING PATH
Your ACEpath teacher’s suggested approach- Solute Conservation
During dilution, adding pure water changes the volume and concentration, but the moles of solute remain constant: .
Write the fundamental equation before rearranging for the unknown variable.
- Algebraic Isolation
To solve for , divide both sides by : .
Always isolate the unknown variable symbolically before plugging in numbers.
- Physical Reality Check
A diluted solution must have a larger volume and lower concentration than the concentrated stock from which it is prepared ( when ).
Verify that your calculated stock volume is smaller than the final solution volume.
CORRECTED PATH
ACEpath Teacher's DemonstrationState the dilution equation based on solute conservation: .
Rearrange algebraically to solve for the stock volume: .
Substitute the given quantities: .
Compute the numerical value: .
Lock it in
How do you algebraically solve the dilution equation for the initial volume ?
. Divide both sides by to isolate on one side.
Similar question
A student needs to prepare of from a concentrated stock solution of . What volume (in ) of the concentrated stock solution is needed?
Answer
. Using , substitute the values: .
How many milliliters of stock solution are required to prepare of ?
Answer
. First convert to . Then apply .
A chemist dilutes of an unknown concentrated stock solution to a final volume of , yielding a solution. Determine the molarity of the original stock solution, and state how many milliliters of water were approximately added.
Answer
; approximately of water added. Rearrange for . Assuming additive volumes, the volume of water added is .