Resources
A standard laboratory protocol precipitates magnesium hydroxide via the net ionic reaction , with . As a test tube containing is diluted to an extreme limit with ultra-pure unbuffered neutral water at ( due to autoionization of water, ), evaluate the ion product and state whether precipitation of can theoretically occur under these neutral dilution conditions.
Answer and steps
Final answer
. Since (), no precipitation occurs.
Steps
Write the Dissolution Equilibrium and the Ion Product Expression
The equilibrium between solid magnesium hydroxide and its dissolved ions is represented by the dissolution reaction:
The solubility product constant, , and the reaction quotient (or ion product), , are defined by the product of the dissolved ion concentrations, each raised to the power of its stoichiometric coefficient:
- If , the solution is supersaturated, and precipitation will occur until equilibrium is reached.
- If , the solution is saturated, existing at dynamic equilibrium.
- If , the solution is unsaturated, and no precipitate can form.
Determine the Initial Concentrations of the Ions
- Magnesium ions (): Magnesium nitrate is a strong, soluble electrolyte that completely dissociates: Therefore, .
- Hydroxide ions (): In unbuffered neutral water at , the autoionization of water governs the hydroxide concentration:
Calculate the Ion Product ()
Substitute the initial ion concentrations into the expression:
Key Pitfall: A common mistake is forgetting to square the concentration of the hydroxide ion. The coefficient of in the chemical formula requires to be raised to the second power in both and .
Compare with
Now compare the calculated ion product to the given solubility product constant:
Since (), the concentration of ions in solution is far below the saturation threshold. Therefore, the solution remains unsaturated, and no precipitation occurs.
Typical errors
01 The student forgets to square the hydroxide ion concentration in the ion product expression, calculating Q_sp as [Mg²⁺][OH⁻] instead of [Mg²⁺][OH⁻]².
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You omitted the power of on the hydroxide ion concentration. Because the dissolution equilibrium produces two hydroxide ions per formula unit, , the concentration must be squared in the expression.
- Step 2Correct
You applied the correct comparison logic (), but your comparison relied on the incorrect value calculated in Step 1.
- Step 3Correct
Your qualitative conclusion is correct, but it followed from a calculation that contained an error in .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the relevant initial ion concentrations from the problem statement.
You knew that precipitation occurs only when the reaction quotient exceeds the solubility product constant .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou forgot to raise to the second power when setting up the reaction quotient expression.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the ion product as a simple product of ion concentrations without applying the stoichiometric coefficients from the balanced dissolution equation as exponents.
REASONING PATH
Your ACEpath teacher’s suggested approach- Check stoichiometric exponents
For a sparingly soluble salt , the ion product is .
Always write out the balanced dissociation equation first, and verify that every stoichiometric coefficient appears as an exponent on the corresponding ion concentration.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the balanced dissolution equilibrium: .
Set up the ion product with stoichiometric exponents: .
Substitute the given concentrations: .
Compare with : since , the solution is unsaturated.
. Since (), no precipitation occurs.
02 The student mistakenly squares both the stoichiometric coefficient and the hydroxide concentration in the expression as (2[OH⁻])² even though the hydroxide concentration is directly given, leading to an overcalculated Q_sp.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You defined the reaction quotient with an extra coefficient inside the brackets as . The general ion product expression is . When the actual ion concentration is already known (), you substitute that value directly into without multiplying by beforehand.
- Step 2Correct
Your comparison logic and precipitation conclusion are conceptually sound, though your comparison used the overestimated value from the previous step.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the given initial concentrations of both ions.
You remembered to square the hydroxide term in accordance with the reaction stoichiometry.
You correctly applied the precipitation criterion that no precipitate forms when .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote inside the squared term instead of substituting the actual directly.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou conflated the molar solubility setup (where solid dissolves into pure water producing moles of and moles of , giving ) with substituting explicitly given or existing ion concentrations into the equilibrium law expression .
REASONING PATH
Your ACEpath teacher’s suggested approach- Equilibrium Expression vs. Molar Solubility
The definition of the ion product is strictly . Stoichiometric coefficients appear solely as exponents.
Always write down the pure definition in terms of brackets like first. Only insert a stoichiometric multiplier like if you are expressing an unknown ion concentration from the dissolution of pure solid salt.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the standard ion product expression: .
Substitute the given concentrations: and .
Compute: .
; since , precipitation will not occur.
03 The student misinterprets the precipitation criterion, believing precipitation occurs when Q_sp < K_sp instead of Q_sp > K_sp.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
Precipitation will theoretically occur because is below
CorrectSince , the solution is unsaturated, so no precipitation occurs.
You reversed the criterion for precipitation. When , the ion concentrations have not reached the solubility limit, meaning the solution is unsaturated and no solid precipitates.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly formulated the ion product expression by raising to the power of .
You accurately substituted the ion concentrations and calculated .
You correctly established that by comparing the exponents.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou treated as the condition for precipitation rather than for an unsaturated solution.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused the physical meaning of relative to . The solubility product constant represents the maximum ion product a solution can hold at equilibrium (saturation). If is below , the solution can hold even more dissolved ions without precipitating.
REASONING PATH
Your ACEpath teacher’s suggested approach- Ion Product vs. Solubility Limit
unsaturated (no precipitate); saturated; supersaturated (precipitate forms).
Always recall that precipitation requires an excess of ions over capacity ().
CORRECTED PATH
ACEpath Teacher's DemonstrationCompare the ion product to the solubility product: and .
Because , the dissolved ion concentration is below the saturation threshold.
Conclude that the solution is unsaturated, so no precipitate of forms.
; because , no precipitation occurs.
Lock it in
For a salt dissolving according to , what is the general formula for the ion product ?
. Each stoichiometric coefficient becomes an exponent on its ion concentration.
Similar question
A solution contains and . For calcium fluoride, . Calculate and predict whether precipitates.
Answer
. Since (), no precipitation occurs.
Solid has . If a mixture has and , evaluate and state whether a precipitate forms.
Answer
. Since (), precipitation will occur.
Equal volumes of and are mixed at . For , . Accounting for dilution upon mixing, calculate and determine whether lead(II) chloride precipitates.
Answer
After mixing equal volumes, concentrations halve: and . . Since (), no precipitation occurs.