Resources
An industrial quality control sample of vinegar is analyzed by titrating a aliquot with a standardized solution containing of sodium hydroxide (, molar mass ). If the equivalence point is detected after adding of the titrant, calculate the concentration of acetic acid in the vinegar in units of millimoles per liter ().
Answer and steps
Final answer
Steps
Determine the molarity of the titrant
The mass concentration of the sodium hydroxide () solution is given as , with a molar mass of . Calculate its molar concentration ():
Calculate the moles of delivered at equivalence
Using the volume of titrant consumed ():
Relate moles of to moles of acetic acid
Acetic acid () is a monoprotic acid that reacts with sodium hydroxide in a stoichiometric ratio:
At the equivalence point, the moles of acid equal the moles of base:
Calculate the concentration of acetic acid in the vinegar
The aliquot volume of the vinegar sample is . The concentration in millimoles per liter () is:
(Common Pitfall: Do not forget to convert the volume of vinegar into liters when dividing by millimoles to yield the final unit of .)
Typical errors
01 The student misapplies the dilution/titration formula C1V1 = C2V2 directly with mass concentration instead of converting to molarity, yielding an incorrect concentration in mmol/L.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Titration stoichiometry operates on chemical amounts (moles), not mass. Because of does not neutralize of acetic acid, you must convert the mass concentration of titrant into molar concentration () before relating acid and base amounts.
- Step 2Correct
You treated grams per liter and millimoles per liter as numerically equivalent units. Grams measure mass while millimoles measure amount of substance; converting between them requires the molar mass of the solute.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly set up the reciprocal volume-concentration equation to isolate the unknown sample concentration.
You performed the algebraic evaluation accurately.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing mass concentration () with molar concentration ( or ) in chemical stoichiometry, leading to applying with mass units and subsequently equating directly to .
REASONING PATH
Your ACEpath teacher’s suggested approach- Stoichiometry Operates on Moles
Chemical neutralization reactions proceed in mole ratios defined by balanced chemical equations ( for monoprotic acids), never in mass ratios.
Always convert titrant concentration from to by dividing by its molar mass before using .
- Unit Equivalence Verification
, whereas . Mass concentration and molar concentration have distinct physical dimensions.
Never interchange and numerically without multiplying or dividing by the substance's molar mass.
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate titrant molarity: .
Calculate moles of delivered: .
Use the reaction ratio: .
Find the acetic acid concentration: .
02 The student forgets to divide the moles of acetic acid by the volume of the aliquot, reporting the total amount of substance in millimoles instead of concentration in mmol/L.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
- Step 4Correct
You equated the total amount of acetic acid in millimoles directly to concentration without dividing by the () aliquot volume.
WHAT YOU DID WELL
Compliments from Your TeacherYou calculated the molarity of the sodium hydroxide titrant accurately from its mass concentration.
You found the exact chemical amount in millimoles delivered at the equivalence point.
You recognized that acetic acid and sodium hydroxide react in a 1:1 molar ratio.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou attached concentration units () directly to your calculated chemical amount () instead of dividing by the vinegar sample volume.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the absolute chemical amount (, measured in ) with volumetric concentration (, measured in ).
REASONING PATH
Your ACEpath teacher’s suggested approach- Distinguish Amount from Concentration
Chemical amount has units of or , whereas concentration has units of or .
Always check your units: divide millimoles by liters (or milliliters) to get a concentration value.
- Use Aliquot Volume in the Final Step
The titrant volume determines the moles reacted, while the analyte aliquot volume determines the analyte's original concentration.
Identify the aliquot volume from the problem prompt () and divide the analyte moles by this volume.
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify the volume of the titrated vinegar aliquot: .
Divide the millimoles of acetic acid by the volume in liters: .
03 The student inverts the titration volume ratio by dividing by the titrant volume instead of the sample aliquot volume.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
- Step 4Correct
You divided by the volume of the titrant () rather than the volume of the vinegar sample aliquot being analyzed ().
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted the mass concentration of into molarity.
You calculated the total moles of titrant delivered at the equivalence point accurately.
You recognized that acetic acid reacts with sodium hydroxide in a mole ratio.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou accidentally used the volume of titrant from the burette () as the denominator when computing the analyte concentration.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the titrant volume (delivered from the burette) with the analyte sample volume (measured into the flask) during the final concentration step.
REASONING PATH
Your ACEpath teacher’s suggested approach- Analyte Concentration Definition
Always divide the moles of analyte by the initial aliquot volume of the sample solution, not the volume delivered from the burette.
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify the volume of the analyte aliquot: .
Divide the moles of acetic acid by the vinegar aliquot volume: .
Lock it in
Why can the formula not be used directly when is in grams per liter () for a neutralization reaction?
Neutralization stoichiometry depends on the ratio of moles (), not masses. One gram of acid does not generally neutralize one gram of base.
Similar question
A sample of hydrochloric acid () is titrated to equivalence with of a solution () having a mass concentration of . Find the concentration of in .
Answer
. First, find titrant molarity: . Millimoles of base: . Since and react , .
A aliquot of sulfuric acid (, diprotic) requires of solution () to reach the equivalence point. Calculate the concentration of in .
Answer
. Titrant molarity: . Moles of consumed: . From the reaction , . Concentration: .
A solid monoprotic organic acid is dissolved in water to make a stock solution with a mass concentration of . Titration of a aliquot requires of . What is the molar mass of the acid, and what is its concentration in ?
Answer
and . Millimoles of base: . Because the reaction is , the aliquot contains of acid in , giving . Molar mass: .