Resources
In theoretical solution thermodynamics, the van 't Hoff factor approaches an exact integer value only at the asymptotic limit of infinite dilution (). Consider an aqueous solution of iron(III) chloride (). At an extremely low molality of , ion pairing becomes negligible. Calculate the freezing point depression of this solution at this asymptotic dilution limit, assuming complete dissociation into its constituent ions ().
Answer and steps
Final answer
Steps
Identify the Dissociation Reaction and van 't Hoff Factor ()
When solid iron(III) chloride () dissolves in water, it dissociates completely into its component ions:
For every mole of that dissolves, it produces:
- of cations
- of anions
At the asymptotic limit of infinite dilution (), interionic attractions and ion pairing are negligible. Therefore, the theoretical van 't Hoff factor equals the total number of ions produced per formula unit:
Apply the Freezing Point Depression Equation
Colligative properties depend on the total concentration of dissolved solute particles. The freezing point depression is given by:
Where:
- (the cryoscopic constant of water)
- (the molality of the solution)
Calculate
Substitute the given values into the formula:
First, multiply the van 't Hoff factor by the molality:
Then, multiply by the freezing point depression constant:
Rounding to three significant figures gives:
Common Pitfalls to Avoid
- Neglecting the van 't Hoff factor: Treating an ionic electrolyte as a non-electrolyte () will underestimate the colligative effect by a factor of 4.
- Miscounting ions: Make sure to count both the metal cation and all halide anions (1 + 3 total ions).
- Freezing point vs. Freezing point depression: Freezing point depression () is defined as a positive magnitude (). If the actual new freezing point were requested, it would be .
Typical errors
01 The student forgets to account for electrolyte dissociation and uses i = 1 for the van 't Hoff factor, resulting in a freezing point depression that is four times too small.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You used the non-electrolyte formula without the van 't Hoff factor . Because is an ionic salt that dissociates into and , each formula unit produces 4 solute particles, making .
- Step 2Correct
Your arithmetic evaluation of was correct, but omitting the factor of 4 produced a value four times smaller than the true freezing point depression.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the freezing point depression formula for a solute.
You accurately substituted the given values for and molality .
You performed the multiplication correctly and included the proper units.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou treated an ionic compound as an intact molecular solute rather than accounting for ionic dissociation.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou overlooked that colligative properties depend on the total number of dissolved particles. For strong electrolytes in dilute solutions, the van 't Hoff factor equals the total moles of ions produced per mole of formula unit dissolved.
REASONING PATH
Your ACEpath teacher’s suggested approach- Electrolyte vs. Non-electrolyte Check
For non-electrolytes (e.g., glucose, urea), . For strong electrolytes (soluble ionic salts, strong acids/bases), equals the total number of ions per formula unit at high dilution.
Always write the chemical dissociation equation first to count the total number of ions produced before applying colligative formulas.
- Colligative Property Formula
Include explicitly in your formula every time, setting only when the solute is confirmed to be non-ionizing.
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the dissociation equation: , giving .
Substitute into the colligative formula: .
Multiply the factors: .
02 The student miscounts the number of dissociated ions by taking the formula subscript of chlorine (3) as the total number of ions rather than adding the iron cation (i = 4).
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
When dissolves completely, each formula unit dissociates into one cation and three anions. The total number of particles per formula unit is , not .
- Step 2Correct
You stated the correct colligative property formula, but substituting your earlier value of carried the error into this step.
- Step 3Correct
Your arithmetic was carried out correctly based on , but using the correct factor yields .
WHAT YOU DID WELL
Compliments from Your TeacherYou selected the correct formula for freezing point depression, .
You performed the multiplication and unit handling accurately based on your chosen values.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou focused on the subscript of the anion (3) and omitted the single metal cation (1 ) when tallying the total ions formed upon dissociation.
REASONING PATH
Your ACEpath teacher’s suggested approach- Tallying Dissociation Ions
For a strong electrolyte of formula , complete dissociation produces cations and anions, giving .
Always write out the dissociation equation with ion charges and sum all stoichiometric coefficients on the product side: ions.
CORRECTED PATH
ACEpath Teacher's DemonstrationDetermine the complete dissociation of : , so .
Substitute , , and into .
Calculate: .
03 The student misidentifies FeCl3 as a binary salt consisting of one iron cation and one polyatomic-like chloride unit, incorrectly setting i = 2.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Iron(III) chloride consists of one iron cation () and three individual chloride anions (). Upon complete dissociation, each formula unit yields moles of dissolved ions, so rather than .
- Step 2Correct
You correctly set up the freezing point depression equation and correctly substituted and , but this step carries over your incorrect van 't Hoff factor from Step 1.
- Step 3Correct
Your arithmetic matches your substituted values (), but because , the true value is twice as large.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recalled and stated the freezing point depression formula .
You substituted the given molality and cryoscopic constant into the equation accurately.
You completed the final calculation and preserved the correct physical units.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the subscript on chloride as part of a single polyatomic-like unit or assumed is a binary salt with only two ions, rather than recognizing that the subscript 3 indicates three separate chloride anions ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Dissociation Stoichiometry
When a soluble neutral ionic compound dissolves, it separates completely into individual monoatomic or polyatomic ions: .
Write out the complete dissociation equation and sum the stoichiometric coefficients of all cations and anions to determine the ideal van 't Hoff factor: .
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the complete dissociation reaction:
Count the total ions released per formula unit: , so .
Substitute the correct values into the depression formula: .
Compute the result: .
Lock it in
What does the van 't Hoff factor represent in colligative property calculations?
It is the ratio of the actual concentration of particles produced in solution to the concentration of formula units dissolved ().
Similar question
Calculate the theoretical freezing point depression of an aqueous solution of calcium chloride () at infinite dilution ().
Answer
. Key steps: , so . Then .
Two aqueous solutions are prepared: Solution A contains glucose (), and Solution B contains potassium phosphate (). Assuming ideal dissociation, which solution exhibits a larger freezing point depression?
Answer
Solution B has the larger freezing point depression. Key steps: For glucose (non-electrolyte), effective particle molality is . For , dissociation yields , so , and effective particle molality is . Since , Solution B depresses the freezing point more.
An unknown ionic sulfate salt of the form dissolves completely in water at a concentration of . The measured freezing point depression is (). Determine the experimental van 't Hoff factor and confirm if it matches ideal dissociation.
Answer
, confirming ideal complete dissociation. Key steps: Rearrange to solve for . This matches the theoretical for .