Resources
Two island populations of the lizard Anolis carolinensis exhibit divergence in courtship dewlap extension display rate. Population 1 displays at a rate of , whereas Population 2 displays at . Concurrently, male chemical cues differ in femoral gland secretion concentrations: Population 1 produces of hexadecanoic acid, while Population 2 produces . Convert Population 2's display rate into units of and Population 2's chemical concentration into . Then, compute the absolute difference in display frequency () in and the fold-difference in lipid concentration ().
Answer and steps
Final answer
; ; Absolute display difference ; Concentration ratio .
Steps
Convert Population 2's Display Rate to Displays per Minute
To compare the behavioral display rates directly, both values must share the same time unit. Population 2's rate is given per hour:
Since :
Convert Population 2's Chemical Concentration to
Population 2's chemical concentration is given per liter:
Since :
Common Pitfall: When converting units in the denominator (such as per hour or per liter), remember to divide by the conversion factor ( or ) rather than multiplying.
Compute the Absolute Difference in Display Rate
With both display rates expressed in ( and ), calculate the absolute difference:
This divergence in courtship display rate represents a behavioral pre-zygotic isolating mechanism that can reduce interpopulation mating.
Compute the Fold-Difference in Chemical Concentration
Using the standardized concentration values ( and ), find the ratio:
Population 1 produces times the concentration of hexadecanoic acid compared to Population 2, illustrating divergence in olfactory reproductive signals.
Typical errors
01 The student multiplies by 60 instead of dividing by 60 when converting per hour to per minute, resulting in an inflated display rate of 7200 displays·min⁻¹.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Because time is in the denominator () and , you need to divide the hourly rate by , not multiply.
- Step 2
- Step 3Correct
Your subtraction and absolute value setup were mathematically sound, but the result was distorted by the incorrect display rate from Step 1.
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly set up and calculated the denominator unit conversion from liters to milliliters for chemical concentration.
You correctly applied the absolute difference formula to compare the two populations.
You correctly computed the ratio to find the fold-difference in lipid concentration.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou knew that , but you multiplied the rate by rather than dividing.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing numerator unit conversions with denominator unit conversions. When a unit is in the denominator (per hour), replacing a larger unit with a smaller unit means dividing by the conversion factor so that the rate over a shorter interval decreases proportionally.
REASONING PATH
Your ACEpath teacher’s suggested approach- Denominator Dimensional Analysis
. Therefore, .
Always write the units explicitly as a fraction with a conversion factor fraction that cancels the unwanted unit: .
- Biological Sanity Check
An animal displaying times across an entire hour cannot display times in just one minute.
Check whether your converted rate is smaller when shifting to a smaller time window.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert by dividing by : .
Recalculate the absolute difference using the corrected rate: .
; ; ;
02 The student multiplies by 1000 instead of dividing by 1000 when converting milligrams per liter to milligrams per milliliter, giving a concentration of 250000 mg·mL⁻¹.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
Because liters are in the denominator () and , you need to divide by rather than multiply.
- Step 3
- Step 4Correct
Your division setup was correct, but your answer was affected by the incorrect value of from Step 2.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted the time unit from hours to minutes for the dewlap display rate.
You correctly calculated the absolute difference in courtship display frequency.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou multiplied by the prefix factor instead of dividing by it because the unit being converted (liters to milliliters) is in the denominator of the concentration unit.
REASONING PATH
Your ACEpath teacher’s suggested approach- Converting Units in Denominators
When replacing a unit in the denominator, write out the fraction explicitly: .
Always substitute the conversion factor into the denominator or multiply by dimensional analysis conversion factors like so units cancel properly.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert using dimensional analysis: .
Recalculate the fold-difference: .
; ; ;
03 The student inverts the ratio requested for fold-difference by calculating C₂ / C₁ instead of C₁ / C₂, resulting in approximately 0.294.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
- Step 4Correct
The prompt specified finding the fold-difference as , but you inverted the fraction and computed instead.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified and applied the conversion factors for time () and volume ().
You accurately calculated the absolute difference in behavioral display frequencies.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set up the ratio upside down as instead of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou reversed the numerator and denominator variables specified in the prompt when setting up the fold-difference formula.
REASONING PATH
Your ACEpath teacher’s suggested approach- Variable Order in Ratios
When a prompt asks for a specific ratio or fold-difference , place the first term in the numerator and the second term in the denominator.
Double-check the question prompt's explicit formula notation before substituting numerical values.
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify the given values: and .
Substitute into the requested ratio: .
; ; ;
Lock it in
When converting a rate from per hour () to per minute (), do you multiply or divide by ?
Divide by . Since time is in the denominator (), fewer events occur in a single minute than in a full hour.
Similar question
A researcher observes two populations of cricket. Population A chirps at a rate of , while Population B chirps at . Convert Population B's chirp rate to and calculate the absolute difference .
Answer
. Absolute difference: .
Two strains of bacteria produce an antibacterial compound in broth. Strain 1 produces , while Strain 2 produces . Convert into and find the fold-difference .
Answer
. Fold-difference: .
In an ethology study on speciation, two frog populations differ in mating call duration and frequency. Population 1 calls at with an average sound pulse rate of . Population 2 calls at with a pulse rate of . Standardize to and to , then compute and .
Answer
; . For pulse rate, . Ratio: .