Resources
In a laboratory experiment on erythrocyte membrane fragility, aliquots of whole blood are suspended into test tubes containing graded concentrations of aqueous (, , , , and , where ). The osmolarity of a solution (molecular mass , van 't Hoff factor ) is isotonic with red blood cells. (a) Calculate the osmolarity in of the tube. (b) After incubation and centrifugation, the absorbance of released hemoglobin in the supernatant is measured spectrophotometrically at . Tube A () exhibits , Tube B () exhibits , and Tube C (deionized water, representing complete osmotic hemolysis) exhibits . Calculate the percent hemolysis in the tube, correcting for the isotonic baseline, and state the physiological mechanism driving hemolysis.
Answer and steps
Final answer
(a) ; (b) . In a severely hypotonic external medium ( vs. internal ), water rapidly moves down its chemical potential gradient into the erythrocytes via aquaporins and the lipid bilayer, causing cell swelling beyond the critical hemolytic volume where membrane tension exceeds mechanical rupture strength, causing cell lysis and hemoglobin release.
Steps
Part (a): Calculating the Osmolarity of the Solution
- Convert percentage concentration to mass concentration: A concentration of represents of solute per of solution, which equals . Therefore:
- Calculate molarity (): Using the molar mass of ():
- Calculate osmolarity ( and ): Osmolarity accounts for dissociation into ions using the van 't Hoff factor (): Converting to milliosmoles per liter ():
Part (b): Calculating Percent Hemolysis and Explaining the Mechanism
- Formula for corrected percent hemolysis: To isolate the hemolysis caused specifically by osmotic stress in Tube B, subtract the baseline background absorbance of the isotonic control (Tube A) from both the sample and the total lysis control (Tube C):
-
Substitute the given absorbance values:
- Sample absorbance (, Tube B):
- Baseline isotonic absorbance (, Tube A):
- Total lysis absorbance (, Tube C):
-
Physiological Mechanism:
- Hypotonic Environment: An extracellular osmolarity of is markedly lower than the normal intracellular osmolarity of erythrocytes ().
- Net Water Influx: Water moves rapidly down its chemical potential gradient (from the region of lower solute concentration to higher solute concentration) across the selectively permeable erythrocyte membrane via aquaporin-1 channels and bilayer diffusion.
- Critical Hemolytic Volume & Lysis: Red blood cells lack rigid cell walls. As water enters, the cells swell from their normal biconcave disc shape into spheres. When cell volume exceeds the critical hemolytic volume (approximately of normal volume), the membrane tension surpasses the mechanical strength of the lipid bilayer and spectrin-actin cytoskeleton, tearing the membrane and releasing intracellular hemoglobin into the supernatant.
Typical errors
01 The student forgets to correct for the isotonic baseline absorbance when calculating percent hemolysis.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You took the raw absorbance ratio rather than subtracting the baseline absorbance of the isotonic tube () from both the numerator and the denominator.
- Step 3
Hypotonic extracellular fluid drives osmotic water influx into erythrocytes, causing swelling and lysis.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted percent weight-by-volume concentration into molarity and osmolarity using the van 't Hoff factor.
You accurately stated that osmotic water influx into erythrocytes in a hypotonic medium causes swelling and cell lysis.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set up a simple ratio of sample to control without subtracting the non-zero background reading from the isotonic tube.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking that spectrophotometric assays require background/blank subtraction when an isotonic negative control exhibits non-zero baseline absorbance.
REASONING PATH
Your ACEpath teacher’s suggested approach- Establish the 0% Baseline
In osmotic fragility assays, the isotonic tube () defines osmotic hemolysis, so any baseline absorbance must be subtracted from all tubes.
Always check whether an isotonic negative control absorbance is provided and subtract it from both the test tube and the lysis tube.
- Use the Normalized Relative Formula
Calculate the dynamic absorbance range in the denominator before dividing by the net sample signal .
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify the baseline absorbance from Tube A: .
Identify the sample absorbance from Tube B: , and maximum lysis from Tube C: .
Subtract the baseline from both values: and .
Compute the ratio: .
84.6%
02 The student assumes complete dissociation of NaCl using an ideal van 't Hoff factor of i = 2 rather than the given value of 1.85.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You multiplied by the ideal van 't Hoff factor of rather than the measured factor specified in the problem statement. Real electrolyte solutions deviate from ideality due to ion-pairing.
- Step 3
- Step 4
Hypotonic solution causes net water influx into erythrocytes, leading to swelling and membrane rupture.
WHAT YOU DID WELL
Compliments from Your TeacherYou converted percentage concentration to molarity accurately.
You properly subtracted the isotonic background baseline when calculating percent hemolysis.
You clearly explained the osmotic mechanism that causes red blood cells to swell and lyse in hypotonic media.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou used the theoretical maximum dissociation value () instead of the supplied non-ideal factor ().
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking that real ionic solutions exhibit interionic attractions and ion-pairing, which reduces the effective colligative particle concentration below the stoichiometric ion count ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Check Given Parameters
When a problem specifies an empirical or experimental van 't Hoff factor , always use that value instead of assuming complete theoretical dissociation.
Scan the problem for explicitly stated constants such as before assuming integer values based on chemical formulas.
- Understanding Colligative Reality
For moderately concentrated electrolytes like , electrostatic ion-pairing reduces effective particle count, making rather than exactly .
Substitute using the supplied experimental factor.
CORRECTED PATH
ACEpath Teacher's Demonstration(a) ; (b) , driven by net osmotic water influx into erythrocytes in a hypotonic medium causing cell swelling beyond critical hemolytic volume and membrane rupture.
03 The student omits the van 't Hoff factor entirely, confusing molarity with osmolarity.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You calculated the molarity of (), but you omitted the van 't Hoff factor () required to convert molarity into osmolarity.
- Step 3
- Step 4
Water moves down its osmotic gradient into erythrocytes placed in a hypotonic medium, causing lysis.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted weight/volume percentage concentration into mass concentration in .
You correctly applied the baseline correction formula to calculate percent hemolysis.
You accurately identified that water influx into erythrocytes in a hypotonic environment drives hemolysis.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou treated molarity as directly equal to osmolarity by dividing mass concentration by molar mass without multiplying by the van 't Hoff factor .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused chemical molarity (moles of intact solute molecules per liter) with colligative osmolarity (moles of osmotically active solute particles per liter), forgetting that electrolytes like dissociate into multiple ions in aqueous solution.
REASONING PATH
Your ACEpath teacher’s suggested approach- Relating Molarity to Osmolarity
, where accounts for dissociation into ions.
Always verify whether the solute is an electrolyte, and multiply the molar concentration by its given or theoretical van 't Hoff factor .
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate molarity: .
Multiply by the van 't Hoff factor (): .
Convert to : .
(a) ; (b) .
Lock it in
What formula calculates percent hemolysis when an isotonic control shows background absorbance ?
. Subtracting zeros the non-lytic background.
Similar question
In an erythrocyte osmotic fragility assay, Tube 1 (isotonic saline) has an absorbance of , Tube 2 (test concentration) has an absorbance of , and Tube 3 (deionized water) has an absorbance of . Calculate the percent hemolysis in Tube 2.
Answer
. Using the baseline-corrected formula: .
A blood sample is suspended in a solution (, molar mass ). (a) Calculate the osmolarity of this solution in . (b) If the supernatant absorbance is , the isotonic control absorbance is , and the complete lysis absorbance is , calculate the corrected percent hemolysis.
Answer
(a) [; ]. (b) [].
Erythrocytes with an internal osmolarity of are placed in a sucrose solution (non-permeating solute). Explain the direction of net water movement across the plasma membrane and describe the structural change in the membrane cytoskeleton that occurs prior to lysis.
Answer
Net water moves into the erythrocytes down its chemical potential gradient via aquaporins and bilayer diffusion. As water enters, the erythrocyte transitions from a biconcave disc to a spherical shape. The internal hydrostatic pressure strains the spectrin-actin cytoskeletal network underlying the lipid bilayer until membrane tension exceeds mechanical rupture strength, causing pore formation and lysis.