Resources
An agricultural laboratory evaluates the concentration of microscopic fungal conidiospores of Botrytis cinerea in an infected greenhouse irrigation tank. A water sample is diluted with sterile water to a final volume of . An aliquot of this diluted suspension is loaded into a standard hemocytometer counting chamber with a depth of . The grid area observed consists of large squares, each with dimensions . The counted conidiospores across all squares total spores. (a) Calculate the concentration of spores in the diluted sample in spores/. (b) Determine the spore concentration of the original undiluted irrigation tank in spores/ and in .
Answer and steps
Final answer
(a) Volume counted . Diluted concentration . (b) Dilution factor . Undiluted concentration , which equals .
Steps
Part (a): Concentration of Spores in the Diluted Sample
-
Calculate the volume of the counted region: A standard hemocytometer counting chamber has a fixed depth beneath the coverslip.
- Dimensions of one large square:
- Depth of chamber:
- Volume of one large square:
- Total volume of large squares:
- Convert the volume to milliliters (): Recall that and . Therefore:
- Determine the diluted spore concentration:
Part (b): Spore Concentration in the Original Irrigation Tank
- Determine the dilution factor (): The sample was prepared by taking of tank water and diluting it to a total volume of :
- Calculate the concentration in the original undiluted sample (): Multiply the diluted concentration by the dilution factor:
- Convert the concentration to : Since :
Common Pitfall: Remember that is , not . Confusing linear millimeter-to-centimeter conversion () with volume conversion () will introduce an error of two orders of magnitude.
Typical errors
01 The student divides the total spore count by the volume of a single square instead of dividing by the total volume of all 5 squares or using the average count per square.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You divided the total count of (from squares) by the volume of only square. You need to divide by the total volume of all squares () or divide the average spores per square () by the volume of one square.
- Step 3
- Step 4Correct
Your multiplication by the dilution factor is logically correct, but the result is off by a factor of due to the earlier concentration error in part (a).
- Step 5Correct
Your conversion from to using division by is correct, but the numeric value carries over the previous error.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the volume of a single hemocytometer square and converted it from to .
You correctly calculated the dilution factor as .
You correctly applied the conversion factor between milliliters and microliters.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeNo, this is a conceptual mismatch between the number of squares counted and the volume used in the denominator.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou paired the total spore count from multiple grid squares with the volume of a single grid square instead of matching the total count to the total volume (or mean count per square to single square volume).
REASONING PATH
Your ACEpath teacher’s suggested approach- Match Count to Volume
Whenever counting multiple squares, multiply the volume of a single square by the number of squares before dividing, or find the average count per square first.
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate total volume counted: .
Calculate diluted concentration: .
Multiply by dilution factor (): .
Convert to : .
(a) ; (b) and
02 The student calculates the dilution factor as 2.50 / 50.0 = 0.05 and mistakenly multiplies by 0.05 instead of multiplying by the reciprocal dilution factor 20.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You set up the dilution factor as and multiplied by it. Diluting a sample lowers its concentration, so working backwards to the original stock must yield a higher concentration. The dilution factor should be , or you must divide the diluted concentration by the dilution ratio .
- Step 3Correct
You applied the correct unit conversion factor (), but the numerical value was affected by the dilution factor calculation in the previous step.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the average count per square and converted chamber volume accurately from cubic millimeters to milliliters.
You calculated the correct concentration for the diluted sample in spores per milliliter.
You applied the correct conversion factor between milliliters and microliters.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou calculated the dilution ratio as and multiplied instead of dividing or using the reciprocal dilution factor of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the dilution fraction (part/whole, ) with the dilution factor multiplier (), which led to calculating an original stock concentration that was lower than the diluted solution.
REASONING PATH
Your ACEpath teacher’s suggested approach- Sanity Check for Stock vs. Diluted Concentration
An original undiluted stock must always be more concentrated than any dilution made from it.
Before moving on, verify that . If your calculated stock concentration is smaller, invert your multiplier.
- Defining Dilution Factor ($DF$)
, so .
Always write the ratio as to obtain a factor greater than .
CORRECTED PATH
ACEpath Teacher's DemonstrationCompute the dilution factor: .
Calculate the original undiluted concentration: .
Convert to spores/ using : .
(a) ; (b) and
03 The student misconverts cubic millimeters to milliliters by assuming 1 mm³ equals 10⁻³ mL rather than 10⁻³ cm³ (10⁻³ mL vs 10⁻⁶ L).
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
Since , multiplying by gives . You wrote , which is ten times too large.
- Step 3Correct
Your division was evaluated correctly based on your volume value, but the result is off by a factor of 10 due to the unit conversion error in Step 2.
- Step 4
- Step 5Correct
You multiplied your diluted concentration by the dilution factor correctly, but the numeric value reflects the earlier conversion error.
- Step 6Correct
You applied the correct conversion from to (), but the value inherited the earlier factor-of-10 error.
WHAT YOU DID WELL
Compliments from Your TeacherYou accurately computed the total geometric volume of the counting chamber in cubic millimeters.
You calculated the dilution factor accurately from the given volumes.
You correctly applied the relationship between spore count, volume, dilution factor, and unit conversions.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeWhen converting to milliliters, you substituted per but wrote instead of shifting the exponent to .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated as by changing to without decreasing the power of ten by .
REASONING PATH
Your ACEpath teacher’s suggested approach- Converting mm³ to mL
and . Therefore, .
Multiply the volume in by before converting to standard scientific notation.
- Adjusting Scientific Notation
When moving the decimal point of the mantissa one place to the right (), the exponent must decrease by ().
Write as an explicit intermediate step.
CORRECTED PATH
ACEpath Teacher's Demonstration(a) ; (b) and
Lock it in
What is the relationship between total cells counted across squares and the volume used to compute cell concentration?
Use either or . Never divide the total count across squares by the volume of square.
Similar question
A yeast suspension is loaded into a hemocytometer with depth . A student counts yeast cells across large squares ( each). Calculate the concentration of yeast cells in .
Answer
.
- Average cells per square .
- Volume of one square .
- Concentration .
To determine microalgae density, of culture is diluted into of growth medium. Counting in a hemocytometer reveals a total of cells across large squares ( each). Determine the original culture concentration in .
Answer
.
- Dilution factor .
- Average cells per square .
- Diluted concentration .
- Original concentration .
A fungal spore suspension with an unknown concentration is diluted . In a hemocytometer ( chamber depth), spores are counted in large squares ( area each). Find the spore concentration of the undiluted stock in both and .
Answer
and .
- Average spores per square .
- Volume per square .
- Diluted concentration .
- Undiluted concentration .
- In : .