Resources
An elodea plant leaf cell initially in osmotic equilibrium has an intracellular osmolarity of . An experimenter immerses the leaf into an open sucrose bath at () and observes that water exits the vacuole until the final protoplast volume stabilizes at exactly () of its initial volume. Assuming the cell behaves as an ideal osmometer with negligible osmotically inactive volume and zero initial turgor pressure (), calculate the final molar concentration of the external sucrose solution required to achieve this specific equilibrium volume.
Answer and steps
Final answer
Steps
Understand the Ideal Osmometer Relationship
An ideal osmometer with negligible osmotically inactive volume obeys the principle of conservation of intracellular solute particles. Because solutes inside the cell cannot freely permeate the plasma membrane, the total number of osmotically active moles of solute () remains constant:
where:
- is the initial intracellular osmolarity,
- is the initial protoplast volume,
- is the final intracellular osmolarity,
- is the final protoplast volume.
Determine the Final Intracellular Osmolarity
The problem states that initial turgor pressure is zero (), meaning the cell begins at incipient plasmolysis. As water exits the cell and the protoplast shrinks further, turgor pressure remains zero (). Therefore, osmotic equilibrium depends solely on solute concentration.
Given that and :
Relate Intracellular Osmolarity to External Sucrose Molarity
At osmotic equilibrium, the net flow of water across the semipermeable membrane ceases when the water potential inside the cell equals the water potential outside the cell:
With zero turgor pressure inside and an open bath outside at atmospheric pressure ():
Sucrose is a non-electrolyte and does not dissociate in aqueous solution, so its van 't Hoff factor is :
Common Pitfall: Do not assume the cell develops negative turgor pressure that counteracts water loss. In plant cells undergoing plasmolysis, the plasma membrane detaches from the cell wall, keeping hydrostatic pressure equal to atmospheric pressure () throughout protoplast shrinkage.
Typical errors
01 The student multiplies the initial osmolarity by the volume fraction instead of dividing by it, mistakenly assuming concentration scales proportionally with volume rather than inversely.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Because intracellular solute particles are trapped inside the cell, the number of moles of solute is conserved (). When water leaves and the volume decreases, the internal solution becomes more concentrated, so you must divide by the volume ratio rather than multiply by it.
- Step 2
- Step 3Correct
Your conversion from osmolarity to molarity followed logically from your previous calculation, but it inherited the numerical error from Step 1.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that sucrose is a non-ionizing solute with a van 't Hoff factor of .
You recognized that at osmotic equilibrium without turgor pressure, external solution concentration matches internal osmolarity.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set instead of , effectively treating concentration as directly proportional to volume.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing direct and inverse proportionality when solute amount is conserved: as solvent volume shrinks, solute concentration must increase (), meaning .
REASONING PATH
Your ACEpath teacher’s suggested approach- Physical Reality Sanity Check
When water leaves a compartment while solute stays inside, the remaining solution must become more concentrated, never more dilute.
Always verify that if , then before proceeding to downstream steps.
- Solute Conservation Equation
Solute conservation requires .
Rearrange algebraically before plugging in numbers: .
CORRECTED PATH
ACEpath Teacher's DemonstrationApply solute conservation: .
Solve for final intracellular osmolarity: .
Equate external osmolarity to final internal osmolarity: .
Convert osmolarity to molarity using : .
02 The student calculates the correct final osmolarity of 500 mOsm/L but assumes sucrose dissociates like a binary salt with i = 2, resulting in halving the required molar concentration.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
For sucrose, assume dissociation factor
CorrectFor sucrose (a non-electrolyte), the van 't Hoff factor is .
Sucrose () is a covalently bonded sugar molecule and does not dissociate into separate ions in water. Its van 't Hoff factor is , not .
- Step 3Correct
Because your dissociation factor was set to , your final molar concentration was halved from the correct value of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the ideal osmometer relation to calculate that protoplast shrinkage to raises internal osmolarity to .
You correctly identified that the external solution must match the cell's equilibrium osmolarity when turgor pressure is zero.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou conflated a molecular disaccharide (sucrose) with a binary ionic salt (such as ), mistakenly assigning it a van 't Hoff factor of instead of .
REASONING PATH
Your ACEpath teacher’s suggested approach- Electrolyte vs. Non-electrolyte Classification
Molecules with only covalent bonds like sugars (sucrose, glucose) do not ionize in water (). Salts dissociating into two ions (like ) have .
Always identify the chemical nature of the solute before converting between osmolarity and molarity.
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify sucrose as a non-electrolyte: .
Relate osmolarity to molarity: .
Calculate final molarity: .
03 The student calculates the change in volume (20% or 0.200) and uses it directly in place of the final volume in the dilution formula.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You substituted the lost volume fraction () into the denominator instead of the remaining final volume fraction (). Solute conservation dictates , so depends on the final volume containing those solutes.
- Step 3
- Step 4Correct
Your conversion from milliosmoles per liter to molar concentration was performed correctly using your value from Step 2, but the final numerical value is affected by the earlier volume substitution error.
WHAT YOU DID WELL
Compliments from Your TeacherYou recognized that sucrose is a non-dissociating solute with .
You understood that cell shrinkage increases intracellular osmolarity according to an inverse concentration-volume relationship.
You converted units properly between and .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou calculated the volume decrement and mistakenly placed it in the denominator of the conservation equation in place of the final volume .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the quantity of volume lost () with the remaining volume of solution () that holds the trapped intracellular solutes.
REASONING PATH
Your ACEpath teacher’s suggested approach- Solute Conservation Principle
For an ideal osmometer with impermeable solutes: .
Always set the denominator of to the actual remaining volume , never to .
- Physical Reality Check
When a cell shrinks moderately (e.g., from to volume), concentration increases moderately (by ).
Check whether your calculated concentration matches the scale of shrinking: a volume loss cannot cause a increase in concentration.
CORRECTED PATH
ACEpath Teacher's DemonstrationSubstitute the final protoplast volume fraction into the solute conservation formula: .
Equate external osmolarity to final intracellular osmolarity at equilibrium (): .
Relate external osmolarity to molarity for sucrose (): .
Lock it in
If water exits an ideal osmometer cell containing trapped solutes, does the intracellular solute concentration increase or decrease?
It increases. Solute moles remain constant (), so reducing volume () increases concentration ().
Similar question
A red blood cell behaving as an ideal osmometer has an initial intracellular osmolarity of . It is placed in a concentrated sucrose solution () and shrinks until its volume is of the initial volume. Assuming zero hydrostatic pressure difference, calculate the molar concentration of the external sucrose solution at equilibrium.
Answer
. By solute conservation, . For sucrose (), .
An elodea protoplast at incipient plasmolysis () has an internal osmolarity of . It is immersed in an external solution (assume ideal dissociation, ). At equilibrium, the protoplast volume stabilizes at of its initial volume. Calculate the molarity of the external solution.
Answer
. Final internal osmolarity is . At equilibrium, external osmolarity equals . Since yields particles, .
A plant protoplast has an initial osmolar concentration of and a total volume of , of which is osmotically inactive volume (). The cell is placed in an open sucrose bath () until its total protoplast volume shrinks to . If turgor pressure remains zero throughout, find the molarity of the external sucrose bath at equilibrium.
Answer
. Only the osmotically active volume changes: initial active volume is , and final active volume is . Solute conservation gives . Since , .