Resources
A bioreactor culture of Escherichia coli begins with an initial bacterial biomass density of and increases exponentially according to . In a preliminary experiment, the population doubles its biomass every . (a) Calculate the intrinsic specific growth rate expressed in standard SI units of . (b) If the culture grows uninhibited for exactly , calculate the final bacterial biomass concentration expressed in milligrams per liter ().
Answer and steps
Final answer
(a) ; (b) Final concentration
Steps
Part (a): Determine the Intrinsic Specific Growth Rate ()
-
Relate doubling time to the specific growth rate: During exponential growth, the biomass doubles () after one doubling time ():
Taking the natural logarithm of both sides yields:
- Convert the doubling time to standard SI units (seconds):
- Calculate :
Part (b): Calculate the Final Biomass Concentration
-
Determine the number of doubling cycles (): Convert the total growth duration into minutes:
The number of generations (doublings) that occur is:
-
Compute the biomass concentration using binary expansion:
(Alternatively, using the continuous formula: )
-
Convert units to : Therefore:
Common Pitfall: When calculating in SI units, ensure that the time value is converted from minutes to seconds before dividing. Omitting unit conversion leads to a rate in rather than the requested .
Typical errors
01 The student forgets to convert the doubling time from minutes to seconds, resulting in a growth rate in min^(-1) rather than s^(-1).
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You divided by directly without converting to seconds, yielding a growth rate of instead of standard SI units ().
- Step 3
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly derived and applied the relationship .
You recognized that is equivalent to .
You correctly calculated the number of doubling generations over .
You accurately computed the final exponential biomass concentration using binary doubling.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou divided by the doubling time in minutes () while writing down for the unit, omitting the required factor of .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the numerical value of doubling time as already in standard SI units or attached the target unit after computing with minutes, rather than converting explicitly before performing the division.
REASONING PATH
Your ACEpath teacher’s suggested approach- Enforce Target Units During Substitution
Before substituting a measured time into a rate equation, verify that its unit matches the requested denominator unit (e.g., convert to when is requested).
Multiply minutes by to get before dividing by .
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert the doubling time into standard SI units of seconds: .
Substitute into the rate equation: .
(a) ; (b) Final concentration
02 The student confuses the doubling time relation by using the reciprocal 1/t_d instead of ln(2)/t_d to calculate the specific growth rate.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
Because continuous exponential growth follows , setting gives , which requires taking the natural logarithm: . The reciprocal represents the doubling frequency (generations per unit time), not the intrinsic continuous rate .
- Step 3
,
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted the doubling time from minutes to standard SI seconds.
You correctly recognized that is equivalent to .
You accurately found the total number of doubling cycles and computed the final concentration for Part (b).
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakenone
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou used the reciprocal of doubling time instead of . The quantity gives the discrete generation frequency (doublings per unit time), whereas the continuous base- specific growth rate in requires solving , yielding .
REASONING PATH
Your ACEpath teacher’s suggested approach- Deriving $\mu$ from Doubling Time
At one doubling time , the population doubles: .
Always take the natural logarithm of when converting doubling time to specific growth rate: .
- Continuous Rate vs. Generation Frequency
Generation frequency is , while continuous specific growth rate is .
Check the governing equation: if the model uses base , multiply by .
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the doubling condition: .
Take the natural logarithm of both sides: .
Substitute : .
(a) ; (b) Final concentration
03 The student misapplies the unit conversion from μg·mL^(-1) to mg·L^(-1) by incorrectly multiplying by 10^(-3) rather than recognizing they are equivalent.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You converted the mass unit from micrograms to milligrams by multiplying by , but you did not account for the volume conversion in the denominator (). Because both factors cancel, is numerically identical to .
- Step 3
- Step 4Correct
Your exponential multiplication using was algebraically correct, but the numerical answer inherits the earlier conversion error in .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted doubling time into seconds to express in standard SI units of .
You used the exact relationship to find the specific growth rate.
You correctly calculated the total number of doubling cycles as .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou converted only the numerator unit () and forgot to convert the volume unit in the denominator ().
WHY IT HAPPENED
ACEpath Teacher's DiagnosisTreating compound units as single-prefix conversions rather than writing out the ratio of conversion factors for both the numerator and denominator.
REASONING PATH
Your ACEpath teacher’s suggested approach- Ratio of Derived Metric Units
When converting derived units like , convert numerator and denominator separately: .
Always write out both conversion factors explicitly: .
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the compound unit factor: .
Therefore, .
Multiply by the binary growth factor: .
(a) ; (b) Final concentration
Lock it in
How do you calculate the specific growth rate in standard SI units () from a doubling time given in minutes?
Convert to seconds first (), then calculate . Rate units always invert time units.
Similar question
A yeast culture in a fermenter doubles its cell count every . Calculate its specific growth rate in standard SI units ().
Answer
. Key step: ; .
An algal suspension grows exponentially with a specific growth rate of . (a) Find its doubling time in minutes. (b) If the initial density is , what is the density after ?
Answer
(a) ; (b) (or ). Key steps: . In , .
A recombinant bacterium has an initial biomass of . Over , the biomass reaches under uninhibited exponential growth. Calculate (a) the doubling time in minutes and (b) the specific growth rate in .
Answer
(a) ; (b) . Key steps: , so doublings occur in , giving . Then .