Resources
In a genetic testcross investigating Mendelian independent assortment versus autosomal linkage, a dihybrid plant () is crossed to a homozygous recessive tester (). A sample of progeny is scored, yielding , , , and . A chi-square () goodness-of-fit test is conducted to test the null hypothesis () of independent assortment (expected phenotypic ratio ). Calculate the critical threshold value for at the significance level for the appropriate degrees of freedom, determine the calculated test statistic for this cross, and evaluate whether the researcher should reject or fail to reject .
Answer and steps
Final answer
Degrees of freedom: ; Critical value: ; Calculated test statistic: ; Decision: Fail to reject the null hypothesis () because ()
Steps
Identify the Null Hypothesis and Expected Progeny Counts
Under Mendel's law of independent assortment, a dihybrid testcross () produces four phenotypic classes in an equal ratio:
The null hypothesis () states that the two genes assort independently and deviations in the sample are due solely to chance.
With a total progeny count of , the expected count () for each of the phenotypic classes is:
Determine Degrees of Freedom and Critical Threshold
The degrees of freedom () for a goodness-of-fit test depend on the number of phenotypic categories ():
Consulting the standard chi-square distribution table at a significance level of with :
Decision rule: Reject if the calculated test statistic ; otherwise, fail to reject .
Compute the Chi-Square () Test Statistic
The chi-square test statistic measures the discrepancy between observed () and expected () frequencies:
Evaluating each phenotypic class:
- For class :
- For class :
- Accounting for the contributions of the remaining classes ( and ) and summing over all categories yields:
Evaluate the Hypothesis and State the Conclusion
Compare the calculated test statistic to the critical threshold:
Because the calculated test statistic does not exceed the critical value, the associated -value is greater than ().
Conclusion: Fail to reject the null hypothesis (). The experimental data do not provide sufficient statistical evidence to reject independent assortment; the observed deviations from a ratio are consistent with random sampling variation rather than autosomal linkage.
Typical errors
01 The student calculates degrees of freedom as the total sample size minus 1 or number of classes minus 2 (e.g., using df = 1 or df = 2), incorrectly looking up a critical value of 3.841 for df = 1 and falsely rejecting the null hypothesis.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
In a chi-square goodness-of-fit test, degrees of freedom are calculated as , where is the number of phenotypic categories. Because there are phenotypic classes (, , , ), the correct degrees of freedom are , giving a critical threshold of at .
- Step 2
- Step 3Correct
Because your critical value was derived from rather than , your decision rule was too strict. Comparing your calculated statistic () to the true critical value of shows that , meaning you should fail to reject .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the expected frequency of individuals for each phenotypic class under the null hypothesis of independent assortment.
You correctly set up and evaluated each component in the chi-square summation formula.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou confused the number of genes () with the number of phenotypic outcome classes () when computing degrees of freedom.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisIn Mendelian genetic crosses, students frequently equate with the number of gene pairs (here genes, and ) or alleles rather than the number of distinct observable phenotypic classes (). Degrees of freedom for a goodness-of-fit test depend solely on the number of categories being tested minus one, not the number of loci.
REASONING PATH
Your ACEpath teacher’s suggested approach- Count Outcome Categories
In a chi-square goodness-of-fit test, degrees of freedom are , where represents the number of observed phenotypic classes.
Identify all phenotypic categories present in the data table before looking up the critical value.
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify the number of phenotypic categories: ().
Calculate the degrees of freedom: .
Look up the critical value at with : .
Compare the calculated test statistic to the critical value: (or ).
Degrees of freedom: ; Critical value: ; Calculated test statistic: ; Decision: Fail to reject ()
02 The student divides by the observed count O rather than the expected count E in the denominator of the chi-square formula, yielding an incorrect test statistic.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You placed the observed count in the denominator instead of the expected count . In Pearson's chi-square test, each squared deviation must be standardized by dividing by the theoretical expected count for that category.
- Step 4Correct
Your comparison logic and conclusion are valid, but your numerical comparison used the downstream affected test statistic ( instead of ).
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the degrees of freedom as and identified the critical threshold .
You accurately computed the expected count of individuals per phenotypic class.
You correctly executed the decision rule by comparing the test statistic to the critical value.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou wrote in the denominator of the chi-square formula instead of dividing each squared difference by .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the standardization basis of goodness-of-fit deviations. The variance of a Poisson or multinomial count under the null model is approximated by the expected count , so deviation squares must be normalized by , not the sample observation .
REASONING PATH
Your ACEpath teacher’s suggested approach- Chi-Square Formula Denominator
Pearson's chi-square test statistic is defined as .
Always verify that the theoretical expected value serves as the divisor for every category.
- Uniform Denominator Check
When all phenotypic classes have the same expected ratio (e.g., ), all terms share an identical denominator .
If you notice varying numbers in your denominators when expected frequencies are equal, check whether you accidentally plugged in observed counts .
CORRECTED PATH
ACEpath Teacher's DemonstrationWrite the standard goodness-of-fit formula: .
Substitute into the denominator of each term: .
Square the deviations: .
Sum the component values: .
Degrees of freedom: ; Critical value: ; Calculated test statistic: ; Decision: Fail to reject because .
03 The student misinterprets the decision rule by rejecting the null hypothesis when the test statistic is smaller than the critical value instead of failing to reject.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
When the calculated test statistic is smaller than the critical threshold, the observed deviation is consistent with random chance (). You should fail to reject (retain) the null hypothesis rather than reject it.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that a ratio across four classes gives and found the critical value .
You correctly computed the expected count of for each phenotypic category.
You accurately carried out the chi-square summation formula.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou correctly noted that the test statistic fell below the critical threshold, but you mistakenly associated falling below the threshold with rejecting the null hypothesis.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the rejection region of a goodness-of-fit test: a smaller value means observed values are close to expected values (good fit), so we only reject when .
REASONING PATH
Your ACEpath teacher’s suggested approach- Chi-Square Decision Rule
Reject only if (or ). If , fail to reject .
Always place the critical value at the boundary of the rejection region in the upper tail; values to the left (smaller) mean insufficient evidence to reject.
CORRECTED PATH
ACEpath Teacher's DemonstrationCompare the calculated value to the critical threshold: .
Because is less than the critical value, the result does not lie in the rejection region, meaning .
Conclude that we fail to reject the null hypothesis (). The data are consistent with independent assortment.
Degrees of freedom: ; Critical value: ; Calculated test statistic: ; Decision: Fail to reject ().
Lock it in
How are degrees of freedom () calculated in a genetic chi-square () goodness-of-fit test?
, where is the number of phenotypic outcome categories, not the number of genes or total sample size.
Similar question
A monohybrid testcross () produces dominant and recessive progeny. Test the hypothesis of equal segregation () at where for . State the calculated and your conclusion.
Answer
Expected counts: for each class. Calculated statistic: . Because , fail to reject .
In a dihybrid cross with codominance at one locus and complete dominance at another, progeny fall into distinct phenotypic classes. Determine the degrees of freedom () and state whether an experimental value of rejects at (critical value for is ).
Answer
Degrees of freedom: . Since , reject the null hypothesis .
A trihybrid testcross () is conducted to test independent assortment across all three genes. Identify the number of phenotypic classes (), the degrees of freedom (), and write the general expression for the expected count in each class if .
Answer
Number of phenotypic classes: . Degrees of freedom: . Expected count per class: .