Resources
A wild population of red foxes () preys upon snowshoe hares () according to coupled Lotka-Volterra predator-prey dynamics: and . The prey's intrinsic growth rate is , the attack rate is , the predator per capita mortality rate is , and the conversion efficiency is . Concurrently, a fatal sarcoptic mange outbreak strikes the fox population, instantly doubling the fox mortality rate to . Calculate the new predator-free equilibrium hare density necessary to sustain the diseased predator population at dynamic equilibrium.
Answer and steps
Final answer
Steps
Identify the Condition for Predator Equilibrium
To find the hare population density required to sustain the predator (fox) population at dynamic equilibrium, we analyze the predator rate equation from the Lotka–Volterra model.
The rate of change of the fox population () over time is given by:
where:
- is the conversion efficiency of consumed prey into predator offspring ().
- is the predator attack rate ().
- is the prey (hare) density.
- is the predator (fox) density.
- is the elevated predator mortality rate after the mange outbreak ().
For the predator population to be at dynamic equilibrium () while maintaining a non-zero predator presence ():
Dividing both sides by :
Solve for the Equilibrium Prey Density ()
Rearranging the formula to isolate the prey equilibrium density (the predator zero-growth isocline):
Substitute the Numerical Values
Insert the given parameters into the equation:
Compute the denominator:
Now, compute :
Biological Insight and Common Pitfall
- Biological interpretation: When disease doubles the predator mortality rate (), each individual fox has a shorter expected lifespan. Consequently, a higher encounter rate with prey—and thus a denser hare population—is required for fox reproduction to balance the heightened death rate.
- Common pitfall: Do not use the prey equation () or the intrinsic growth rate () when solving for . The prey equation determines the equilibrium predator density (), whereas the predator equation determines the threshold prey density () necessary to maintain predator balance.
Typical errors
01 The student uses the baseline mortality rate m = 0.35 rather than the doubled mortality rate m' = 0.70 caused by the disease outbreak, resulting in an equilibrium hare density of 1250 hares.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You substituted the pre-outbreak mortality rate . Because the mange outbreak doubled predator mortality, you needed to use .
- Step 3Correct
Your arithmetic on the substituted numbers was correct, but the final value is halved because it inherited the unadjusted mortality rate from Step 2.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that sustaining the predator population at dynamic equilibrium requires setting .
You isolated the prey zero-growth threshold correctly in terms of model parameters.
You accurately computed the product .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou used the baseline parameter value provided early in the problem prompt rather than incorporating the explicitly updated parameter state caused by an environmental perturbation (the disease outbreak).
REASONING PATH
Your ACEpath teacher’s suggested approach- Check for Parameter Modifications
When an environmental shock or disease event occurs, locate the modified parameter value () rather than the initial baseline ().
Scan the problem statement for state changes or updated rates before plugging numbers into your derived formula.
- Biological Reasonableness Check
Higher predator mortality requires a higher prey density to provide enough encounter and consumption events to sustain predator replacement.
Verify that your new equilibrium increases relative to the baseline when predator death rates increase.
CORRECTED PATH
ACEpath Teacher's DemonstrationSubstitute the disease-elevated mortality rate into the isocline equation: .
Evaluate the denominator: .
Divide to find the new equilibrium density: .
02 The student sets the prey equation dH/dt = 0 instead of the predator equation dP/dt = 0, attempting to calculate an equilibrium using the intrinsic growth rate r instead of the predator parameters, leading to an incorrect hare density of r/a = 200.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You set the prey rate equation to find the prey density. However, the prey density that sustains the predator population at dynamic equilibrium is determined by setting the predator rate equation .
- Step 2Correct
Even within the equation , dividing by gives , which solves for the predator density , not . Setting yields , which gives .
- Step 3Correct
Your arithmetic evaluation was carried out correctly on the expression you derived, but it propagated the incorrect formula from the previous steps and omitted the disease-adjusted mortality rate and conversion efficiency .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recognized that finding dynamic equilibrium requires setting a population derivative to zero.
You performed the division accurately.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused the prey zero-growth isocline with the predator zero-growth isocline. In Lotka–Volterra models, setting determines the predator threshold required to stabilize prey, whereas setting determines the prey density required to support predator balance.
REASONING PATH
Your ACEpath teacher’s suggested approach- Identify which population is at equilibrium
To find the resource density required to sustain a consumer at dynamic equilibrium, set the consumer's rate equation to zero: .
Always write down when solving for conditions that balance predator births and deaths.
- Match variables to parameters
In , non-trivial equilibrium requires , so .
Check that the solved variable is prey () and that its formula depends on predator efficiency (), attack rate (), and predator mortality ().
CORRECTED PATH
ACEpath Teacher's DemonstrationSet the fox population derivative to zero: .
Factor out for the non-trivial equilibrium (): .
Solve for the equilibrium hare density: .
Substitute , , and : .
03 The student omits the conversion efficiency b from the predator equation, writing dP/dt = aHP - m'P and calculating H^ = m' / a = 175 hares.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You omitted the conversion efficiency factor from the predator growth rate. Predation events () produce new predators at an efficiency of , so the birth term must be .
- Step 2Correct
Because was missing from your initial differential equation, your algebraic expression for the predator zero-growth isocline is missing in the denominator.
- Step 3Correct
Carrying the omitted factor into the arithmetic yielded instead of the true required equilibrium density of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that sustaining the predator population at dynamic equilibrium requires setting .
You correctly accounted for the mange outbreak by using the doubled predator mortality rate .
You factored out properly to solve for the non-trivial equilibrium prey density.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou omitted the dimensionless conversion efficiency parameter in the predator growth term.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated predator birth as occurring at a ratio per prey kill () rather than accounting for ecological trophic transfer efficiency (), where only a fraction of consumed prey biomass is converted into predator reproduction.
REASONING PATH
Your ACEpath teacher’s suggested approach- Predator Rate Equation
In standard Lotka–Volterra models, predator births equal conversion efficiency times total prey kills: .
Always verify that both the attack rate and conversion efficiency multiply the interaction term in .
- Predator Zero-Growth Isocline
For non-zero predator populations, setting yields the prey threshold .
Check the units: has units of (since is dimensionless), ensuring the formula is dimensionally and ecologically complete.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet the full predator equation to zero for dynamic equilibrium: .
Factor out assuming a sustained predator population (): .
Isolate the equilibrium hare density: .
Substitute the parameters: .
Lock it in
In a Lotka-Volterra predator equation , what is the biological formula for the predator zero-growth isocline ?
. Predator numbers stay constant when prey density generates births exactly equal to predator mortality .
Similar question
In a coupled predator-prey system, predator dynamics follow with , , and baseline mortality . Severe winter starvation increases the mortality rate by . Find the new equilibrium prey density .
Answer
. The elevated mortality rate is . Then .
A lynx population preys on hares with attack rate and conversion efficiency . Due to an anti-poaching intervention, the lynx mortality rate drops from to . Calculate the change in equilibrium hare density .
Answer
. Initial: . New: . Thus, .
A predator-prey system has prey dynamics and predator dynamics with , , , and initial . An epidemic doubles predator mortality to . Simultaneously, habitat fragmentation reduces hunting efficiency by . Determine the new equilibrium prey density .
Answer
. Updated parameters: and . The equilibrium prey density is .