Resources
In an isolated rat cardiomyocyte at , bioenergetic metabolites are quantified using HPLC and converted from tissue mass: , , and . The standard biochemical free energy change for hydrolysis at and is . (a) Convert all metabolite concentrations into consistent molar units (). (b) Calculate the cellular phosphorylation potential (actual in vivo of hydrolysis) in . Use .
Answer and steps
Final answer
(a) , , ; (b)
Steps
Part (a): Convert Metabolite Concentrations to Molar Units ()
Recall that . Convert each concentration to :
- For : Since ,
- For : Since ,
- For : Since ,
Part (b): Calculate the Cellular Phosphorylation Potential ()
The reaction for ATP hydrolysis under standard physiological conditions is:
In dilute aqueous biological solutions, water is in great excess, so its activity is taken as . The mass-action ratio (reaction quotient, ) is:
Substitute the concentrations obtained in Part (a):
The actual free energy of ATP hydrolysis in the cell () is related to standard conditions by the thermodynamic relationship:
Calculate the thermal energy factor :
Calculate the logarithmic correction term:
Now, add this term to :
Key Takeaway & Common Pitfall: Cellular metabolism maintains far higher than and relative to their chemical equilibrium state. As a result, , which makes the term significantly negative. Consequently, the actual free energy released in vivo () is substantially more exergonic than the standard free energy (). A common mistake is to ignore the units of or forget that water concentration is omitted from .
Typical errors
01 The student inverts the mass action ratio Q by placing reactants over products instead of products over reactants.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
For ATP hydrolysis, , the products are and while the reactant is . The reaction quotient must be . You inverted this ratio.
- Step 3Correct
You applied the thermodynamic relationship correctly, but your calculation inherited the inverted value of from the previous step.
WHAT YOU DID WELL
Compliments from Your TeacherYou converted all metabolite concentrations into consistent molar units accurately.
You correctly used the formula and matched the units of with .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set up as instead of the standard convention .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the reaction direction or forgetting that the mass-action quotient always places the products in the numerator and the reactants in the denominator.
REASONING PATH
Your ACEpath teacher’s suggested approach- Mass-Action Ratio Definition
For any chemical reaction , the reaction quotient is .
Always write out the chemical equation first (e.g., ) to visually confirm which species belong in the numerator.
- Physiological Sanity Check for ATP
Living cells maintain far above equilibrium levels, ensuring and making significantly more negative than .
Check whether your calculated is more negative than (typically around in healthy cells).
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the reaction quotient with products over reactants: .
Substitute the molar values: .
Evaluate the logarithmic correction: .
Sum with standard free energy: .
02 The student misinterprets the prefix micro (μ) as 10⁻³ instead of 10⁻⁶ when converting [ATP], leading to an incorrect concentration and free energy calculation.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
, ,
Correct, ,
You converted and correctly. However, the prefix micro () represents , not . Therefore, rather than .
- Step 2Correct
You used the correct expression for the reaction quotient and computed the arithmetic accurately, but the result was shifted by three orders of magnitude due to substituting instead of .
- Step 3Correct
You applied the thermodynamic relationship and handled the gas constant units flawlessly. Because of the earlier error in , your calculated was overly negative.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the equilibrium reaction quotient formula omitting water activity.
You used the correct value and units for in matching .
You accurately converted millimolar and millimole units to molarity.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou multiplied by instead of when converting micromoles () to moles.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the SI prefixes micro () and milli () during concentration standardization.
REASONING PATH
Your ACEpath teacher’s suggested approach- SI Prefix Standard
and .
Before calculating, double-check that every prefix with is replaced with and every prefix with is replaced with .
- Biological Plausibility Check
Cytoplasmic in living cells typically ranges from ().
Flag any cellular metabolite concentration calculated to be in the whole molar range (such as ), as such concentrations are physically impossible in cells.
CORRECTED PATH
ACEpath Teacher's Demonstration(a) , , ; (b)
03 The student uses common logarithm (log10) instead of the natural logarithm (ln) in the free energy expression.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
, ,
- Step 2
- Step 3Correct
The fundamental thermodynamic relationship uses the natural logarithm (), not the base-10 logarithm (). Using underestimates the logarithmic correction term by a factor of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted all three metabolite concentrations into molar units ().
You set up the reaction quotient properly with products in the numerator and ATP in the denominator.
You calculated the product accurately using consistent units.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou used rather than when calculating the concentration-dependent term .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing base-10 logarithm ( or ) with the natural logarithm (, base ) in thermodynamic equations derived from statistical mechanics and chemical potential, where . If base-10 log is used, it must include the conversion factor: .
REASONING PATH
Your ACEpath teacher’s suggested approach- Logarithmic Base in Thermodynamics
Chemical potential relationships are derived using base : .
Always verify whether the formula calls for the natural logarithm () or base-10 logarithm before entering values into your calculator.
- Converting Between Bases
.
If you prefer using base-10 logarithms, remember to multiply by the factor .
CORRECTED PATH
ACEpath Teacher's DemonstrationEvaluate the natural logarithm of the reaction quotient: .
Multiply by the thermal energy factor : .
Add the standard free energy change: .
(a) , , ; (b)
Lock it in
For the forward reaction , what is the correct formula for the reaction quotient ?
. Remember: is always , and pure water is omitted.
Similar question
A resting muscle cell maintains , , and at . Given and , calculate for ATP hydrolysis.
Answer
. . .
In an ischemic tissue experiencing hypoxia, ATP drops and ADP rises such that , , and at . Using and , determine the new cellular .
Answer
. . .
Phosphocreatine (PCr) regenerates ATP via the reaction with at . If , , , and , calculate for this reaction. ().
Answer
. . .