Resources
A food science technician digests a sample of the disaccharide maltose () into two glucose monomers () via enzymatic hydrolysis. The technician dissolves of maltose in pure water to an initial total mass of . Assuming the hydrolysis goes to completion and no water evaporates, calculate: (a) the moles of consumed, (b) the mass of water consumed in grams (using molar mass ), and (c) the final mass percentage of glucose in the resulting solution.
Answer and steps
Final answer
(a) ; (b) ; (c)
Steps
Write the balanced equation for the hydrolysis reaction
Hydrolysis is the chemical breakdown of a compound due to reaction with water. The enzymatic cleavage of the disaccharide maltose into two glucose monosaccharides requires one molecule of water to break the glycosidic bond:
From the stoichiometry, of maltose reacts with of .
Therefore, for of maltose:
Calculate the mass of water consumed
Using the given molar mass of water ():
Rounding to two significant figures gives:
Determine the mass of glucose formed
According to the balanced equation, of maltose produces of glucose:
The molar mass of glucose () is:
Calculate the mass of glucose produced:
Calculate the final mass percentage of glucose
By the law of conservation of mass, because no water evaporates and no material leaves the system, the total mass of the solution remains unchanged at .
Now, compute the mass percentage:
Rounding to two significant figures yields:
Typical errors
01 The student forgets that each maltose molecule yields two glucose molecules, assuming a 1:1 mole ratio between maltose and glucose.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
Even though you correctly balanced the equation as , you treated the molar amount of glucose as equal to maltose () instead of applying the mole ratio to obtain of glucose.
- Step 4Correct
Your percentage calculation setup and denominator were completely correct, but the final percentage was cut in half due to the earlier molar ratio error in Step 3.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly balanced the chemical equation for the enzymatic hydrolysis of maltose.
You correctly determined that of water is consumed and calculated its mass as .
You recognized that the total solution mass remains and used the correct mass percentage formula.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou balanced the reaction showing molecules produced per maltose, but when calculating moles of glucose you carried over directly without multiplying by .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking product stoichiometric coefficients when transitioning from balanced reaction formulas to quantitative mole-to-mole conversions.
REASONING PATH
Your ACEpath teacher’s suggested approach- Mole Ratio Check
Always write the mole ratio explicitly: .
CORRECTED PATH
ACEpath Teacher's DemonstrationApply the stoichiometric ratio from to find .
Calculate the mass of glucose formed: .
Compute the final mass percentage: .
(a) ; (b) ; (c)
02 The student incorrectly subtracts the consumed water from the initial total mass of the solution when calculating the final mass percentage, failing to recognize that mass is conserved in a closed liquid system.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3
- Step 4Correct
You subtracted the mass of reacted water from the total mass. Because the water was already part of the solution and its atoms were incorporated into the glucose molecules without leaving the beaker, total mass is conserved.
- Step 5Correct
Your percentage formula and computation were performed correctly, but the result was affected by the incorrect denominator carried over from Step 4.
WHAT YOU DID WELL
Compliments from Your TeacherYou wrote the correct balanced equation for the enzymatic hydrolysis of maltose.
You accurately converted moles of consumed water to grams using its molar mass.
You correctly used stoichiometric ratios to determine the mass of glucose formed.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou treated the water consumed in the reaction as though it evaporated or left the system, rather than recognizing that its mass was incorporated into the solute.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused chemical consumption of a solvent reactant with physical loss from the system. In hydrolysis within an aqueous solution, the water molecules break glycosidic bonds and become part of the product molecules; since no matter enters or leaves, the total mass of the solution remains strictly constant.
REASONING PATH
Your ACEpath teacher’s suggested approach- Conservation of Mass in Closed Systems
Unless a gas escapes, a precipitate is filtered out, or solvent evaporates, .
Check whether any matter has actually crossed the boundary of the container before altering the denominator.
- Reactant Solvents Stay in Solution
When liquid reacts to form product molecules, its mass transforms from solvent mass into solute mass: .
Do not subtract consumed solvent from the total system mass when finding .
CORRECTED PATH
ACEpath Teacher's DemonstrationBy the law of conservation of mass, no matter leaves the system: .
Calculate the mass percentage of glucose: .
Round to two significant figures to match the given data: .
(a) ; (b) ; (c)
03 The student assumes two moles of water are consumed per mole of maltose to form two glucose molecules, doubling the required water.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
A maltose molecule contains a single glycosidic bond connecting two glucose units. Hydrolyzing one mole of maltose requires only one mole of according to the balanced equation , rather than two moles of .
- Step 2Correct
Your multiplication and molar mass calculation were carried out correctly, but the result is doubled due to the incorrect mole value carried over from part (a).
- Step 3
- Step 4
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recognized that each mole of maltose yields two moles of glucose monomers.
You accurately calculated the mass of glucose from its molar mass.
You correctly applied conservation of mass to maintain the total solution mass at when calculating the final mass percentage.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou matched the stoichiometric coefficient of water to the number of monomer products (2 glucose molecules) instead of the number of glycosidic bonds cleaved (1 bond per maltose molecule).
REASONING PATH
Your ACEpath teacher’s suggested approach- Water stoichiometry in polymer cleavage
Hydrolysis consumes one molecule per covalent bond cleaved, which equals water molecules for an unbranched chain of monomer units.
For a disaccharide (), count the single glycosidic bond being broken, requiring exactly per mole of disaccharide.
CORRECTED PATH
ACEpath Teacher's Demonstration(a) ; (b) ; (c)
Lock it in
How many moles of hexose monosaccharide are produced when of a disaccharide undergoes complete hydrolysis?
. Disaccharides consist of two linked monomer units; cleaving the glycosidic bond with releases both monomers.
Similar question
A solution contains of lactose. If the lactose undergoes complete enzymatic hydrolysis into glucose and galactose, calculate: (a) the moles of water consumed, and (b) the total moles of monosaccharides produced.
Answer
(a) , because hydrolysis of disaccharide consumes . (b) total monosaccharides (), since each disaccharide yields monosaccharides.
A chemist dissolves of cellobiose (a glucose-glucose disaccharide, ) in water to make a solution. After complete hydrolysis into glucose monomers, calculate the final mass percentage of glucose in the solution (molar mass of glucose ).
Answer
Mass percentage . Moles of glucose . Mass of glucose . Mass percentage .
A sample contains of the trisaccharide maltotriose (composed of three glucose units linked by two glycosidic bonds, formula ). It is completely hydrolyzed in a solution with an initial total mass of . Calculate: (a) the moles of consumed, and (b) the mass percentage of glucose produced ().
Answer
(a) , since breaking glycosidic bonds per trisaccharide requires per mole of maltotriose. (b) . Moles of glucose . Mass of glucose . Mass percentage .