Resources
An agricultural ditch drains organophosphate insecticide runoff into a slow-moving freshwater canal. Laboratory water analysis reports that the canal water contains of the active ingredient chlorpyrifos (molar mass ). A non-target aquatic crustacean population experiences an acute (concentration lethal to of the population) at an environmental concentration of . Convert the analytical runoff concentration from to both (parts per million equivalent) and molarity (), and determine whether the ambient canal concentration exceeds the crustacean threshold.
Answer and steps
Final answer
Steps
Convert concentration from to
Recall the metric relationships for volume and mass:
Set up the dimensional analysis to convert micrograms per deciliter to milligrams per liter:
Convert concentration from to molarity ()
To find molarity, convert milligrams to grams, then divide by the molar mass of chlorpyrifos ():
- Convert mass to grams per liter:
-
Calculate molar concentration ():
Compare with the toxicity threshold ()
- Ambient canal concentration:
- Crustacean :
Comparing the two values reveals that the ambient concentration in the canal does not exceed the threshold; rather, it exactly equals the threshold ().
(Common pitfall: A concentration equal to an represents a severe ecological hazard where of the exposed population is expected to die over 96 hours, even though it does not strictly "exceed" the numerical cutoff.)
Typical errors
01 The student misinterprets 1 dL as 10 L instead of 0.1 L, leading to a calculated concentration that is two orders of magnitude too low.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You defined as instead of (or ). Because a deciliter is one-tenth of a liter, converting to liters requires multiplying the concentration by , giving .
- Step 2Correct
You correctly set up the conversion from mass concentration to molarity by dividing grams per liter by molar mass, but the resulting value inherited the hundredfold error from Step 1.
- Step 3Correct
Your comparison logically followed your calculated value, but the true ambient concentration of exactly matches the threshold.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted micrograms to milligrams using the factor .
You used the correct relationship between mass concentration and molar mass to calculate molarity.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou equated to instead of dividing liters into tenths ().
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing fractional submultiples with multiples (mixing up deci- with deka-), which inverts the conversion factor when transforming denominator volume units.
REASONING PATH
Your ACEpath teacher’s suggested approach- Denominator Unit Conversion
When converting a unit in the denominator, replacing a smaller volume (like ) with a larger volume (like ) increases the numeric concentration value.
Set up dimensional analysis with explicit cancelling fractions: .
- Deci- vs. Deka- Prefix Sense Check
The prefix 'deci-' () means (tenth), while 'deka-' () means (ten).
Confirm whether the unit represents a fraction of the base unit before writing equality statements.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert the volume in the denominator using (or ): .
Convert milligrams per liter to grams per liter: .
Divide by the molar mass of chlorpyrifos (): .
Compare the ambient concentration with the crustacean threshold: .
02 The student multiplies by the molar mass instead of dividing when converting mass concentration to molarity, yielding an incorrect molarity that erroneously exceeds the threshold.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
To convert mass concentration to molarity , you must divide by the molar mass , not multiply. Multiplying gives units of instead of .
- Step 3Correct
Because of the multiplication error in the previous step, your calculated molarity was far too high, leading to an incorrect conclusion about exceeding the threshold.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly related deciliters to liters and micrograms to milligrams.
You calculated the correct mass concentration of .
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou set up the operation with molar mass as multiplication rather than division.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisConfusing the relationship between moles, mass, and molar mass when converting concentrations.
REASONING PATH
Your ACEpath teacher’s suggested approach- Unit Cancellation Check
Always write out unit dimensions and cancel them before multiplying numerical values.
- Threshold Comparison
Evaluate whether values are strictly greater than or identical to an benchmark.
State explicitly if the ambient concentration matches the benchmark exactly rather than exceeding it.
CORRECTED PATH
ACEpath Teacher's Demonstration03 The student rounds 3.565 × 10⁻⁷ mol/L up to 3.57 × 10⁻⁷ mol/L and incorrectly concludes that reaching the threshold counts as exceeding it.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
You noted that the concentration reaches the , but mathematically, to 'exceed' means to be strictly greater than (), not equal to ().
WHAT YOU DID WELL
Compliments from Your TeacherYou performed the multi-step metric conversion from to with complete accuracy.
You correctly used the molar mass of chlorpyrifos to convert mass concentration into molarity.
You matched the calculated concentration with the given value.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou equated reaching an ecological threshold with exceeding it.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisIn ecological and chemical toxicity contexts, 'exceeding' a threshold requires a value strictly greater than the cutoff (). Reaching the exact value () constitutes meeting or equaling the threshold, not exceeding it.
REASONING PATH
Your ACEpath teacher’s suggested approach- Strict Inequality vs. Equality
In quantitative comparisons, 'exceeds' corresponds to the strict inequality , while 'meets' or 'equals' corresponds to .
Check whether the question asks if a value 'meets' or 'exceeds' a standard. State explicitly that equality means the threshold is met, but not exceeded.
CORRECTED PATH
ACEpath Teacher's DemonstrationCompare ambient molarity directly to the value of .
Observe that .
Conclude that while this level presents severe acute toxicity ( mortality), it exactly equals the threshold and therefore does not exceed it.
(It does not exceed the threshold; it exactly equals it).
Lock it in
What exact fraction of a liter does one deciliter () represent, and how many deciliters make up one liter?
; there are in . (Memory cue: 'deci-' means tenth, like a decimal or dime).
Similar question
An environmental health sample contains of lead ions. Convert this concentration into .
Answer
. Set up dimensional analysis: .
A wetland water sample contains of atrazine (molar mass ). Calculate its molarity in .
Answer
. First, convert to : . Next, divide by molar mass: .
Runoff delivers of an insecticide (molar mass ) into an estuary. The for a resident copepod is . Determine whether this runoff exceeds the copepod .
Answer
No, it does not exceed the threshold (it is lower). Convert concentration: . Divide by molar mass: . Since , the concentration does not exceed the .