Resources
Human microRNA-21 () post-transcriptionally regulates the tumor suppressor gene . The mature is in length and contains a seed region extending from nucleotide to nucleotide . Suppose a cytoplasmic transcript pool of is present at an initial concentration of . Upon incorporation of into the RNA-induced silencing complex (), the target undergoes accelerated deadenylation and endonucleolytic decay, reducing its cytoplasmic half-life () from to . Assuming first-order decay kinetics where , calculate: (a) the first-order rate constant of decay () in , and (b) the remaining concentration of after under induction.
Answer and steps
Final answer
(a) ; (b) Remaining .
Steps
Part (a): Determining the Induced Rate Constant of Decay ()
MicroRNAs regulate gene expression post-transcriptionally by guiding the RNA-induced silencing complex () to complementary target sequences in , promoting transcript destabilization and accelerated degradation.
The degradation of the cytoplasmic transcript follows first-order kinetics, where the rate constant is inversely proportional to the half-life ():
Under regulation, the induced half-life decreases to . Substituting this value into the equation yields:
Part (b): Calculating the Remaining Concentration of
The concentration of at time for a first-order decay process is given by the integrated rate law:
Alternatively, this can be expressed in terms of elapsed half-lives :
Using the half-life decay formula:
Substitute the initial concentration and :
Common Pitfall to Avoid: Be sure to use the induced half-life () rather than the basal half-life () when computing decay parameters under microRNA silencing.
Typical errors
01 The student uses the uninduced baseline half-life of 6.00 hours instead of the miR-21-induced half-life of 1.50 hours to calculate the decay rate constant and downstream concentration.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You correctly set up the relation , but you used the uninduced baseline half-life of instead of the accelerated, induced half-life of resulting from targeting.
- Step 2Correct
You correctly set up the ratio for elapsed half-lives, but this value was affected by carrying over the uninduced half-life of instead of the induced half-life of .
- Step 3
[] = (2.40 10^{-9}) (0.5)^{0.75} = 1.43 10^{-9}
Correct[]_{4.50} = []_0 ^3 = 2.40 10^{-9} = 3.00 10^{-10}
Your half-life decay calculation followed correctly from your value of , but because was computed using the wrong half-life, the resulting transcript concentration is higher than the actual induced value.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that transcript degradation follows first-order kinetics with .
You accurately applied the fractional half-life decay formula to compute the remaining transcript level.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou chose the baseline (uninduced) transcript half-life rather than the accelerated (induced) half-life triggered by microRNA-mediated degradation. In regulatory gene expression scenarios, always select the kinetic parameters corresponding to the specific experimental condition requested.
REASONING PATH
Your ACEpath teacher’s suggested approach- Identify the active regulatory condition
When microRNA or RISC silencing is active, mRNA degradation is accelerated, lowering and increasing .
Match the condition in the prompt ('under miR-21 induction') directly to the induced parameter () before beginning calculations.
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify the induced half-life under regulation: .
Compute .
Determine the number of elapsed half-lives under induction: .
Calculate remaining .
(a) ; (b)
02 The student misinterprets first-order exponential decay as linear decay, subtracting equal amounts of mRNA per half-life.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
First-order decay is multiplicative, not linear. Each half-life halves the remaining concentration at that moment rather than subtracting a fixed of the initial pool.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly selected the induced half-life of rather than the basal half-life.
You correctly evaluated the first-order rate constant .
You correctly determined that corresponds to half-lives.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou calculated a constant loss of for each half-life and multiplied it by , concluding that the transcript pool was completely depleted.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated first-order decay as a linear process with a constant rate of absolute loss (), instead of an exponential process where the rate of decay is proportional to the remaining concentration (). Under exponential decay, each half-life reduces the current remaining amount by half: .
REASONING PATH
Your ACEpath teacher’s suggested approach- Exponential Half-Life Rule
For any first-order decay, remaining quantity after half-lives is , never .
Raise to the power of the number of elapsed half-lives and multiply by the starting concentration.
CORRECTED PATH
ACEpath Teacher's DemonstrationApply the first-order exponential decay formula: .
Substitute and : .
Evaluate .
Compute the remaining concentration: .
03 The student calculates the fraction remaining as (1/2) * n rather than (1/2)^n, multiplying by the number of half-lives instead of raising to the power.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2
- Step 3Correct
Half-life decay is exponential rather than linear. Each half-life halves the previous amount, so after half-lives the fraction remaining is , not .
- Step 4
[] = 0
Correct[] = 2.40 10^{-9} = 3.00 10^{-10}
Because your fraction remaining was calculated incorrectly as , your final concentration of is affected by that earlier error.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the relevant induced half-life of .
You accurately computed the first-order degradation constant .
You correctly calculated that full half-lives elapsed in .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou modeled half-life decay as subtracting of the original amount per half-life linearly () rather than multiplying by for each successive half-life ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Exponential Decay Rule
After half-lives, the remaining fraction of a substance is , which approaches zero asymptotically and can never be negative.
Raise to the power of the number of half-lives () instead of multiplying by .
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate the remaining fraction: .
Multiply the initial concentration by the remaining fraction: .
Lock it in
How does microRNA binding via RISC affect target mRNA half-life () and its decay rate constant ()?
MicroRNA targeting accelerates deadenylation and decay, which decreases and increases because .
Similar question
A cytoplasmic mRNA has an initial concentration of . In the presence of a specific regulatory microRNA, its half-life decreases from to . Calculate the first-order decay rate constant under microRNA regulation () and the remaining mRNA concentration after of regulation.
Answer
. The elapsed time represents half-lives. Remaining .
Under basal conditions, a proto-oncogene mRNA decays with a rate constant of . Upon delivery of an antisense siRNA targeting the transcript, its degradation rate increases by a factor of . Calculate the new half-life () of the transcript under siRNA treatment and the percentage of mRNA remaining after .
Answer
. The new half-life is . The elapsed time is half-lives, leaving , or of the original transcript pool.
In a cell culture assay, a cytokine mRNA pool starts at with a baseline half-life of . For the first , the cells are untreated. At , an inducible microRNA is activated, shifting the mRNA half-life to for the subsequent . Find the final mRNA concentration at .
Answer
During the uninduced phase ( to ), half-life elapses: . During the induced phase ( to , duration ), half-lives elapse: .