Resources
In a 96-well broth microdilution experiment conforming to standard diagnostic protocols for emerging resistant pathogens, serial two-fold dilutions of vancomycin were prepared to determine the Minimum Inhibitory Concentration (MIC) for an isolate of . The tested drug concentrations were , , , , , , and . After incubation at for , optical density readings at () were recorded: at , at , at , at , at , at , and at . The negative media-only control well exhibited a background absorbance of . (a) Define the experimental MIC based on the lowest concentration showing no visible growth (). (b) If clinical breakpoints state that Susceptible is , Intermediate is , and Resistant is , classify the resistance status of this strain.
Answer and steps
Final answer
(a) ; (b) Intermediate susceptibility to vancomycin.
Steps
Part (a): Determining the Minimum Inhibitory Concentration (MIC)
- Understand the definition of MIC: The Minimum Inhibitory Concentration (MIC) is defined as the lowest concentration of an antimicrobial agent that prevents the visible growth of a microorganism. In spectrophotometric measurements, no visible growth corresponds to an optical density reading comparable to the sterile background control, specified here as:
-
Evaluate growth across the tested concentrations: Comparing the recorded values at each concentration to the growth threshold:
- At : (Inhibited / No growth)
- At : (Inhibited / No growth)
- At : (Inhibited / No growth)
- At : (Bacterial growth detected)
- At , , and : (Turbid bacterial growth)
- Identify the lowest inhibitory concentration: The concentrations that inhibit growth are , , and . Among these, the lowest concentration is:
Common Pitfall: A common mistake is selecting the highest concentration that permits growth () rather than the lowest concentration that successfully suppresses growth ().
Part (b): Classifying the Resistance Status
-
Compare the experimental MIC to clinical standard breakpoints:
- Susceptible (S):
- Intermediate (I):
- Resistant (R):
- Classify the isolate: Since the measured , it falls directly into the range defining intermediate susceptibility:
Therefore, this isolate of Enterococcus faecalis exhibits intermediate susceptibility to vancomycin.
Typical errors
01 The student confuses the lowest concentration that inhibits growth with the highest concentration showing growth or the boundary where growth is first observed, selecting 4.00 μg/mL and concluding the strain is Susceptible.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
The Minimum Inhibitory Concentration (MIC) is defined as the lowest concentration that prevents visible bacterial growth (). At , growth was observed (). The lowest tested concentration that successfully inhibited growth is ().
- Step 2Correct
You correctly compared your chosen value to the breakpoint criteria, but because the true MIC is , it falls within the intermediate range ().
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified that significant bacterial turbidity occurs at because its optical density exceeds the background threshold.
You correctly applied the clinical breakpoint comparison logic to classify resistance based on your stated MIC value.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou selected the highest concentration that permitted visible bacterial growth (or where growth first appeared) rather than the lowest concentration that successfully suppressed visible growth.
REASONING PATH
Your ACEpath teacher’s suggested approach- Define MIC precisely
is the lowest antibiotic concentration where (no growth), not where growth begins.
Always identify all concentrations showing inhibition () and pick the minimum of that set: .
CORRECTED PATH
ACEpath Teacher's DemonstrationIdentify all wells with no visible growth (): (), (), and ().
Select the lowest concentration among these cleared wells: .
Compare to the clinical breakpoints: defines Intermediate susceptibility.
(a) ; (b) Intermediate susceptibility to vancomycin.
02 The student misinterprets 'lowest concentration showing no visible growth' as the lowest concentration tested among all those that inhibit growth, but selects 32.0 μg/mL by confusing dilution order with numeric magnitude.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
The Minimum Inhibitory Concentration is defined as the lowest (minimum) concentration that completely prevents visible growth. Among the inhibitory concentrations (, , and ), the lowest value is , not .
- Step 3Correct
Your comparison logic followed your stated value of , but because the true MIC is , it falls within the intermediate range ().
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the concentrations that showed no visible bacterial growth by using the background absorbance cutoff.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou selected the highest concentration that inhibited growth rather than the lowest inhibitory concentration, possibly confusing the starting well of the dilution series with the minimal effective dose.
REASONING PATH
Your ACEpath teacher’s suggested approach- Defining Minimum Inhibitory Concentration
The MIC is the lowest concentration of an antimicrobial agent that prevents visible bacterial growth.
Always list all concentrations showing no growth and select the smallest numerical value among them.
CORRECTED PATH
ACEpath Teacher's DemonstrationFrom the inhibitory set , select the minimum value: .
Compare to the breakpoint ranges: (Susceptible), (Intermediate), (Resistant).
(a) ; (b) Intermediate
03 The student correctly determines the MIC as 8.00 μg/mL but misreads the breakpoint inequality and classifies the boundary value 8.00 μg/mL as Susceptible rather than Intermediate.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
Clinical breakpoints are strict numerical boundaries rather than approximate ranges. Because exceeds and falls directly into the interval , the isolate must be classified as Intermediate.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly applied the optical density threshold to determine that is the Minimum Inhibitory Concentration.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou treated the clinical cutoff value as flexible or approximate instead of evaluating the exact breakpoint inequality.
WHY IT HAPPENED
ACEpath Teacher's DiagnosisClinical susceptibility breakpoints represent strict, mutually exclusive diagnostic thresholds. An MIC equal to is double the upper limit for Susceptible () and matches the exact lower boundary of the Intermediate category ().
REASONING PATH
Your ACEpath teacher’s suggested approach- Strict Breakpoint Inequalities
Clinical breakpoints define exact mathematical intervals without rounding or proximity allowance.
Locate the exact interval that contains your calculated MIC value and confirm that boundary points satisfy the inclusive inequality.
CORRECTED PATH
ACEpath Teacher's DemonstrationCompare the measured directly to the breakpoint ranges: Susceptible (), Intermediate (), and Resistant ().
Since falls within the inclusive interval , the isolate exhibits intermediate susceptibility.
Intermediate
Lock it in
What does Minimum Inhibitory Concentration (MIC) represent in broth microdilution testing?
The lowest antimicrobial concentration that completely prevents visible microbial growth (clear well).
Similar question
In a broth microdilution assay with ciprofloxacin, serial dilutions gave the following results: (clear), (clear), (clear), (turbid), and (turbid). Determine the MIC of ciprofloxacin for this isolate.
Answer
. The wells showing complete inhibition of growth are and . The minimum concentration among these clear wells is .
A clinical isolate of tested against oxacillin yielded the following values (growth threshold ): at , at , at , and at . (a) State the MIC. (b) If breakpoints are Susceptible and Resistant , classify the isolate.
Answer
(a) , since is the lowest concentration with . (b) Susceptible, because .
A laboratory tests ampicillin against across dilutions from to . Growth is completely inhibited at . Clinical breakpoints define Susceptible as , Intermediate as , and Resistant as . A student reports the strain is Susceptible because growth was first observed at . Explain the error and provide the correct classification.
Answer
The student mistakenly defined the MIC using the growth concentration () instead of the lowest inhibitory concentration. The true MIC is (the lowest concentration preventing growth). According to the clinical breakpoints, an MIC of corresponds to Intermediate resistance, not Susceptible.