Resources
A clinical study measures the coordination between the muscular, skeletal, and urinary systems in clearing metabolic waste. A patient's plasma creatinine concentration is measured as . Over a collection period, the patient excretes a total urine volume of with a urinary creatinine concentration of . (a) Convert the plasma creatinine concentration to and the urine excretion rate to . (b) Calculate the patient's creatinine clearance rate (an estimate of glomerular filtration rate, GFR) in , showing all unit balance steps.
Answer and steps
Final answer
(a) Plasma concentration = , Urine excretion rate = ; (b) Creatinine clearance =
Steps
Part (a): Unit Conversions
-
Plasma Creatinine Concentration ():
- By definition, .
- Convert to :
-
Urine Excretion Rate ():
- The total collection time is . Convert this duration to minutes:
- Divide the total urine volume excreted () by the collection time:
Part (b): Creatinine Clearance Rate ()
Creatinine is a waste product generated by the breakdown of creatine phosphate in skeletal muscle. It is transported through the bloodstream to the kidneys, where it is freely filtered by the glomeruli and minimally reabsorbed or secreted. Therefore, the rate at which plasma is cleared of creatinine provides an estimate of the glomerular filtration rate (GFR).
-
Renal Clearance Formula: The clearance equation balances the rate of urinary creatinine excretion against the plasma concentration: where:
- is the urinary creatinine concentration,
- is the urine flow rate,
- is the plasma creatinine concentration.
-
Calculation and Unit Balance: Using the values with matching concentration units:
- (or )
- (or )
Substituting into the formula:
Canceling the concentration units ():
Common Pitfall: When using the clearance formula, ensure that and are expressed in the exact same concentration units (e.g., both in or both in ) so their units cancel completely, leaving the clearance rate in units of flow ().
Typical errors
01 The student multiplies by 100 instead of dividing when converting deciliters to milliliters, resulting in an inflated plasma concentration and severely underestimated clearance rate.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
Because , converting from deciliters to milliliters in the denominator requires dividing by , not multiplying. A milliliter is a smaller volume than a deciliter, so the amount of solute in one milliliter must be smaller.
- Step 2
- Step 3Correct
Your clearance formula is correct, but substituting your erroneous value of caused the concentration units ( in the numerator and in the denominator) to fail to cancel, underestimating the clearance rate by a factor of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted to .
You accurately calculated the urine flow rate .
You correctly recalled the renal clearance formula .
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou inverted the relationship between deciliters and milliliters (), treating as , which multiplied the concentration by instead of dividing by and led to mismatched units in the clearance equation.
REASONING PATH
Your ACEpath teacher’s suggested approach- Dimensional Analysis with Denominators
When a unit to be converted is in the denominator, place that unit in the numerator of the conversion factor so it cancels: .
Always write out the unit fraction explicitly and verify that the unwanted unit cancels out before multiplying numbers.
- Unit Consistency in Clearance Ratios
In , and must share the exact same concentration units (both or both ) so they cancel out completely.
Keep both concentrations in their original form when computing , or convert both to before dividing.
CORRECTED PATH
ACEpath Teacher's DemonstrationKeep and in matching units: and .
Substitute into the clearance equation: .
Cancel the concentration units () and evaluate: .
(a) Plasma concentration = , Urine excretion rate = ; (b) Creatinine clearance =
02 The student divides the urine volume by 24 hours without converting hours to minutes, giving the flow rate in mL/h rather than mL/min.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You calculated , but wrote the unit as without converting hours to minutes.
- Step 3Correct
Your clearance equation setup and algebra are structurally sound, but the final answer is inflated by a factor of due to using instead of .
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly converted plasma creatinine concentration from to .
You recalled and set up the correct renal clearance equation .
You correctly balanced and canceled matching concentration units between urine and plasma.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou divided total urine volume by hours instead of minutes, but attached the label directly to the result in .
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking the dimensional consistency of the time unit in the flow rate calculation () before substituting it into the clearance formula.
REASONING PATH
Your ACEpath teacher’s suggested approach- Time Unit Alignment
Urine flow rate in clinical clearance formulas must be expressed per minute ().
Multiply the collection hours by (e.g., ) before dividing the volume.
- Plausibility Check for GFR
A normal human glomerular filtration rate (GFR) is approximately .
If your calculated clearance is several thousand , check whether an hourly rate was mistakenly substituted instead of a minute rate.
CORRECTED PATH
ACEpath Teacher's DemonstrationConvert to minutes: .
Calculate : .
Substitute into the clearance formula: .
(a) , ; (b)
03 The student inverts the clearance formula by placing plasma concentration in the numerator and urine concentration in the denominator.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You inverted the variables in the clearance formula. Renal clearance is defined by the excretion rate divided by plasma concentration, , because the rate of solute excreted in the urine () must equal the rate at which plasma volume is cleared of that solute ().
- Step 3Correct
You computed your expression accurately, but the resulting numerical value is incorrect due to the inverted formula in the previous step.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly used the conversion factor of per deciliter to find plasma concentration in .
You converted the 24-hour period into minutes and calculated the correct urine flow rate .
You carefully tracked your units throughout the calculation.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou reversed the relationship between the excretion compartment (urine) and the source compartment (plasma), writing instead of .
REASONING PATH
Your ACEpath teacher’s suggested approach- Mass Conservation in Excretion
Excretion rate of solute equals clearance rate times plasma concentration: .
Always isolate clearance by dividing the urinary excretion rate by the plasma concentration: .
- Physiological Reality Check
A normal adult glomerular filtration rate (GFR) is around , and urine is typically much more concentrated than plasma for waste solutes ().
If your calculated clearance rate is a tiny fraction of a milliliter per minute (), check whether you placed the much larger urine concentration in the denominator by mistake.
CORRECTED PATH
ACEpath Teacher's DemonstrationSet up the renal clearance equation with urinary excretion rate in the numerator: .
Substitute the given values: .
Multiply the numerator terms: .
Divide by the plasma concentration: .
(a) Plasma concentration = , Urine excretion rate = ; (b) Creatinine clearance =
Lock it in
How many milliliters () are in one deciliter (), and what conversion factor converts to ?
. Multiply by (or divide by ). Memory cue: smaller volume unit means a smaller amount of solute per unit.
Similar question
A patient has a plasma glucose concentration of . Express this concentration in and in .
Answer
and . Steps: ; since , the value in is also .
A subject excretes of urine over . If urinary creatinine is and plasma creatinine is , calculate (a) the urine flow rate in and (b) the creatinine clearance in .
Answer
(a) ; (b) . Steps: ; .
In an inulin clearance test, urine flow rate is and urine inulin concentration is . Plasma inulin is reported as . Calculate the glomerular filtration rate (GFR) in , showing explicit unit alignment.
Answer
. Steps: Convert plasma inulin to : . Then .