Resources
A mammalian cell possessing a baseline volume of and an internal non-permeating solute concentration of is suspended in an open bath containing urea and non-permeating solutes at (). The plasma membrane contains aquaporin channels permeable to water and facilitated urea transporters (UT-A). Urea enters the cell via facilitated diffusion at an initial rate of . If the cell membrane stretches and maintains constant internal volume by adjusting internal water content, calculate the magnitude of the initial solute potential change per second () inside the cell caused solely by this initial influx of urea (, ).
Answer and steps
Final answer
Steps
Relate Solute Potential to Solute Concentration
The solute (osmotic) potential of an aqueous solution is given by the van 't Hoff relation:
where:
- is the ionization constant ( for non-ionizing solutes like urea),
- is the molar concentration of solutes inside the cell ( or ),
- is the ideal gas constant (),
- is the absolute temperature ().
Taking the rate of change with respect to time , holding temperature and the ionization factor constant:
Determine the Rate of Change of Internal Concentration
The rate of solute influx is given as:
Because the internal cell volume remains constant at , the increase in internal urea concentration per unit time is:
Calculate the Rate of Change in Solute Potential
Substitute the rate of concentration increase into the differentiated solute potential equation:
Common Pitfall: A common mistake is omitting the negative sign in the solute potential formula. Increasing the concentration of solute inside a compartment always makes its solute potential more negative, decreasing the water potential .
Typical errors
01 The student misapplies the formula by using the influx rate of moles directly as concentration in the solute potential formula without dividing by the cell volume.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You substituted the rate of molar influx directly into the solute potential formula in place of concentration change . Because solute potential depends on molarity (moles per liter), you must divide the molar influx rate by the cell's volume ().
- Step 2Correct
Your final calculation followed arithmetically from the unscaled molar rate in Step 1, but it is off by a factor equal to the cell volume ().
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly recalled the parameters , , and from the van 't Hoff formula.
You accurately identified the rate of urea influx from the problem prompt.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou treated the solute influx rate (measured in ) as if it were a rate of change in molar concentration (measured in or ), neglecting to divide by the intracellular volume.
REASONING PATH
Your ACEpath teacher’s suggested approach- Verify concentration units in van 't Hoff equation
Solute potential is , where is molar concentration (), not amount of substance ().
Always convert an influx of moles per second to concentration change by dividing by volume: .
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate the rate of concentration increase inside the cell: .
Substitute into the differentiated solute potential equation: .
(or )
02 The student uses the temperature in degrees Celsius instead of converting to Kelvin when evaluating the gas constant expression.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1
- Step 2Correct
You applied the gas constant , whose units require absolute temperature in Kelvin (), but you substituted the temperature in Celsius () instead.
- Step 3Correct
Your arithmetic evaluation was carried out correctly from your substitution, but the final value is incorrect due to the Celsius temperature used in Step 2.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly calculated the rate of internal solute concentration increase using the cell volume.
You correctly identified the differentiated van 't Hoff relation for solute potential change over time.
THE ERROR
Where Your ACEpath Teacher Spotted the MistakeYou substituted temperature as instead of using absolute temperature in Kelvin ().
WHY IT HAPPENED
ACEpath Teacher's DiagnosisOverlooking that thermodynamic equations containing the ideal gas constant strictly require absolute temperature in Kelvin () to cancel units properly with in the denominator.
REASONING PATH
Your ACEpath teacher’s suggested approach- Check the Gas Constant Units
Whenever an equation contains ( or ), the temperature must be in Kelvin.
Inspect the unit of before calculating and verify that temperature is expressed as .
- Sign Convention for Solute Potential
Solute potential is always negative or zero: . An influx of solute makes more negative ().
Ensure that if direction of change is requested rather than absolute magnitude, include the negative sign: .
CORRECTED PATH
ACEpath Teacher's DemonstrationSubstitute the absolute temperature in Kelvin: .
Evaluate the rate of change: .
Multiply the factors: .
(or )
03 The student divides the initial rate of mole influx by the concentration gradient rather than cell volume to find the rate of concentration change.
Sample Student Work
Reviewed by ACEpath TeacherStep-by-Step Review
Walk Through It with Your Teacher- Step 1Correct
You divided the rate of mole influx by the concentration difference instead of dividing by the cell volume . Because concentration is moles per unit volume (), the rate of change of concentration at constant volume is .
- Step 2Correct
You correctly applied the differentiated van 't Hoff relation , but your final numerical answer was affected by the incorrect value of from Step 1.
WHAT YOU DID WELL
Compliments from Your TeacherYou correctly identified the temperature and constant values needed for the van 't Hoff relationship.
You set up the rate of solute potential change proportionally to the rate of concentration change.
THE ERROR
Where Your ACEpath Teacher Spotted the Mistakeno
WHY IT HAPPENED
ACEpath Teacher's DiagnosisYou confused the definition of concentration rate of change with a transport rate equation, dividing solute flux (mol/s) by a concentration difference (mol/L) rather than the compartment volume (L). Checking units reveals that , whereas concentration rate of change must have units of or .
REASONING PATH
Your ACEpath teacher’s suggested approach- Rate of Concentration Change Definition
For a compartment with constant volume , the change in molarity over time is .
Always divide the mole flux rate (in ) by the compartment volume (in ) to determine .
- Dimensional Analysis Check
Molar concentration change per second has units of .
Verify that before inserting the value into thermodynamic equations.
CORRECTED PATH
ACEpath Teacher's DemonstrationCalculate the rate of concentration increase inside the cell using the constant cell volume: .
Substitute this rate into the van 't Hoff equation for solute potential: .
Compute the final product: (or ).
(or )
Lock it in
In the van 't Hoff solute potential formula , what does the variable represent, and what are its standard units?
represents molar concentration (molarity), with units of (or ), not total moles.
Similar question
A spherical artificial liposome with an internal volume of is placed in a glycerol solution at (). Glycerol enters the liposome at a constant initial rate of . Assuming internal volume remains fixed and glycerol does not dissociate (), calculate the rate of change of solute potential inside the liposome in ().
Answer
. First, find . Then, evaluate .
A plant protoplast with a fixed volume of takes up potassium chloride (, which completely dissociates into ions) at a rate of at (). Calculate the magnitude of the rate of change of the intracellular solute potential in ().
Answer
. First, compute the change in salt concentration: . Then, apply the formula with : .
A red blood cell maintaining a constant volume of is suspended in an isotonic solution at (). An experimental drug triggers non-electrolytic solute influx () causing the internal solute potential to change at an initial rate of . Calculate the influx rate of the solute in ().
Answer
Influx rate . Rearrange to solve for concentration change: . Multiply by volume to get molar influx: .